White spot lesions (WSLs) are very frequent alterations during orthodontic treatments causing demineralization of the dental enamel. Various dental treatments have been developed to prevent WSLs; the prevalence and incidence of these lesions remain significantly high. Although silver nanoparticles (AgNPs) have demonstrated good inhibitory effects against several microorganisms, more studies about antiadherence activity on different orthodontic appliance surfaces are necessary. To determine the inhibitory effect and antiadherence activity of AgNPs on the adhesion of S. mutans on surfaces of brackets and wires for orthodontic therapies, two sizes of AgNPs were prepared and characterized. The evaluation of S. mutans adhesion was performed with microbiological assays on surfaces of brackets and orthodontic modules in triplicate. Topographic characteristics of orthodontic brackets and wires were made by scanning electron and atomic force microscopies. All AgNP samples inhibited S. mutans adhesion; however, the smaller AgNPs had better inhibition than the larger ones. The presence of the module influenced the adhesion of S. mutans but not in the activity of AgNPs. The AgNPs used in this study showed to have good antimicrobial and antiadherence properties against S. mutans bacteria determining its high potential use for the control of WSLs in orthodontic treatments.
Agave
fibers were used to elaborate transparent and flexible cellulose hydrogel
films used as a scaffold for tissue regeneration and tested by in
vitro assays with NIH 3T3 fibroblast cells. Using a dimethylacetamide/lithium
chloride (DMAc/LiCl) system made it possible to obtain cellulose solutions,
and hydrogel films were prepared by phase inverse method without cross-linker.
The concentration of LiCl in the DMAc solution was varied from 4 to
12 wt %. The resultant hydrogel films showed water contents in the
range of 239–323% and enough film strength from 50 to 66 N/mm2, when the LiCl was changed from 4 to 12 wt % concentrations,
respectively. The prepared agave cellulose films showed better cytocompatibility
than the polystyrene dish used as control. Atomic force microscopy
images showed that the hydrogel films with lower LiCl apparently contained
ordered and aggregated fiber orientation. This comparison suggested
that the segmental microstructure in the hydrogel films influenced
fibroblast cells spreading.
Introduction. In our days, several approaches reported the use of natural compounds in medical applications. Among them, pectin and allantoin are nontoxic, biocompatible, and biodegradable; however, its use for possible wound healing therapeutics is still limited. Pectin and allantoin have been applied in pharmaceutical industry and beauty cosmetic and could be also applied as scaffolds for tissue regeneration, wound healing, and so on. The aim of this study was to combine by the first time two natural ingredients to develop a new biomaterial to treat skin injuries in a rat model. Methods. For the hydrogel development, new synthesis parameters were established for the obtaining of the film such as temperature, mixing velocity and time, and drying temperatures as well. To enrich the film, the allantoin concentrations were set at 90 wt% and 100 wt% of pectin used. By in vivo assay, films were tested in wound healing in female Wistar rats,
190
±
10
g
in weight and 2 months aged. Results. The obtained films comprise 2 well-differentiated layers, one layer rich in allantoin, which will be the regenerative layer, and one rich in pectin, which will work as an antimicrobial and protective layer to the wound. These were characterized by swelling kinetics, Fourier transform of the infrared spectrum of absorption (FTIR) spectroscopy, and contact angle. The morphology and topography were determined by scanning electron microscopy (SEM) and confocal laser scanning microscopy (CLSM). In vivo assay showed remarkable reduce in a time period in a wound healing process when the film was used. The results show that the use of PA (Pectin-Allantoin) hydrogel reduces the total healing time by 25% approximately. Conclusions. Pectin-Allantoin (PA) film has potential use in medical applications as wound healing material promoting healthy tissue renewal.
Ultrasound (US) drug release system using cellulose based hydrogel films was developed as triggered to mimosa. Here, the mimosa, a fascinating drug to cure injured skin, was employed as the loading drug in cellulose hydrogel films prepared with phase inversion method. The mimosa hydrogels were fabricated from dimethylacetamide (DMAc)/LiCl solution in the presence of mimosa, when the solution was exposed to ethanol vapor. The US triggered release of the mimosa from the hydrogel matrix was carried out under following conditions of US powers (0-30W) and frequencies (23, 43 and 96kHz) for different mimosa hydrogel matrix from 0.5wt% to 2wt% cellulose solution. To release the drug by US trigger from the matrix, the better medicine release was observed in the matrix prepared from the 0.5wt% cellulose solution when the 43kHz US was exposed to the aqueous solution with the hydrogel matrix. The release efficiency increased with the increase of the US power from 5 to 30W at 43kHz. Viscoelasticity of the hydrogel matrix showed that the hydrogel became somewhat rigid after the US exposure. FT-IR analysis of the mimosa hydrogel matrixes showed that during the US exposure, hydrogen bonds in the structure of mimosa-water and mimosa-cellulose were broken. This suggested that the enhancement of the mimosa release was caused by the US exposure.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.