We present an overview of the background, scientific goals, and execution of the Aerosol, Radiation, and Cloud Processes affecting Arctic Climate (ARCPAC) project of April 2008. We then summarize airborne measurements, made in the troposphere of the Alaskan Arctic, of aerosol particle size distributions, composition, and optical properties and discuss the sources and transport of the aerosols. The aerosol data were grouped into four categories based on gas-phase composition. First, the background troposphere contained a relatively diffuse, sulfate-rich aerosol extending from the top of the sea-ice inversion layer to 7.4 km altitude. Second, a region of depleted (relative to the background) aerosol was present within the surface inversion layer over sea-ice. Third, layers of dense, organic-rich smoke from open biomass fires in Southern Russia and Southeastern Siberia were frequently encountered at all altitudes from the top of the inversion layer to 7.1 km. Finally, some aerosol layers were dominated by components originating from fossil fuel combustion. <br></br> Of these four categories measured during ARCPAC, the diffuse background aerosol was most similar to the average springtime aerosol properties observed at a long-term monitoring site at Barrow, Alaska. The biomass burning (BB) and fossil fuel layers were present above the sea-ice inversion layer and did not reach the sea-ice surface during the course of the ARCPAC measurements. The BB aerosol layers were highly scattering and were moderately hygroscopic. On average, the layers produced a noontime net heating of ~0.1 K day⁻¹ between 2 and 7 km and a~slight cooling at the surface. The ratios of particle mass to carbon monoxide (CO) in the BB plumes, which had been transported over distances >5000 km, were comparable to the high end of literature values derived from previous measurements in fresh wildfire smoke. These ratios suggest minimal precipitation scavenging and removal of the BB particles between the time they were emitted and the time they were observed in dense layers above the sea-ice inversion layer

The total effect of aerosols, both directly and on cloud properties, remains the biggest source of uncertainty in anthropogenic radiative forcing on the climate. Correct characterization of intensive aerosol optical properties, particularly in conditions where absorbing aerosol is present, is a crucial factor in quantifying these effects. The southeast Atlantic Ocean (SEA), with seasonal biomass burning smoke plumes overlying and mixing with a persistent stratocumulus cloud deck, offers an excellent natural laboratory to make the observations necessary to understand the complexities of aerosol-cloud-radiation interactions. The first field deployment of the NASA ORACLES (ObseRvations of Aerosols above CLouds and their intEractionS) campaign was conducted in September of 2016 out of Walvis Bay, Namibia.Data collected during ORACLES-2016 are used to derive aerosol properties from an unprecedented number of simultaneous measurement techniques over this region. Here, we present results from six of the eight independent instruments or instrument combinations, all applied to measure or retrieve aerosol absorption and single-scattering albedo. Most but not all of the biomass burning aerosol was located in the free troposphere, in relative humidities typically ranging up to 60 %. We present the single-scattering albedo (SSA), absorbing and total aerosol optical depth (AAOD and AOD), and absorption, scattering, and extinction Ångström exponents (AAE, SAE, and EAE, respectively) for specific case studies looking at near-coincident and near-colocated measurements from multiple instruments, and SSAs for the broader campaign average over the month-long deployment. For the case studies, we find that SSA agrees within the measurement uncertainties between multiple instruments, though, over all cases, there is no strong correlation between values reported by one instrument and another. We also find that agreementPublished by Copernicus Publications on behalf of the European Geosciences Union. 9182 K. Pistone et al.: Biomass burning SSA intercomparisonbetween the instruments is more robust at higher aerosol loading (AOD 400 > 0.4).The campaign-wide average and range shows differences in the values measured by each instrument. We find the ORACLES-2016 campaign-average SSA at 500 nm (SSA 500 ) to be between 0.85 and 0.88, depending on the instrument considered (4STAR, AirMSPI, or in situ measurements), with the interquartile ranges for all instruments between 0.83 and 0.89. This is consistent with previous September values reported over the region (between 0.84 and 0.90 for SSA at 550nm). The results suggest that the differences observed in the campaign-average values may be dominated by instrument-specific spatial sampling differences and the natural physical variability in aerosol conditions over the SEA, rather than fundamental methodological differences.

Soon after its successful launch in August 2018, the spaceborne wind lidar ALADIN (Atmospheric LAser Doppler INstrument) on-board ESA’s Earth Explorer satellite Aeolus has demonstrated to provide atmospheric wind profiles on a global scale. Being the first ever Doppler Wind Lidar (DWL) instrument in space, ALADIN contributes to the improvement in numerical weather prediction (NWP) by measuring one component of the horizontal wind vector. The performance of the ALADIN instrument was assessed by a team from ESA, DLR, industry, and NWP centers during the first months of operation. The current knowledge about the main contributors to the random and systematic errors from the instrument will be discussed. First validation results from an airborne campaign with two wind lidars on-board the DLR Falcon aircraft will be shown.

This study examines shallow cumulus cloud fields and their surface shortwave radiative effects using large-eddy simulation (LES) along with observations across multiple days at the Atmospheric Radiation Measurement Southern Great Plains atmospheric observatory. Pronounced differences are found between probability density functions (PDFs) of downwelling surface solar irradiance derived from observations and LES one-dimensional (1D) online radiation calculations. The shape of the observed PDF is bimodal, which is only reproduced by offline three-dimensional (3D) radiative transfer calculations, demonstrating PDF bimodality as a 3D radiative signature of continental shallow cumuli. Local differences between 3D and 1D radiative transfer calculations of downwelling surface solar irradiance are, on average, larger than 150 W m−2 on one afternoon. The differences are substantially reduced when spatially averaged over the LES domain and temporally averaged over the diurnal cycle, but systematic 3D biases ranging from 2 to 8 W m−2 persist across different days. Covariations between the domain-averaged surface irradiance, framed as a surface cloud radiative effect, and the simulated cloud fraction are found to follow a consistent diurnal relationship, often exhibiting hysteresis. In contrast, observations show highly variable behavior. By subsampling the LES domain, it is shown that this is due to the limited sampling density of inherently 3D observations. These findings help to define observational requirements for detecting such relationships, provide valuable insight for evaluating weather and climate models against surface observations as they push to ever higher resolutions, and have important implications for future assessments of solar renewable energy potential.