The hidden nature of a glued-in rod joint presents considerable challenges with regards to quality control, and there has been minimal research on the subject to fully understand the influence of defects on the joint performance. In this study, voids in adhesive line or glue-free zones were simulated in various depths of the embedded rod, and the results were compared to a reference sample population without defects. Withdrawal capacity of glued-in steel threaded rods were lower compared to reference group samples without gluing defects, when glue simulated voids or glue-free zones were positioned in the middle part and upper (closer to sample crosscut surface) part of the glued-in rods. And no difference was observed of simulated glue-free zones in the lower (the deepest) part, closer to the end of the glued-in rod, compared to reference group samples without gluing defects.
Retrofitting existing buildings with prefabricated insulation panels provides not only considerably fasterconstruction rates, greater insulation layer thicknesses, but also more finishing options and optimalwindow placement, when compared to traditional method for retrofitting façades. Considering thevariety of buildings in need of renovation, more knowledge of implementation of this type of renovationis of an great importance both for contractors and future manufacturers. A pilot project, retrofitting ofa facede, made in 1970’s with an area of approximatelt 135 m2 was done and equipped with a variety ofsensors in order to provide insight for the performance of the insulation panels.
In the market of the Latvia different wood surface coating materials suitable for use in outdoor conditions are offered, but available information on the efficiency of these against direct water exposure is insufficient. For structural timber building elements, such as glued laminated timber (GLT), the surface coating should be applied taking into account technological, visual or colour changes (ISO 7724:1984) and – last, but not least – economic aspects are considered. Wood surfaces coated with coating materials, such as varnishes, paints, etc. can stabilize some properties such as movement of moisture content, dimensional changes and attack by microorganisms and fungi. The changes in the moisture content of timber may influence such important parameters as mechanical properties and the total life time of the structural timber elements. A study has been conducted with the aim of assessing the efficiency of coating materials used for wood protection against water absorption. In this study, six different commercial coating products used for the treatment of spruce (Picea Abies L. Karst.) and pine (Pinus Sylvestris L.) samples were tested. The efficiency of different coating substances was assessed using two modified test methods according to the standards EN 382-2 (1994) and EN 927-5 (2006), determining the surface water absorption after immersion in water for 24 h and the dynamics of water absorption of the glued laminated timber for 696 h kept in water. As a result of the study, it has been ascertained that organic solvent-based commercial coating products are more efficient against short-term and long-term wood water absorption compared to oil-based coating materials.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.