The paper presents the methods of determination of the actual operation of solid fuel heating boilers in Poland. The analysis was based on an average annual distribution of the actual power outputs of the solid fuel heating boilers operated in four selected locations in Poland. Based on said data, three characteristic percent shares have been estimated of the nominal power outputs, at which the heating boilers in Poland operate throughout the year (divided into four characteristic portions—the seasons of the year). Additionally, for the analysis, the authors took into account the average annual temperature amplitude and the annual air quality information for the discussed locations and analyzed 30 solid fuel heating boilers in terms of their performance in the laboratory certification tests. In the final stage of the investigations, the authors initiated laboratory tests on the application of the combustion quality analyzers and their potential benefits.
The paper examined the impact of wood pellets of different type on the emission of nitrogen oxides (NO x) formed during the combustion process in a low-power heating boiler. The study aim was to determine the dependencies of the NO x emission levels on the chemical composition of fuel. The test was carried out using a model of a combustion chamber equipped with a dedicated burner. The analysis of the results confirmed the relationship between flue gas and the formation of NO x. The obtained results prove the possibility of reorganizing the combustion process in order to reduce the NO x emission by selecting a proper composition of raw materials when producing wood pellets.
This academic paper revolves around the results of research on the change in emission parameters of the used heating boiler following the introduction of the overheated water stream, which had an impact on different emission parameters. The research results provide an insight into the hard coal combustion process, which had a significant impact on the change in the chemical composition of exhaust gases: it contributed to the lower mass concentration of the emitted dust and black carbon (PM) as well as nitric oxides (NOx) while, at the same time, playing a significant role in increasing the mass concentration of the emitted carbon oxide (CO). Two types of devices were used for the purposes of conducting the research at hand: a boiler with an automatic fuel feeding system with one combustion chamber and a boiler with a combustion chamber and an afterburning chamber fitted over it. Apart from the measurements of mass concentration of the emitted harmful substances, the research also focused on measurements of temperature inside the combustion and afterburning chambers, as well as the temperature of exhaust gases and their oxygen content. As part of the research, water steam was introduced to the combustion and afterburning chambers at the flow rate of 0.71 kg/h and 3.60 kg/h for boilers operating at a minimum power of 30% and a nominal power of 100%. An original steam generator with an overheated water steam production range from 0.71 kg/h to 3.60 kg/h was used to create and feed the water steam. The efficiency of the combustion process was calculated using the obtained results for each operating configuration of a given boiler.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.