It would be convenient if we could achieve multi-component (organic and inorganic species) analysis using just one quartz fiber filter (QFF) as an aerosol collection medium. In general, QFF have been used for analyzing carbonaceous materials in aerosols. This study shows a nondestructive, rapid, and simple method using EDXRF (Energy Dispersive X-Ray Fluorescence spectrometry) that has secondary targets and three-dimensional polarization optics for analyzing inorganic multi-elements in aerosols collected on QFFs. Multi-element analysis can be achieved by using EDXRF coupled with fundamental parameter (FP) quantification, as speed of up to 900 s (15 min) per sample. The EDXRF-FP method shows good repeatability, with generally less than 5% variation when measuring each analyzed element. While the elemental concentrations in the blank QFFs in any lots examined in this study could be considered to be lower than the actual samples, the blank level of Ni cannot be ignored. The EDXRF-FP results for each element of the aerosols collected on QFF agreed well with ICP-MS and ICP-AES results. The temporal variations of the selected elements in aerosols obtained by EDXRF-FP showed very good agreement with those obtained by ICP-MS and AES, and thus this method is suitable for elucidating day-to-day variations of multi-elements in aerosols.

Numerous researchers have proposed that surface area is a more appropriate indicator than mass for evaluating pulmonary inflammatory responses caused by exposure to fine and ultrafine particles. In this study, measurements of surface area concentrations of aerosols were conducted in Yokohama, Japan, using the diffusion charging method. PM 2.5 mass concentration and black carbon concentration in PM 2.5 were also measured. The 24-hour continuous measurement campaigns were conducted 39 times from March to November, 2014. The surface area concentration was more closely correlated with the black carbon concentration than with the PM 2.5 mass concentration. It is considered that the abundance of black carbon particles significantly affects the surface area concentration of PM 2.5 . The strength of the correlation between the surface area and black carbon concentrations varied considerably among the measurement campaigns. A relatively weaker afternoon correlation was observed compared with the other time zones (morning, evening, and night). We consider that these phenomena are due to the transportation/formation of the particles other than black carbon that affects surface area concentration and/or the variation of the surface condition of the black carbon particles.

Abstract:The surface area of ambient aerosols can be considered as an index of toxicity because an increased surface area may be able to act as a catalyst for specific reactions between particles and cells, as well as a carrier for co-pollutants, such as gases and chemicals. The aerosol surface area concentration was measured together with black carbon (BC) and other chemical species such as organic compounds, sulfate, and nitrate in Fukuoka, Japan, and the effect of the chemical composition of aerosols on their surface area was investigated. Aerosol surface area concentration was highly correlated with BC concentration for the entire period. Day-of-week variation and diurnal variation also showed the strong correlation between aerosol surface area and BC. This implies that even though BC accounts for relatively small percentage (in this study, 3.5%) of PM 2.5 mass, it should receive considerable attention when aerosol surface area is considered as an index of adverse health effects caused by exposure of the human body to aerosols. Sulfate aerosol does not usually affect aerosol surface area in Fukuoka, but it may occasionally have a significant effect when the airmass contains an excess amount of relatively smaller particles of sulfate derived from volcanic SO 2 .

Observation of the ambient aerosol surface area concentrations is important to understand the aerosol toxicity because an increased surface area may be able to act as an enhanced reaction interface for certain reactions between aerosol particles and biological cells, as well as an extended surface for adsorbing and carrying co-pollutants that are originally in gas phase. In this study, the concentration of aerosol surface area was measured from April 2015 to March 2016 in Fukuoka, Japan. We investigated the monthly and diurnal variations in the correlations between the aerosol surface area and black carbon (BC) and sulfate concentrations. Throughout the year, aerosol surface area concentration was strongly correlated with the concentrations of BC, which has a relatively large surface area since BC particles are usually submicron agglomerates consisting of much smaller (tens of nanometers) sized primary soot particles. The slopes of the regression between the aerosol surface area and BC concentrations was highest in August and September 2015. We presented evidence that this was caused by an increase in the proportion of airmasses that originated on the main islands of Japan. This may enhance the introduction of the BC to Fukuoka from the main islands of Japan which we hypothesize to be relatively fresh or "uncoated", thereby maintaining its larger surface area.

Observation of the ambient aerosol surface area concentrations is important to understand the aerosol toxicity because an increased surface area may be able to act as an enhanced reaction interface for certain reactions between aerosol particles and biological cells, as well as an augmented carrier surface for co-pollutants. In this study, the concentration of aerosol surface area was measured from April 2015 to March 2016 in Fukuoka, Japan. We investigated the monthly and diurnal variations in the correlations between the aerosol surface area and black carbon (BC) and sulfate concentrations. Throughout the year, aerosol surface area concentration was strongly correlated with the concentrations of BC, which has relatively large surface area since BC particles are usually submicron agglomerates consisting of much smaller (tens of nanometers) sized primary soot particles. The slopes of the regression between the aerosol surface area and BC concentrations was highest in August and September 2015. This appears to have been the results of an increase in the proportion of the airmass that originated on the main islands of Japan. This may enhance the introduction of the BC from the main islands of Japan that is relatively fresh (or "uncoated"), thereby maintaining its larger surface area.

In absorption refrigeration systems, molybdate is used as a key inhibitor against corrosion of steel, although it is liable to precipitate because of its limited solubility in a concentrated LiBr solution. In this research, the use of sulfite is proposed as a precipitation inhibitor for molybdate and its effect on the passivation of iron is examined. The effect of the stronger passivator of nitrate on the actions of sulfite is also investigated. The results show that sulfite decreases the amount of corrosion of iron and promotes the formation of the oxide layer MoO 2 , Fe 3 O 4 on the surface of iron irrespective of presence of nitrate. Thus, sulfite is concluded as an effective additive in an absorption refrigerator for better control of molybdate concentration and corrosion of iron.