No abstract

No abstract

Wide-bandgap semiconductors represent an attractive option to meet the increasing demands of micro- and nano-electromechanical systems (MEMS/NEMS) by offering new functionalities, high stability, biocompatibility and the potential for miniaturization and integration. Here, we report on resonant MEMS and NEMS devices with functional layers of SiC, AlN and AlGaN/GaN heterostructures on different substrates, which have been investigated and analysed in the course of an interdisciplinary research focus programme of the German Research Foundation (DFG). The specific deposition and etching technologies necessary for the three-dimensional micro-structuring are explained. Further, the implementation of appropriate electromechanical transduction schemes is discussed. In case of SiC and AlN resonators, actuation and sensing was achieved by a magnetomotive scheme. A piezoelectric coupling scheme where the counter electrode is formed by the two-dimensional electron gas at the interface of the III/V heterostructure was realized for the AlGaN/GaN resonators. Thus, flexural and longitudinal vibration modes were excited and characterized using electrical and optical techniques. The measured key parameters of resonant frequency and quality factor are related to geometry, material and environmental parameters using analytical and finite element (FE) models. Finally, potential sensor applications are experimentally investigated

Articles you may be interested inMicroresonators with Q-factors over a million from highly stressed epitaxial silicon carbide on silicon Appl. Phys. Lett. 104, 081901 (2014); 10.1063/1.4866268Stress-based resonant volatile gas microsensor operated near the critically buckled state

MEMS resonators bear great potential for applications as RF sensors, filters and oscillators, e.g., in life sciences or information technology. A semiconductor fabrication process has been applied to prepare resonant AlN and SiC beams operating at frequencies between 0.1 and 2.1 MHz. The metallized beams were actuated in a permanent magnetic field of about 0.5 T by the Lorentz force. For systematic studies of the resonant frequencies and quality factors, the induced voltage was measured using time domain and frequency domain techniques. Resonator geometry, material and ambient pressure were varied to attain a generalized understanding of the RF performance. The dependence of the resonant frequency on tensile axial strain has been derived analytically and extended to include highly strained beams. Based on these formulas, accurate detection of the residual layer strain after fabrication is presented. To describe the quality factor a chain of beads model has been applied successfully. The influences of the beam width and the pressure-dependent viscosity on the model parameters are analyzed.