No abstract

Enhanced aerosol abundance in the upper troposphere and lower stratosphere (UTLS) associated with the Asian summer monsoon (ASM) is referred to as the Asian Tropopause Aerosol Layer (ATAL). The chemical composition, microphysical properties, and climate effects of aerosols in the ATAL have been the subject of discussion over the past decade. In this work, we use the ECHAM/MESSy Atmospheric Chemistry (EMAC) general circulation model at a relatively fine grid resolution (about 1.1 × 1.1 • ) to numerically simulate the emissions, chemistry, and transport of aerosols and their precursors in the UTLS within the ASM anticyclone during the years 2010-2012. We find a pronounced maximum of aerosol extinction in the UTLS over the Tibetan Plateau, which to a large extent is caused by mineral dust emitted from the northern Tibetan Plateau and slope areas, lofted to an altitude of at least 10 km, and accumulating within the anticyclonic circulation. We also find that the emissions and convection of ammonia in the central main body of the Tibetan Plateau make a great contribution to the enhancement of gas-phase NH 3 in the UTLS over the Tibetan Plateau and ASM anticyclone region. Our simulations show that mineral dust, water-soluble compounds, such as nitrate and sulfate, and associated liquid water dominate aerosol extinction in the UTLS within the ASM anticyclone. Due to shielding of high background sulfate concentrations outside the anticyclone from volcanoes, a relative minimum of aerosol extinction within the anticyclone in the lower stratosphere is simulated, being most pronounced in 2011, when the Nabro eruption occurred. In contrast to mineral dust and nitrate concentrations, sulfate increases with increasing altitude due to the larger volcano effects in the lower stratosphere compared to the upper troposphere. Our study indicates that the UTLS over the Tibetan Plateau can act as a well-defined conduit for natural and anthropogenic gases and aerosols into the stratosphere.

Ensuring water availability for agriculture and drinking water supply in semi-arid mountainous regions requires control of factors influencing groundwater availability. In most cases, the population draws its water needs from the alluvial aquifers close to villages that are already limited and influenced by current climatic change. In addition, the establishment of deep wells in the hard rock aquifers depletes the aquifer. Hence, understanding the factors influencing water availability is an urgent requirement. The use of geographic information system (GIS), and remote sensing (RS), together with decision-making methods like analytical hierarchy process (AHP) will be of good aid in this regard. In the Tata basin, located in SE Morocco, ten factors were used to explain the groundwater potentiality map (GWPM). Five categories of potential zones were determined: very low (8.67%), low (17.74%), moderate (46.77%), high (19.95%), and very high (6.87%). The efficiency of the AHP model is validated using the ROC curve (receiver operating characteristics) which revealed a good correlation between the high potential groundwater zones and the spatial distribution of high flow wells. Geophysical prospecting, using electrical resistivity profiles, has made it possible to propose new well sites. It corresponds to conductive resistivity zones that coincide with the intersection of hydrogeological lineaments.

This study is focused on developing an approach for spatial mapping of groundwater by considering four types of factors (geological, topographical, hydrological, and climatic factors), and by using different bivariate statistical models, such as frequency ratio (FR) and Shannon’s entropy (SE). The developed approach was applied in a fractured aquifer basin (Ameln Basin, Western Anti-Atlas, Morocco), to map the spatial variation of groundwater potential. Fifteen factors (15) influencing groundwater were considered in this study, including slope degree, slope aspect, elevation, topographic wetness index (TWI), slope length (LS), topographic position index (TPI), plane curvature, profile curvature, drainage density, lineament density, distance to rivers and fault network, normalized difference vegetation index (NDVI), lithology, and land surface temperature (LST). The potential maps produced were then classified into five classes to illustrate the spatial view of each potential class obtained. The predictive capacity of the frequency ratio and Shannon’s entropy models was determined using two different methods, the first one based on the use of flow data from 49 boreholes drilled in the study area, to test and statistically calibrate the predictive capacity of each model. The results show that the percentage of positive water points corresponds to the most productive areas (high water flow) (42.86% and 30.61% for the FR and SE models, respectively). On the other hand, the low water flows are consistent with the predicted unfavorable areas for hydrogeological prospecting (4.08% for the FR model and 6.12% for the SE model). Additionally, the second validation method involves the integration of 7200 Hz apparent resistivity data to identify conductive zones that are groundwater circulation zones. The interpretation of the geophysical results shows that the high-potential zones match with low apparent resistivity zones, and therefore promising targets for hydrogeological investigation. The FR and SE models have proved very efficient for hydrogeological mapping at a fractured basement area and suggest that the northern and southern part of the study area, specifically the two major fault zones (Ameln Valley in the north, and the Tighmi-Tifermit Valley in the south) has an adequate availability of groundwater, whereas the central part, covering the localities of Tarçouat, Boutabi, Tililan, and Ighalen, presents a scarcity of groundwater. The trend histogram of the evolution of positive water points according to each potentiality class obtained suggests that the FR model was more accurate than the SE model in predicting the potential groundwater areas. The results suggest that the proposed approach is very important for hydrogeological mapping of fractured aquifers, and the resulting maps can be helpful to managers and planners to generate groundwater development plans and attenuate the consequences of future drought.

In the Middle East, water shortage is becoming more and more serious due to the development of agriculture and industry and the increase in population. Saudi Arabia is one of the most water-consuming countries in the Middle East, and urgent measures are needed. Therefore, we integrated data from Gravity Recovery and Climate Experiment (GRACE), and other relevant data to estimate changes in groundwater storage in Saudi Arabia. The findings are as follows: 1) Average annual precipitation (AAP) was calculated to be 76.4, 90, and 72 mm for the entire period, Period I (April 2002 to March 2006) and Period II (April 2006 to July 2016), respectively. 2) The average TWS variation was estimated to be −7.94 ± 0.22, −1.39 ± 1.35, and −8.38 ± 0.34 mm/yr for the entire period, Period I and Period II, respectively. 3) The average groundwater storage was estimated to be +1.56 ± 1.35 mm/yr during Period I. 4) The higher average groundwater depletion rate was calculated to be −6.05 ± 0.34 mm/yr during Period II. 5) Both soil texture and surface streams in the study area promote lateral flow and carry surface water to the Arabian Gulf and the Red Sea. 6) During Period II, average annual recharge rates were estimated to be +9.48 ± 2.37 and +4.20 ± 0.15 km3 for Saudi Arabia and the Saq aquifer, respectively. 7) This integrated approach is an informative and cost-effective technique to assess the variability of groundwater resources in large areas more efficiently.