Abstract. Airborne lidar and in-situ measurements of aerosols and trace gases were performed in volcanic ash plumes over Europe between Southern Germany and Iceland with the Falcon aircraft during the eruption period of the Eyjafjalla 1 volcano between 19 April and 18 May 2010. Flight planning and measurement analyses were supported by a refined Meteosat ash product and trajectory model analysis. The volcanic ash plume was observed with lidar directly over the volcano and up to a distance of 2700 km downwind, and up to 120 h plume ages. Aged ash layers were between a few 100 m to 3 km deep, occurred between 1 and 7 km altitude, and were typically 100 to 300 km wide. Particles collected by impactors had diameters up to 20 µm diameter, with size and age dependent composition. Ash mass concentrations were derived from optical particle spectrometers for aCorrespondence to: U. Schumann (ulrich.schumann@dlr.de) 1 Also known as Eyjafjallajökull or Eyjafjöll volcano, http://www.britannica.com/EBchecked/topic/1683937/ Eyjafjallajokull-volcano particle density of 2.6 g cm −3 and various values of the refractive index (RI, real part: 1.59; 3 values for the imaginary part: 0, 0.004 and 0.008). The mass concentrations, effective diameters and related optical properties were compared with ground-based lidar observations. Theoretical considerations of particle sedimentation constrain the particle diameters to those obtained for the lower RI values. The ash mass concentration results have an uncertainty of a factor of two. The maximum ash mass concentration encountered during the 17 flights with 34 ash plume penetrations was below 1 mg m −3 . The Falcon flew in ash clouds up to about 0.8 mg m −3 for a few minutes and in an ash cloud with approximately 0.2 mg m −3 mean-concentration for about one hour without engine damage. The ash plumes were rather dry and correlated with considerable CO and SO 2 increases and O 3 decreases. To first order, ash concentration and SO 2 mixing ratio in the plumes decreased by a factor of two within less than a day. In fresh plumes, the SO 2 and CO concentration increases were correlated with the ash mass concentration. The ash plumes were often visible slantwise as faint dark layers, even for concentrations below 0.1 mg m −3 .Published by Copernicus Publications on behalf of the European Geosciences Union. U. Schumann et al.: Airborne observations of the Eyjafjalla volcano ash cloud over EuropeThe large abundance of volatile Aitken mode particles suggests previous nucleation of sulfuric acid droplets. The effective diameters range between 0.2 and 3 µm with considerable surface and volume contributions from the Aitken and coarse mode aerosol, respectively. The distal ash mass flux on 2 May was of the order of 500 (240-1600) kg s −1 . The volcano induced about 10 (2.5-50) Tg of distal ash mass and about 3 (0.6-23) Tg of SO 2 during the whole eruption period. The results of the Falcon flights were used to support the responsible agencies in their decisions concerning air traffic in the presence of v...

The North Atlantic Waveguide and Downstream Impact Experiment (NAWDEX) explored the impact of diabatic processes on disturbances of the jet stream and their influence on downstream high-impact weather through the deployment of four research aircraft, each with a sophisticated set of remote sensing and in situ instruments, and coordinated with a suite of ground-based measurements. A total of 49 research flights were performed, including, for the first time, coordinated flights of the four aircraft: the German High Altitude and Long Range Research Aircraft (HALO), the Deutsches Zentrum für Luft- und Raumfahrt (DLR) Dassault Falcon 20, the French Service des Avions Français Instrumentés pour la Recherche en Environnement (SAFIRE) Falcon 20, and the British Facility for Airborne Atmospheric Measurements (FAAM) BAe 146. The observation period from 17 September to 22 October 2016 with frequently occurring extratropical and tropical cyclones was ideal for investigating midlatitude weather over the North Atlantic. NAWDEX featured three sequences of upstream triggers of waveguide disturbances, as well as their dynamic interaction with the jet stream, subsequent development, and eventual downstream weather impact on Europe. Examples are presented to highlight the wealth of phenomena that were sampled, the comprehensive coverage, and the multifaceted nature of the measurements. This unique dataset forms the basis for future case studies and detailed evaluations of weather and climate predictions to improve our understanding of diabatic influences on Rossby waves and the downstream impacts of weather systems affecting Europe.

