This paper presents the use of Ca2Mn2O5 as an oxygen-deficient perovskite electrocatalyst for oxygen evolution reaction (OER) in alkaline media. Phase-pure Ca2Mn2O5 was made under mild reaction temperatures through a reductive annealing method. This oxygen deficient perovskite can catalyze the generation of oxygen at ~1.50 V versus (vs) reversible hydrogen electrode (RHE) electrochemically, and reach an OER mass activity of 30.1 A/g at 1.70 V (vs RHE). In comparison to the perovskite CaMnO3, Ca2Mn2O5 shows higher OER activities. The molecular level oxygen vacancies and high spin electron configuration on manganese in the crystal structures are likely the contributing factors for the enhanced performance. This work demonstrates that oxygen-deficient perovskite, A2B2O5, is a new class of high performance electrocatalyst for those reactions that involve active oxygen intermediates, such as reduction of oxygen and OER in water splitting.

Development of acid-stable electrocatalysts with low overpotential for oxygen evolution reaction (OER) is a major challenge to produce hydrogen directly from water. We report in this paper a pyrochlore yttrium ruthenate (YRuO) electrocatalyst that has significantly enhanced performance toward OER in acid media over the best-known catalysts, with an onset overpotential of 190 mV and high stability in 0.1 M perchloric acid solution. X-ray absorption near-edge structure (XANES) indicates YRuO electrocatalyst had a low valence state that favors the high OER activity. Density functional theory (DFT) calculation shows this pyrochlore has lower band center energy for the overlap between Ru 4d and O 2p orbitals and is therefore more stable Ru-O bond than RuO, highlighting the effect of yttrium on the enhancement in stability. The YRuO pyrochlore is also free of expensive iridium metal and thus is a cost-effective candidate for practical applications.

A new motif for infinite metal atom wires with tunable compositions and properties is developed based on the connection between metal paddlewheel and square planar complex moieties. Two infinite Pd chain compounds, [Pd4(CO)4(OAc)4Pd(acac)2] 1 and [Pd4(CO)4(TFA)4Pd(acac)2] 2, and an infinite Pd-Pt heterometallic chain compound, [Pd4(CO)4(OAc)4Pt(acac)2] 3, are identified by single-crystal X-ray diffraction analysis. In these new structures, the paddlewheel moiety is a Pd four-membered ring coordinated by bridging carboxylic ligands and μ2 carbonyl ligands. The planar moiety is either Pd(acac)2 or Pt(acac)2 (acac = acetylacetonate). These moieties are connected by metallophilic interactions. The results showed that these one-dimensional metal wire compounds have photoluminescent properties that are tunable by changing ligands and metal ions. 3 can also serve as a single source precursor for making Pd4Pt bimetallic nanostructures with precise control of metal composition.

No abstract

This paper describes the facile and surfactant-free synthesis of faceted Pt-Ni alloy nanoparticle electrocatalysts using neat N-formylpiperidine as a new type of solvent. Unlike the widely-used colloidal synthesis based on long-carbon chain surfactants, nanoparticles made in neat N-formylpiperidine possess a directly accessible surface for electrocatalytic reactions, making it a very attractive alternative solvent. The area-specific oxygen reduction reaction (ORR) activity is much higher than the commercial Pt/C catalyst reference and reaches a maximum of 1.12 mA cm(-2) for the Pt-Ni alloy nanoparticles. We observed that the freshly formed Pt-Ni alloy could have controllable bulk and near surface compositions under the same initial reaction conditions and precursor ratio. The change in the composition could be attributed to the effect of CO on the formation of uniform nuclei at the initial stage, and a different deposition rate between Pt and Ni metals during the growth. The well-defined Pt-Ni nanoparticle catalysts show strong composition-dependent catalytic behavior in ORR, highlighting the important role of controlling the growth kinetics in the preparation of active Pt-Ni ORR catalysts.

A conveyor transport system is developed for the continuous production of carbon-supported uniform Pt nanocubes, and Pt Ni nanocubes and octahedra in a single-reaction system under hot carbon monoxide environment. Oleylamine is critical for the high loading and even the dispersion of Pt nanocubes on a carbon support. The metal catalyst shows high performance in electrocatalytic oxidation of methanol.

No abstract

On page 4808, a novel conveyor transport system is developed by K.‐C. Tsao and H. Yang for the continuous production of carbon‐supported cubic and octahedral Pt3Ni and cubic Pt electrocatalysts in a single process. This is a unique contribution, as this new approach is effective in producing supported, uniform shape‐controlled nanoparticles and opens a new avenue for the production of advanced catalysts.