PTEN is a tumor suppressor gene mutated in many human cancers, and its expression is reduced or absent in almost half of hepatoma patients. We used the Cre-loxP system to generate a hepatocyte-specific null mutation

No abstract

Ultrasonic waves in cancellous bone change dramatically depending on its structural complexity. One good example is the separation of an ultrasonic longitudinal wave into fast and slow waves during propagation. In this study, we examined fast wave propagation in cancellous bone obtained from the head of the bovine femur, taking the bone structure into consideration. We investigated the wave propagation perpendicular to the bone axis and found the two-wave phenomenon. By rotating the cylindrical cancellous bone specimen, changes in the fast wave speed due to the rotation angle then were observed. In addition to the ultrasonic evaluation, the structural anisotropy of each specimen was measured by X-ray micro-computed tomography (CT). From the CT images, we obtained the mean intercept length (MIL), degree of anisotropy (DA), and angle of insonification relative to the trabecular orientation. The ultrasonic and CT results showed that the fast wave speed was dependent on the structural anisotropy, especially on the trabecular orientation and length. The fast wave speeds always were higher for propagation parallel to the trabecular orientation. In addition, there was a strong correlation between the DA and the ratio between maximum and minimum speeds (V(max)/V(min)) (R(2) = 0.63).

The ultrasonic wave propagation of fast and slow waves was investigated in vitro in 35 cubic cancellous bone specimens extracted from human femoral heads. Measurements were performed in three orthogonal directions using home-made PVDF transducers excited by a single sinusoidal wave at 1 MHz. The apparent density of the specimens was measured. Two separated fast and slow waves were clearly observed in 16 specimens, mainly in the main load direction. The waveforms and the sound speeds of fast and slow waves were similar to the reported data in bovine bone. The group of specimens in which the two waves were observed did not exhibit statistically higher apparent density than the rest of the specimens, but did exhibit statistically higher acoustic anisotropy ratio. The speeds in the main load direction were higher than those in the other direction. The fast and slow wave speeds were in good agreement with Biot's model, showing an increase with bone volume fraction (BV/TV). The ratio of peak amplitudes of the fast and slow waves nonlinearly increased as a function of BV/TV. These results open interesting perspective for acoustic assessment of cancellous bone micro-architecture and especially anisotropy that might lead to an improved assessment of bone strength.

Previous studies have shown that interference between fast waves and slow waves can lead to observed negative dispersion in cancellous bone. In this study, the effects of overlapping fast and slow waves on measurements of the apparent attenuation as a function of propagation distance are investigated along with methods of analysis used to determine the attenuation properties. Two methods are applied to simulated data that were generated based on experimentally acquired signals taken from a bovine specimen. The first method uses a time-domain approach that was dictated by constraints imposed by the partial overlap of fast and slow waves. The second method uses a frequency-domain log-spectral subtraction technique on the separated fast and slow waves. Applying the time-domain analysis to the broadband data yields apparent attenuation behavior that is larger in the early stages of propagation and decreases as the wave travels deeper. In contrast, performing frequency-domain analysis on the separated fast waves and slow waves results in attenuation coefficients that are independent of propagation distance. Results suggest that features arising from the analysis of overlapping two-mode data may represent an alternate explanation for the previously reported apparent dependence on propagation distance of the attenuation coefficient of cancellous bone.

No abstract

The influence of cancellous bone microstructure on the ultrasonic wave propagation of fast and slow waves was experimentally investigated. Four spherical cancellous bone specimens extracted from two bovine femora were prepared for the estimation of acoustical and structural anisotropies of cancellous bone. In vitro measurements were performed using a PVDF transducer (excited by a single sinusoidal wave at 1 MHz) by rotating the spherical specimens. In addition, the mean intercept length (MIL) and bone volume fraction (BV/TV) were estimated by X-ray micro-computed tomography. Separation of the fast and slow waves was clearly observed in two specimens. The fast wave speed was strongly dependent on the wave propagation direction, with the maximum speed along the main trabecular direction. The fast wave speed increased with the MIL. The slow wave speed, however, was almost constant. The fast wave speeds were statistically higher, and their amplitudes were statistically lower in the case of wave separation than in that of wave overlap.

No abstract