The Hangu Formation (Paleocene) consists of sandstone, siltstone, carbonaceous shale, coal and laterite. It is well exposed in the Trans Indus Surghar range and the southern Hazara basin. The sandstone is yellowish brown, fine to coarse grained and medium to thick bedded. The sandstone of the Hangu Formation is classified as quartz arenite on the Q-F-L diagram. It is mostly grain supported and are cemented by silica cement. The study of different stratigraphic sections reveal that Hangu Formation can be sub-divided into a number of lithofacies on the basis of sedimentary structures and lithological variations. These include lateritic lithofacies, coal and carbonaceous shale, cross-bedded sandstone, bioclastic limestone and bioturbated sandstone. All these lithofacies are well-developed in the Baroch Nala section of the Surghar range except the lateritic lithofacies which contains a thin bed of ferruginous clay. In the studied sections of the Hazara basin, the lateritic lithofacies is the only well-developed lithofacies present in the area. The coal occurs at two stratigraphic levels in the Baroch Nala section. The lower coal seam is thick and its chemical study indicates higher calorific value and carbon content than the upper coal seam and with low moisture/ash content. On the basis of the calorific value, the coal of the Hangu Formation is characterized as high volatile bituminous. The degree of laterization is strong in the Langrial and Khanpur sections and moderate in Baroch Nala section.
The Himalayan main frontal thrust (MFT) accommodates most of the present-day Indo–Asia convergence with related periodic earthquakes. The seismicity and deformation mechanism varies considerably across the frontal Himalayas. We mapped a segment (Manzai Ranges) of the MFT at the western margin of the Himalayas and analyzed its deformation mechanism and active tectonics using geomorphic indices and the Interferometric Synthetic Aperture Radar (InSAR) Small Baseline Subset (SBAS) technique. Two frontal thrust faults (Khirgi and Jandola) were mapped using Sentinel-2B band ratios in the study area. Water gaps were present in the form of deflected streams at the tip of the growing anticlines. The C-band RADAR interferometry (Sentinel-1A) showed an average uplift of 5–9 mm/year in the satellite line of sight (LOS) from May 2018 to October 2019. The velocity profiles show an uplift variation across the anticlines and may be related to the displacement transfer from the zone of compression in the Manzai Ranges to the zone of transpression in the Pezu–Bhittani Ranges. Four types of morphometric analyses were carried out to assess the relative tectonic activity, namely mountain front sinuosity index (Smf), valley floor width to height ratio (Vf), normalized longitudinal river profile, and normalized channel steepness index (Ksn). The landscape response to active tectonics in the study area was recorded as a deep fluvial incision in V-shaped valleys, convex river profiles, topographic breaks as knickpoints, and a high Ksn index. The geomorphic parameters show a relative increase in tectonic uplift and deformation from the Kundi anticline to the Khirgi and Manzai anticline. We concluded that the frontal structures in the western Himalayas are still going through an active phase of deformation and landscape development with both seismic and aseismic creep.
The Suleiman Fold-Thrust Belt represents an active deformational front at the western margin of the Indian plate and has been a locus of major earthquakes. This study focuses on the western part of the Suleiman Fold-Thrust Belt that comprises two parallel NW–SE oriented faults: Harnai Fault and Karahi Fault. These faults have known thrust components; however, there remains uncertainty about the lateral component of motion. This work presents the new observation of surface deformation using the Small Baseline Subset (SBAS), Interferometric Synthetic Aperture Radar (InSAR) technique on Sentinel-1A datasets to decompose displacement into the vertical and horizontal components employing ascending and descending track geometries. The subsurface structural geometry of this area was assessed using 2D seismic and well data. In addition, geomorphic indices were calculated to assess the relative tectonic activity of the area. InSAR results show that the Karahi Fault has a ~15 mm right-lateral movement for descending and ~10 mm/for ascending path geometries. The Harnai Fault does not show any lateral movement. Seismic data are in agreement with the InSAR results suggesting that the Harnai Fault is a blind thrust. This work indicates that the block between these two faults displays a clockwise rotation that creates the “bookshelf model”.
The current study uses an integrated lithofacies, optical microscopy, and scanning electron microscopy (SEM) analysis to investigate the sedimentary processes, depositional architecture, and reservoir rock potential of the Tredian Formation’s (Mid-Triassic) mixed siliciclastic and carbonate succession in the Salt and Trans-Indus Ranges. The formation has been divided litho-stratigraphically into two components: the lower Landa Member, which consists of fine-grained sandstone and shale, and the upper Khatkiara Member, which consists of coarse-grained sandstone. Based on sedimentary structures and lithology, four distinct types of lithofacies are identified. Two lithofacies representing sandstones interbedded with shale (LF1) and thick-bedded sandstone (LF2) lithofacies suggestive of fluvio-deltaic settings are among them. Another two lithofacies of thin-bedded sandstone (LF3) and dolomite (LF4) suggest a tidal flat depositional environment, correspondingly. The petrographic examination of the Tredian sandstones indicates a lithology ranging from sub-feldspathic arenite to feldspathic arenite with moderate packing. The presence of primary calcite cement, silica cement, and iron oxide/hydroxide cements were shown by the diagenetic investigation, which was supported by SEM studies. In addition, secondary cements include ferroan-dolomite, chlorite, and illite, which is linked with chemical alteration of unstable grains. The paragenetic sequence depicts the diagenetic evolution of the Tredian sandstone from early to late diagenetic phases. The reservoir quality of the LF1 and LF4 lithofacies has been destroyed by early-stage calcite cementation, but the lithofacies LF2 and LF3 have a strong reservoir potential owing to the scarcity of calcite cement, dissolution of unstable feldspar grains, and grain fracture.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.