The objective of this article is to evaluate low-voltage electron-beam (e-beam) resists suitable for direct write on wafer and mask fabrication in the sub-100 nm regime. Low kV exposure provides the advantages of high sensitivity, reduced charging, and a lack of proximity and heating effects. However, a major concern is whether a low-voltage e-beam is capable of patterning sub-100 nm features in resist with a thickness substantially greater than the penetration range of the electrons. At 1–2 kV, the penetration range is between 30 and 100 nm, while typical resist thickness is >200 nm. In an effort to overcome this limitation, thin film layer techniques are evaluated for low kV e-beam exposure. Preliminary 1 kV results on two thin imaging schemes, the bilayer CARL process and top surface imaging with NTS-4 resist, are reported here. Important results achieved are high sensitivity (1–2 μC/cm2), high contrast (γ>10), high resolution (70 nm in ∼300 nm thick resist), good critical dimension (CD) linearity (range=7 nm, mean=8 nm), large exposure latitude (ΔCD/Δdose=0.5 nm/% change in dose), and absence of proximity effects.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.