Composting is generally accepted as the sustainable recycling of biowaste into a useful and beneficial product for soil. However, composting processes can produce gases that are considered air pollutants. In this dataset, we summarized the spatial and temporal distribution of process gases (including rarely reported carbon monoxide, CO) generated inside full-scale composting piles. In total 1375 cross-sections were made and presented in 230 figures. The research aimed to investigate the phenomenon of gas evolution during the composting of biowaste depending on the pile turning regime (no turning, turning once a week, and turning twice a week) and pile location (outdoors, and indoors in a composting hall). The analyzed biowaste (a mixture of tree leaves and branches, grass clippings, and sewage sludge) were composted in six piles with passive aeration including additional turning at a municipal composting plant. The chemical composition and temperature of process gases within each pile were analyzed weekly for ~49–56 days. The variations in the degree of pile aeration (O2 content), temperature, and the spatial distribution of CO, CO2 and NO concentration during the subsequent measurement cycles were summarized and visualized. The lowest O2 concentrations were associated with the central (core) part of the pile. Similarly, an increase in CO content in the pile core sections was found, which may indicate that CO is oxidized in the upper layer of composting piles. Higher CO and CO2 concentrations and temperature were also observed in the summer season, especially on the south side of piles located outdoors. The most varied results were for the NO concentrations that occurred in all conditions. The dataset was used by the composting plant operator for more sustainable management. Specifically, the dataset allowed us to make recommendations to minimize the environmental impact of composting operations and to lower the risk of worker exposure to CO. The new procedure is as follows: turning of biowaste twice a week for the first two weeks, followed by turning once a week for the next two weeks. Turning is not necessary after four weeks of the process. The recommended surface-to-volume ratio of a compost pile should not exceed 2.5. Compost piles should be constructed with a surface-to-volume ratio of less than 2 in autumn and early spring when low ambient temperatures are common.
Carbon monoxide (CO), an air pollutant and a toxic gas to humans, can be generated during aerobic digestion of organic waste. CO is produced due to thermochemical processes, and also produced or consumed by cohorts of methanogenic, acetogenic, or sulfate-reducing bacteria. The exact mechanisms of biotic and abiotic formation of CO in aerobic digestion (particularly the effects of process temperature) are still not known. This study aimed to determine the temporal variation in CO concentrations during the aerobic digestion as a function of process temperature and activity of microorganisms. All experiments were conducted in controlled temperature reactors using homogeneous materials. The lab-scale tests with sterilized and non-sterilized mix of green waste, dairy cattle manure, sawdust (1:1:1 mass ratio) were carried out for 1 week at 10, 25, 30, 37, 40, 50, 60, 70°C to elucidate the biotic vs. abiotic effect. Gas concentrations of CO, O2, and CO2 inside the reactor were measured every 12 h. The CO concentrations observed for up to 30°C did not exceed 100 ppm v/v. For 50 and 60°C, significantly (p < 0.05) higher CO concentrations, reaching almost 600 ppm v/v, were observed. The regression analyses showed in both cases (sterile and non-sterile) a statistically significant effect (p < 0.05) of temperature on CO concentration, confirming that the increase in temperature causes an increase in CO concentration. The remaining factors (time, O2, and CO2 content) were not statistically significant (p > 0.05). A new polynomial model describing the effect of temperature, O2, and CO2 concentration on CO production during aerobic digestion of organic waste was formulated. It has been found that the proposed model for sterile variant had a better fit (R2 = 0.86) compared with non-sterile (R2 = 0.71). The model predicts CO emissions and could be considered for composting process optimization. The developed model could be further developed and useful for ambient air quality and occupational exposure to CO.
