The U.S. Department of Energy's Atmospheric Radiation Measurement (ARM) Program is deploying sensitive, millimeter-wave cloud radars at its Cloud and Radiation Test Bed (CART) sites in Oklahoma, Alaska, and the tropical western Pacific Ocean. The radars complement optical devices, including a Belfort or Vaisala laser ceilometer and a micropulse lidar, in providing a comprehensive source of information on the vertical distribution of hydrometeors overhead at the sites. An algorithm is described that combines data from these active remote sensors to produce an objective determination of hydrometeor height distributions and estimates of their radar reflectivities, vertical velocities, and Doppler spectral widths, which are optimized for accuracy. These data provide fundamental information for retrieving cloud microphysical properties and assessing the radiative effects of clouds on climate. The algorithm is applied to nine months of data from the CART site in Oklahoma for initial evaluation. Much of the algorithm's calculations deal with merging and optimizing data from the radar's four sequential operating modes, which have differing advantages and limitations, including problems resulting from range sidelobes, range aliasing, and coherent averaging. Two of the modes use advanced phase-coded pulse compression techniques to yield approximately 10 and 15 dB more sensitivity than is available from the two conventional pulse modes. Comparison of cloud-base heights from the Belfort ceilometer and the micropulse lidar confirms small biases found in earlier studies, but recent information about the ceilometer brings the agreement to within 20-30 m. Merged data of the radar's modes were found to miss approximately 5.9% of the clouds detected by the laser systems. Using data from only the radar's two less-sensitive conventional pulse modes would increase the missed detections to 22%-34%. A significant remaining problem is that the radar's lower-altitude data are often contaminated with echoes from nonhydrometeor targets, such as insects.

A new millimeter-wave cloud radar (MMCR) has been designed to provide detailed, long-term observations of nonprecipitating and weakly precipitating clouds at Cloud and Radiation Testbed (CART) sites of the Department of Energy's Atmospheric Radiation Measurement (ARM) program. Scientific requirements included excellent sensitivity and vertical resolution to detect weak and thin multiple layers of ice and liquid water clouds over the sites and longterm, unattended operations in remote locales. In response to these requirements, the innovative radar design features a vertically pointing, single-polarization, Doppler system operating at 35 GHz (K a band). It uses a low-peak-power transmitter for long-term reliability and high-gain antenna and pulse-compressed waveforms to maximize sensitivity and resolution. The radar uses the same kind of signal processor as that used in commercial wind profilers. The first MMCR began operations at the CART in northern Oklahoma in late 1996 and has operated continuously there for thousands of hours. It routinely provides remarkably detailed images of the ever-changing cloud structure and kinematics over this densely instrumented site. Examples of the data are presented. The radar measurements will greatly improve quantitative documentation of cloud conditions over the CART sites and will bolster ARM research to understand how clouds impact climate through their effects on radiative transfer. Millimeter-wave radars such as the MMCR also have potential applications in the fields of aviation weather, weather modification, and basic cloud physics research.

The U.S. Department of Energy Atmospheric Radiation Measurement (ARM) Program operates millimeter-wavelength cloud radars in several climatologically distinct regions. The digital signal processors for these radars were recently upgraded and allow for enhancements in the operational parameters running on them. Recent evaluations of millimeter-wavelength cloud radar signal processing performance relative to the range of cloud dynamical and microphysical conditions encountered at the ARM Program sites have indicated that improvements are necessary, including significant improvement in temporal resolution (i.e., less than 1 s for dwell and 2 s for dwell and processing), wider Nyquist velocities, operational dealiasing of the recorded spectra, removal of pulse compression while sampling the boundary layer, and continuous recording of Doppler spectra. A new set of millimeter-wavelength cloud radar operational modes that incorporate these enhancements is presented. A significant change in radar sampling is the introduction of an uneven mode sequence with 50% of the sampling time dedicated to the lower atmosphere, allowing for detailed characterization of boundary layer clouds. The changes in the operational modes have a substantial impact on the postprocessing algorithms that are used to extract cloud information from the radar data. New methods for postprocessing of recorded Doppler spectra are presented that result in more accurate identification of radar clutter (e.g., insects) and extraction of turbulence and microphysical information. Results of recent studies on the error characteristics of derived Doppler moments are included so that uncertainty estimates are now included with the moments. The microscale data product based on the increased temporal resolution of the millimeter-wavelength cloud radars is described. It contains the number of local maxima in each Doppler spectrum, the Doppler moments of the primary peak, uncertainty estimates for the Doppler moments of the primary peak, Doppler moment shape parameters (e.g., skewness and kurtosis), and clear-air clutter flags.

During the past decade, the U.S. Department of Energy (DOE), through the Atmospheric Radiation Measurement (ARM) Program, has supported the development of several millimeter-wavelength radars for the study of clouds. This effort has culminated in the development and construction of a 35-GHz radar system by the Environmental Technology Laboratory (ETL) of the National Oceanic and Atmospheric Administration (NOAA). Radar systems based on the NOAA ETL design are now operating at the DOE ARM Southern Great Plains central facility in central Oklahoma and the DOE ARM North Slope of Alaska site near Barrow, Alaska. Operational systems are expected to come online within the next year at the DOE ARM tropical western Pacific sites located at Manus, Papua New Guinea, and Nauru. In order for these radars to detect the full range of atmospheric hydrometeors, specific modes of operation must be implemented on them that are tuned to accurately detect the reflectivities of specific types of hydrometeors. The set of four operational modes that are currently in use on these radars are presented and discussed. The characteristics of the data produced by these modes of operation are also presented in order to illustrate the nature of the cloud products that are, and will be, derived from them on a continuous basis.

No abstract