In the present work, microfibrillated cellulose (MFC) made from bleached sulfite softwood dissolving pulp was utilized to reinforce a poly(ε-caprolactone) (PCL) biopolymer matrix. To improve the dispersibility of the hydrophilic MFC in the nonpolar matrix and the interfacial adhesion in the composite material, we covalently grafted the MFC with PCL via ring-opening polymerization (ROP) of ε-caprolactone (ε-CL). To be able to investigate the effect of the PCL graft length on the mechanical properties of the composite material, we performed ROP to different molecular weights of the grafts. Bionanocomposites containing 0, 3, and 10 wt % MFC were prepared via hot pressing using both unmodified and PCL grafted MFC (MFC-g-PCL) as reinforcement. PCL grafting resulted in improved dispersion of the MFC in a nonpolar solvent and in the PCL matrix. The mechanical testing of the biocomposites showed an improvement in the mechanical properties for the PCL grafted MFC in comparison to ungrafted MFC. It was also shown that there was an impact on the mechanical properties with respect to the PCL graft lengths, and the strongest biocomposites were obtained after reinforcement with MFC grafted with the longest PCL graft length.

Previous attempts to use polylactide (PLA) latex particles and nanofibrillated cellulose (NFC) in papermaking processing have been limited to low NFC content. In the present study, a bionanocomposite material was successfully produced using a PLA latex and NFC. The components were mixed using a wet mixing method and bionanocomposite films were made by filtration followed by hot pressing. In composite materials, the dispersion of the reinforcing component in the matrix is critical for the material properties. Biopolymers such as PLA are non‐polar and soluble only in organic solvents; NFC is, however, highly hydrophilic. By utilizing latex, i.e., an aqueous dispersion of biopolymer micro‐particles, wet mixing is possible and the problem of aggregation of the hydrophilic nanocellulose in organic solvent is avoided. The properties of the resulting NFC/PLA latex bionanocomposite films were analyzed. Thorough blending resulted in good dispersion of the reinforcing component within the matrix. Adding increasing amounts of NFC improved the Young's modulus, tensile strength, and strain at break of the bionanocomposite material. The increase in the tensile properties was linear with increasing NFC content as a result of the good dispersion. The NFC also improved the thermal stability of the bionanocomposite material. © 2012 Wiley Periodicals, Inc. J Appl Polym Sci, 2012

No abstract