No abstract

Carbon fibers (CFs) of high quality were produced from hydrocarbons such as isobutane or ethylene using the catalytic chemical vapor deposition method (CCVD) and Ni catalyst. The as-prepared samples were functionalized with acidic groups using concentrated sulfuric acid or 4-benzenediazonium sulfonate (BDS) generated in situ from sulfanilic acid and sodium nitrite. The morphological features of the materials were confirmed by transmission electron microscopy, whereas their physicochemical properties were characterized by means of elemental and textural analyses, thermogravimetric (TG) method, Raman spectroscopy, potentiometric back titration, and X-ray diffraction analysis. The obtained CFs were used as catalysts in glycerol etherification with tert-butyl alcohol at 110 °C under autogenous pressure. The BDS-modified CFs were particularly effective in the reaction, showing high glycerol conversions (of about 45–55% after 6 h) and substantial yields of mono- and di-glycerol ethers. It was found that the chemistry of the sample surface was crucial for the process. The high concentration of -SO3H groups decorating CFs boosted the formation of di- and tri-tert-butyl glycerol ethers. Surface oxygen functionalities also had a positive effect on the reaction, however, their impact on the catalytic performances of CFs was significantly weaker compared to that shown by -SO3H groups and it was probably due to the adsorption of reagents on the catalyst surface.

No abstract

No abstract

Ethylene was thermocatalytically transformed into carbon products via a CCVD process. The filamentous carbon obtained was further modified with concentrated sulfuric acid or 4‐benzenediazonium sulfonate (BDS) to produce acid-type catalysts. The as-prepared samples were characterized by SEM and TEM techniques to confirm their morphological features. TG, XRD, elemental, and porosity analyses were also performed to assess the quality of these materials. The fabricated carbons were tested in eco-friendly green synthesis of value-added fuel bio-additives, namely in glycerol esterification. The reaction of glycerol transformation was performed with acetic acid at 80 °C using different glycerol to acetic acid (Gly/AA) molar ratios. The samples functionalized with diazonium salt showed better performance in the above process than those modified with H2SO4, and this was found to be directly related to the degree of surface functionalization with acidic sites. BDS-modified carbon fibers allowed obtaining acceptable results within 6 h when the reaction was performed with a Gly/AA molar ratio of 1:6, however, the dominant products in this case were mono- and diacetins. Extended reaction time altered the distribution of products. Finally, the combined selectivity to the targeted acetins (i.e., DA and TA) was about 75.5%. A direct correlation between the content of –SO3H groups of CNFs and the yield of higher acetins was found.