No abstract

An atomic force microscope colloidal probe technique has been employed to probe normal and friction forces between silica surfaces coated with adsorbed layers of a diblock copolymer of the composition poly(N-isopropylacrylamide) 48 -block-poly(3-acrylamidopropyl)trimethylammonium chloride) 20 , abbreviated PNIPAAM 48 -b-PAMPTMA(+) 20 . The interactions between the PNIPAAM 48 -b-PAMPTMA(+) 20 -coated surfaces across a 0.1 mM NaCl (pH 6) solution at 25 C are purely repulsive, due to a combination of steric and electrostatic double-layer forces. However, when the temperature is increased to 35 C, and subsequently to 45 C, an attractive force develops at short separations due to the unfavourable PNIPAAM-water interaction at these temperatures. The temperature-dependent polymer-water interaction has implications for the friction force between the layers. At 25 C a frictional force that increases linearly with increasing load is observed once the surfaces are brought into close contact. At higher temperatures significantly higher friction forces appear as a consequence of attractive segment-segment interactions. Further, a clearly expressed hysteresis between friction forces encountered on loading and unloading is detected. Our results demonstrate that both normal and friction forces between surfaces can be controlled by temperature changes when temperatureresponsive polymers are employed, and friction forces can be adjusted as required from low to high.

A combination of turbidity, light scattering, and steady shear viscosity experiments has revealed that aqueous solutions of an amphiphilic diblock copolymer or a negatively charged triblock copolymer, both containing poly(N-isopropylacrylamide), can undergo a temperature-induced transition from loose intermicellar clusters to collapsed core-shell nanostructures. Turbidity, light scattering, and viscosity results of these short-chain copolymers disclose transition peaks at intermediate temperatures. At high temperatures, the compact core-shell particles from the diblock copolymer aggregate, whereas no renewed interpolymer association is observed for the triblock copolymer or for the solution of the diblock copolymer with added sodium dodecyl sulfate because the electrostatic repulsive interactions suppress the tendency of forming interpolymer clusters. The temperature-induced building up of intermicellar structures and the formation of large aggregates at high temperature in the solution of the diblock copolymer is significantly reduced under the influence of high shear rates.

The influence of shear flow on aggregation and disaggregation in aqueous solutions of the thermoresponsive methoxy-poly(ethylene glycol)-block-poly(N-isopropylacrylamide) (MPEG53-b-PNIPAAM113) copolymer that exhibits a lower critical solution temperature was investigated with the aid of turbidity, shear viscosity, and rheo small angle light scattering (rheo-SALS) methods. The turbidity results at quiescent conditions revealed a novel transition peak in the turbidity curve at intermediate temperatures, which reflects the delicate interplay between temperature-induced aggregation and shrinking of the species. A similar anomalous transition peak (located at the same temperature) was observed in the steady shear viscosity measurements at intermediate temperatures, and the amplitude of the peak was reduced with increasing shear rate as a consequence of breakup of interaggregate chains. At low temperatures (low sticking probability), enhanced shear rate generated interpolymer aggregates; whereas in the high-temperature domain (high sticking probability) association structures were broken up as the shear rate was increased. The rheo-SALS experiments disclosed growth of aggregates at low temperatures and destruction of association complexes at high temperatures. An increase of the cloud point temperature with rising shear rate is reported, which is interpreted as being a disruption of clusters under the influence of shear stresses.

Therapeutic nanoparticles (NPs) have great potential to deliver drugs against human diseases. Encapsulation of drugs in NPs protects them from being metabolized, while they are delivered specifically to a target site, thereby reducing toxicity and other side-effects. However, non-specific tissue accumulation of NPs, for example in macrophages, especially in the spleen and liver is a general problem with many NPs being developed for cancer therapy. To address the problem of non-specific tissue accumulation of NPs we describe the development of the zebrafish embryo as a transparent vertebrate system for characterization of NPs against cancer. We show that injection of human cancer cells results in tumor-like structures, and that subsequently injected fluorescent NPs, either made of polystyrene or liposomes can be imaged in real-time. NP biodistribution and general in vivo properties can be easily monitored in embryos having selective fluorescent labeling of specific tissues. We demonstrate in vitro, by using optical tweezer micromanipulation, microscopy and flow cytometry that polyethylene glycol (PEG) coating of NPs decreases the level of adhesion of NPs to macrophages, and also to cancer cells. In vivo in zebrafish embryos, PEG coating resulted in longer NP circulation times, decreased macrophage uptake, and reduced adhesion to the endothelium. Importantly, liposomes were observed to accumulate passively and selectively in tumor-like structures comprised of human cancer cells. These results show that zebrafish embryo is a powerful system for microscopy-based screening of NPs on the route to preclinical testing.

