No abstract

No abstract

High-strain-rate superplasticity describes the ability of a material to sustain large plastic deformation in tension at high strain rates of the order of 10-2 to 10-1 s-1 and is of great technological interest for the shape-forming of engineering materials. High-strain-rate superplasticity has been observed in aluminium-based and magnesium-based alloys. But for ceramic materials, superplastic deformation has been restricted to low strain rates of the order of 10-5 to 10-4 s-1 for most oxides and nitrides with the presence of intergranular cavities leading to premature failure. Here we show that a composite ceramic material consisting of tetragonal zirconium oxide, magnesium aluminate spinel and alpha-alumina phases exhibits superplasticity at strain rates up to 1 s-1. The composite also exhibits a large tensile elongation, exceeding 1,050 per cent for a strain rate of 0.4 s-1. The tensile flow behaviour and deformed microstructure of the material indicate that superplasticity is due to a combination of limited grain growth in the constitutive phases and the intervention of dislocation-induced plasticity in the zirconium oxide phase. We suggest that the present results hold promise for the application of shape-forming technologies to ceramic materials.

No abstract

No abstract

By controlling the heating rate at o101C/min during sparkplasma-sintering (SPS) processing, transparent polycrystalline spinel with an in-line transmission of 50% and 70% in the visible-and infrared-wavelengths, respectively, can be successfully fabricated for only a 20-min soak at 13001C. The high transmission can be attained by reducing the residual porosity and pore size, which was achieved by the low-heating rate. At high heating rates, many closed pores are formed due to the high densification rate during the heating process and remain as large pores around grain junctions. At temperatures 413001C, the coalescence of the residual pores and the precipitation of second phases, which are caused by rapid grain growth, degrade the transparency. The present study demonstrates that although the high heating rates have been regarded as a primary advantage for the SPS processing, the low heating rate is highly effective in attaining a high transparency in the spinel even at low temperatures and for short sintering times.

No abstract

No abstract