Near-dawn airborne lidar and dropsonde observations acquired on 7 July 2006, during the African Monsoon Multidisciplinary Analysis (AMMA) Special Observing Period 2a1, were used to investigate dust mobilization, lifting and transport in the intertropical discontinuity (ITD) region over western Niger. Atmospheric reflectivity data from the LEANDRE 2 lidar system enabled us to analyse the structure of dust plumes in the context of wind and thermodynamic information provided by the WIND lidar system and dropsondes. Dust mobilization was mainly observed in two locations: (a) within the monsoon flow as the result of the passage of a density current originating from a mesoscale convective system over southwest Niger, and (b) at the leading edge of the monsoon flow where the near-surface winds and turbulence were strong, because the monsoon flow was behaving as an intrusive density current. The circulation in the head of the monsoon density current lifted the mobilized dust towards the wake, along an isentropic surface. Behind and away from the leading edge, some of the mobilized dust was observed to mix across the monsoon-harmattan interface, due to the existence of mechanical shear above the monsoon layer. The dust thus becomes available for long-range transport by the harmattan. Because dust sources are widespread over the Sahel and presumably active on many days when the ITD is located in this region during summer, dust emissions associated with the described mechanism may influence the radiation budget over West Africa.

Airborne measurements of Lidar backscatter, aerosol concentrations (particle diameters of 4 nm to 50 μm), trace gas mixing ratios (SO₂, CO, O₃, H₂O), single particle properties, and meteorological parameters have been performed in volcanic ash plumes with the Falcon aircraft operated by Deutsches Zentrum für Luft- und Raumfahrt (DLR). A series of 17 flights was performed over Europe between Southern Germany and Iceland during the eruption period of the Eyjafjalla¹ volcano between 19 April and 18 May 2010. Flight planning and measurement analyses were supported by a refined Meteosat ash product and trajectory model analysis. The volcanic ash plume was observed with Lidar directly over the volcano and up to a distance of 2700 km downwind. Lidar and in-situ measurements covered plume ages of 7 h to 120 h. Aged ash layers were between a few 100 m to 3 km deep, occurred between 1 and 7 km altitude, and were typically 100 to 300 km wide. Particles collected by impactors had diameters up to 20 μm diameter, with size and age dependent composition. Ash mass concentration was evaluated for a material density of 2.6 g cm^&minus;3 and for either weakly or moderately absorbing coarse mode particles (refractive index 1.59+0<i>i</i> or 1.59+0.004<i>i</i>). In the absorbing case, the ash concentration is about a factor of four larger than in the non-absorbing limit. Because of sedimentation constraints, the smaller results are the more realistic ones for aged plumes. The Falcon flew in ash clouds up to about 1 mg m^&minus;3 for a few minutes and in an ash cloud with more than 0.2 mg m^&minus;3 mean-concentration for about one hour without engine damages. In fresh plumes, the SO₂ concentration was correlated with the ash mass concentration. Typically, 0.5 mg m^&minus;3 ash concentration was related to about 100 nmol mol^&minus;31 SO₂ mixing ratio and 70 nmol mol^&minus;1 CO mixing ratio increases for this volcano period. In aged plumes, layers with enhanced coarse mode particle concentration but without SO₂ enhancements occurred. To first order, ash concentration and SO₂ mixing ratio in the plumes decreased by a factor of two within less than a day. The ash plumes were often visible as faint dark layers even for concentrations below 0.1 mg m^&minus;3. The ozone concentrations and the humidity inside the plumes were often reduced compared to ambient values. The large abundance of volatile Aitken mode particles suggests nucleation of sulfuric acid droplets. Ammonium sulfate particles were also found on the impactors. The effective diameters decreased from about 5 μm in the fresh plume to about 1 μm for plume ...

The global observation of profiles of the atmospheric wind speed is the highest-priority unmet need for global numerical weather prediction. Satellite Doppler lidar is the most promising candidate to meet the requirements on global wind profile observations with high vertical resolution, precision, and accuracy. The European Space Agency (ESA) decided to implement a Doppler wind lidar mission called the Atmospheric Dynamics Mission Aeolus (ADM-Aeolus) to demonstrate the potential of the Doppler lidar technology and the expected impact on numerical weather forecasting. An airborne prototype of the instrument on ADM-Aeolus was developed to validate the instrument concept and retrieval algorithms with realistic atmospheric observations before the satellite launch. It is the first airborne direct-detection Doppler lidar for atmospheric observations, and it is operating at an ultraviolet wavelength of 355 nm. The optical design is described in detail, including the single-frequency pulsed laser and the two spectrometers to resolve the Doppler frequency shift from molecular Rayleigh and aerosol Mie backscatter. The airborne prototype is representative of the spaceborne instrument, and their specific differences are discussed.