Chemically cross-linked poly(N-isopropylacrylamide) (PNIPAM) microgels and PNIPAM with different amounts of acrylic acid groups (PNIPAM-co-PAA) were synthesized and the temperature-induced aggregation behaviors of aqueous suspensions of these microgels were investigated mainly with the aid of dynamic light scattering (DLS) and turbidimetry. The DLS results show that the particles at all conditions shrink at temperatures up to approximately the lower critical solution temperature (LCST), but the relative contraction effect is larger for the microgels without acid groups or for microgels with added anionic surfactant (SDS). A significant depression of the cloud point is found in suspensions of PNIPAM with very low concentrations of SDS. The compression of the microgels cannot be traced from the turbidity results, but rather the values of the turbidity increase in this temperature interval. This phenomenon is discussed in the framework of a theoretical model. At temperatures above LCST, the size of the microgels without attached charged groups in a very dilute suspension is unaffected by temperature, while the charged particles (pH 7 and 11) continue to collapse with increasing temperature over the entire domain. In this temperature range, low-charged particles of higher concentration and particles containing acrylic acid groups at low pH (pH 2) aggregate, and macroscopic phase separation is approached at higher temperatures. This study demonstrates how the stabilization of microgels can be affected by factors such as polymer concentration, addition of ionic surfactant to particles without charged acid groups, amount of charged groups in the polymer, and pH.

Temperature-induced intermicellar structures in aqueous solutions of the thermoresponsive methoxypoly(ethylene glycol)-block-poly(N-isopropylacrylamide) (MPEGn-b-NIPAAM71) copolymer that exhibit a lower critical solution temperature were studied by means of turbidimetry, dynamic light scattering (DLS), shear viscosity, and rheo small-angle light scattering (rheo-SALS) methods. The length of the hydrophilic chains (MPEG) of the copolymer varies from n=0 to n=114. It is shown that this change has a major impact on the temperature-induced association behavior of the polymer in solution. The turbidity results at quiescent conditions revealed a transition peak in the turbidity curve at intermediate temperatures, and this peak as well as the cloud point is shifted toward higher temperatures with increasing length of the hydrophilic chains of the copolymer. The DLS measurements disclosed a fast and a slow relaxation mode, which both are diffusive. From the fast and slow relaxation times the sizes of unimers/micelles and intermicellar clusters, respectively, can be determined. The temperature-induced aggregation is less pronounced in solutions of copolymers with long hydrophilic chains, and the intermicellar structures exhibit an interesting transition at intermediate temperatures. In the shear viscosity measurements large association complexes are formed at high temperatures and at low shear flow for the polymers with short hydrophilic chains, whereas at high shear rates breakup of interaggregate chains was observed. For the copolymer with the highest number of hydrophilic chains (n=114), a novel transition peak was found in the viscosity data. The rheo-SALS results divulged shear-induced structural changes of the association complexes at elevated temperatures. For copolymers with short hydrophilic chains, shear-induced disruption of association complexes was found at higher temperatures, whereas for hairy micelles augmented shear flow promoted the growth of complexes.

The thermoresponsive amphiphilic block copolymer poly(d,l-lactic acid-co-glycolic acid)-block-poly(ethylene glycol)-block-poly(d,l-lactic acid-co-glycolic acid) (PLGA-PEG -PLGA), which exhibits a reversible temperature-induced sol-gel transition at higher polymer concentrations in aqueous solution has attached a great deal of interest because of its potential in biomedical applications. In the present work, the length of the hydrophobic PLGA blocks is kept constant, whereas the length of the hydrophilic PEG block is altered and this variation has a pronounced impact on the phase behavior of the aqueous samples and the structure of the polymer. A short PEG block promotes gelation at a low temperature, whereas a longer PEG block shifts the gelation point to higher temperature. By using a combination of turbidity, rheology, and small angle neutron scattering (SANS) methods, the authors have revealed dramatic temperature effects. In dilute solution, the SANS experiments expose asymmetric ellipsoid structures for the copolymer with the short PEG-spacer, whereas spherical core-shell structure is observed for the polymer with long PEG-spacer. In the semidilute concentration regime, SANS measurements disclose similar profiles for the two copolymers. In a broad temperature interval, the transition from spherical core-shell micelles to cylindrical structure and packing of cylinders is observed.