Mevcut çalışmada betonarme kirişlerde soğuk derz tipi birleşimin kiriş eğilme davranışı üzerindeki etkileri araştırılmıştır. Bu kapsamda toplam yedi adet kirişin dört nokta eğilme testleri gerçekleştirilmiştir. Bu kirişler 150 mm genişliğe, 300 mm yüksekliğe ve 3000 mm uzunluğa sahiptir. Soğuk derzler üç farklı yöntem ile oluşturulmuştur. Bunlardan ilk ikisi kirişin tam ortasında yani sabit moment bölgesinde yatayla 45 ve 90° açı yapacak şekilde iken, sonuncusu ise kiriş yarı yüksekliği seviyesinde kiriş uzunluğu boyunca devam etmektedir. Tüm soğuk derz birleşimleri betonun 24 saatlik arayla iki ayrı dökümü neticesinde elde edilmiştir. Farklı tipte soğuk derz birleşimine sahip betonarme kirişlerin eğilme davranışlarının net şekilde belirlenmesi için çalışmada tek dökümden üretilmiş bir referans kirişe de yer verilmiştir. Ayrıca soğuk derz birleşimlerinde aderans artırıcı harç kullanımının kirişlerin eğilme davranışları üzerindeki etkileri de araştırılmıştır. Bu amaçla farklı derz tipleri için her numuneden birbirinin aynı iki adet üretilmiş ve birer numunede ikinci beton dökümünden önce soğuk derz birleşim yüzeylerine aderans artırıcı harç “MasterBrace ADH 1420” uygulanmıştır.
The use of steel fibers in a certain ratio in the concrete mixture can provide more energy dissipation to transitioning the concrete from a brittle material to a ductile material. The effects of steel fibers on the interlocking force behavior between concrete and reinforcement, as well as on concrete compressive strength, were investigated experimentally in this study. Two different water/cement ratios were prepared in the concrete mixtures for the creation of concrete samples. In the preparation of concrete, the volume of steel fibers was treated as 0.00%, 0.25%, 0.50%, and 1.00%. To evaluate the effects of steel fibers on the interlocking force between reinforcement and concrete, ribbed steel reinforcement bars were embedded by fastening the samples vertically at interlocking lengths of 5 cm, 10 cm, and 15 cm during casting. Pull-out tests and concrete compression tests were performed on the concrete samples that had been cured for 28 days. As a result of the increase in steel fiber volumetric ratios from 0.25% to 1.00%, the compressive strength increased and it was found out that the steel fibers contribute negatively to the increase in compressive strength. Nevertheless, the tensile strength increases in parallel with the increase in interlocking length between concrete and reinforcement, but the tensile strength of the steel fiber samples is generally lower than that of nonfibrous samples. The principal findings of this study demonstrate that the steel fibers have a beneficial effect on flexural behavior, cracking performance, and postcracking residual stresses.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.