Composting processes reduce the weight and volume of biowaste and produce products that can be used in agriculture (e.g., as fertilizer). Despite the benefits of composting, there are also problems such as odors and the emission of pollutants into the atmosphere. This research aimed to investigate the phenomenon of process gas (CO, CO2, NO, O2) evolution within a large-scale municipal composter. The effects of turning frequency and pile location (outdoor vs. indoors) on process gas and temperature spatial and temporal evolution were studied in six piles (37‒81 tons of initial weight) over a six-month period. The biowaste consisted of green waste and municipal sewage sludge. The chemical composition and temperature of process gases within four cross sections with seven sampling locations were analyzed weekly for ~7–8 weeks (a total of 1375 cross sections). The aeration degree, temperature, CO, CO2, and NO concentration and their spatial and temporal distribution were analyzed. Final weight varied from 66% reduction to 7% weight gain. Only 8.2% of locations developed the desired chimney effect (utilizing natural buoyancy to facilitate passive aeration). Only 31.1% of locations reached thermophilic conditions (necessary to inactivate pathogens). Lower O2 levels corresponded with elevated CO2 concentrations. CO production increased in the initial composting phase. Winter piles were characterized by the lowest CO content. The most varied was the NO distribution in all conditions. The O2 concentration was lowest in the central part of the pile, and aeration conditions were good regardless of the technological regime used. Turning once a week was sufficient overall. Based on the results, the most favorable recommended procedure is turning twice a week for the first two weeks, followed by weekly turning for the next two weeks. After that, turning can be stopped unless additional removal of moisture is needed. In this case, weekly turning should continue until the process is completed. The size of the pile should follow the surface-to-volume ratio: <2.5 and <2 for cooler ambient conditions.
Knowledge of kinetic parameters of CO production during biowaste composting is significantly important for the prediction of its course and estimation of total gas quantity. This allows increasing the control of the process, to minimize its negative impact on the environment and to protect the occupational safety of employees exposed to CO in the biowaste composting plant. For the first time, a full study of the influence of temperature and biowaste sterilization on the kinetics of CO production is presented. The lab-scale experiments used a mixture of green waste, dairy cattle manure, and sawdust in two variants: sterilized and non-sterilized samples. The process was carried out in controlled temperature reactors with measuring the concentrations of CO, O2, and CO2 every 12 h.CO production and k value increased with temperature. However, higher CO production was observed in biotic conditions between 10~50 °C, suggesting the biotic CO formation and 1st-order kinetics. The abiotic (thermochemical) process was more efficiently generating CO above 50 °C, described with a 0-order kinetic model. Additionally, the rate constant (k) value of CO production under biotic conditions was increasing up to a temperature of 60 °C, above which a slight decrease in CO production rate was observed at 70 °C. The presented results are the basis for further studies focused on the feasibility of (1) the mitigation and (2) valorization of CO production during the biowaste biostabilization are warranted.
There are insufficient data for the development of process design criteria for constructed wetlands systems based on submerged plants as a major treatment agent. The aim of the study was to evaluate the oxygen transfer capacity (OTC) of E. densa, in relation to wet plants’ mass (w.m.), and the influence of E. densa on the oxygen concentration and contaminants’ removal efficiency from municipal wastewater. The obtained oxygen concentration and temperature data allowed to calculate the OTC values (mg O2·L−1·h−1), which had been related to wet plants’ mass unit (mg O2·L−1·h−1·g w.m.−1). The efficiency of wastewater treatment was determined in relation to initial wastewater content in the mixture of wastewater and tap water (0%, 25%, 50%, and 100%) during 3 days of the experiment duration. The simulation of day and night conditions was done by artificial lighting. Before and after finishing the second experiment, the COD, Ntotal, and P-PO4 concentration were analyzed in wastewater solutions. The OTC ranged from 3.19 to 8.34 (mgO2·L−1·h−1·g w.m.−1), and the increase of OTC value was related to the increase of wet plant’s mass. The research showed that E. densa affected positively on the wastewater treatment efficiency, and the highest efficiency was achieved in 25% wastewater solution: 43.6% for COD, 52.9% for Ntotal, 14.9% for P-PO4.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.