Extensive literature and publications on intermediate band solar cells (IBSCs) are reviewed. A detailed discussion is given on the thermodynamics of solar energy conversion in IBSCs, the device physics, and the carrier dynamics processes with a particular emphasis on the two-step inter-subband absorption/recombination processes that are of paramount importance in a successful implementation high-efficiency IBSC. The experimental solar cell performance is further discussed, which has been recently demonstrated by using highly mismatched alloys and high-density quantum dot arrays and superlattice. IBSCs having widely different structures, materials, and spectral responses are also covered, as is the optimization of device parameters to achieve maximum performance.

We have developed a technique to fabricate quantum dot (QD) solar cells with direct doping of Si into InAs QDs in GaNAs strain-compensating matrix in order to control the quasi-Fermi level of intermediate QD states. The Si atoms were evenly incorporated into QDs during the assembling stage of growth such that a uniform array of partially filled QDs has been obtained. Nonradiative recombination losses were also reduced by Si doping and a photocurrent increase due to two-step photon absorption was clearly measured at room temperature detected under filtered air-mass 1.5 solar spectrum.

Infertility caused by ovarian or tubal problems can be treated using In Vitro Fertilization and Embryo Transfer (IVF-ET); however, this is not possible for women with uterine loss and malformations that require uterine reconstruction for the treatment of their infertility. In this study, we are the first to report the usefulness of decellularized matrices as a scaffold for uterine reconstruction. Uterine tissues were extracted from Sprague Dawley (SD) rats and decellularized using either sodium dodecyl sulfate (SDS) or high hydrostatic pressure (HHP) at optimized conditions. Histological staining and quantitative analysis showed that both SDS and HHP methods effectively removed cells from the tissues with, specifically, a significant reduction of DNA contents for HHP constructs. HHP constructs highly retained the collagen content, the main component of extracellular matrices in uterine tissue, compared to SDS constructs and had similar content levels of collagen to the native tissue. The mechanical strength of the HHP constructs was similar to that of the native tissue, while that of the SDS constructs was significantly elevated. Transmission electron microscopy (TEM) revealed no apparent denaturation of collagen fibers in the HHP constructs compared to the SDS constructs. Transplantation of the decellularized tissues into rat uteri revealed the successful regeneration of the uterine tissues with a 3-layer structure 30 days after the transplantation. Moreover, a lot of epithelial gland tissue and Ki67 positive cells were detected. Immunohistochemical analyses showed that the regenerated tissues have a normal response to ovarian hormone for pregnancy. The subsequent pregnancy test after 30 days transplantation revealed successful pregnancy for both the SDS and HHP groups. These findings indicate that the decellularized matrix from the uterine tissue can be a potential scaffold for uterine regeneration.

Photovoltaic generation has stepped up within the last decade from outsider status to one of the important contributors of the ongoing energy transition, with about 1.7% of world electricity provided by solar cells. Progress in materials and production processes has played an important part in this development. Yet, there are many challenges before photovoltaics could provide clean, abundant, and cheap energy. Here, we review this research direction, with a focus on the results obtained within a Japan–French cooperation program, NextPV, working on promising solar cell technologies. The cooperation was focused on efficient photovoltaic devices, such as multijunction, ultrathin, intermediate band, and hot-carrier solar cells, and on printable solar cell materials such as colloidal quantum dots.

We report for the first time a successful fabrication and operation of an InAs/GaAs quantum dot based intermediate band solar cell concentrator photovoltaic (QD-IBSC-CPV) module to the IEC62108 standard with recorded power conversion efficiency of 15.3%. Combining the measured experimental results at Underwriters Laboratory (UL®) licensed testing laboratory with theoretical simulations, we confirmed that the operational characteristics of the QD-IBSC-CPV module are a consequence of the carrier dynamics via the intermediate-band at room temperature.

In order to design optimum structures for intermediate band solar cells, simulations based on self-consistent drift-diffusion model with a suitable treatment of the intermediate band in device domain are necessary. In this work, we have included the dependence of occupation rate of intermediate band at each position on optical generation rate via the intermediate band. Typical material parameters of GaAs were used except for the absorption coefficient of each corresponding band-to-band transition. Simulation results using our model indicate that the dependence of occupation rate on device position strongly affect short-circuit currents and also electrostatic potentials of the cell.

We present a numerical study on the fundamental operation principle of an intermediate band solar cell (IBSC) by using the self-consistent drift-diffusion method; the effects of doping in the IB region and incident light concentration on the operation characteristics are investigated. We find that under light illumination the electrostatic potential profile of IBSC strongly and intricately depends on both the electron density in IB and the carrier generation/recombination rates through IB. Introduction of doping in the IB region produces larger short-circuit current than that of IBSCs without doping under low light concentrations. Under high light concentrations, on the other hand, the doping dependence of the short-circuit current diminishes due to the photofilling effects. Although recombination processes through IB degrade the open-circuit voltage and fill factor compared to single junction solar cells under low light concentrations, they are greatly improved under high light concentrations by the photofilling effects. As a result, IBSCs could exceed in efficiency the single junction solar cells.

No abstract