In high aspect ratio (HAR) dielectric plasma etching, dual-frequency capacitively coupled radio-frequency plasmas operated at low pressures of 1 Pa or less are used. Such plasma sources are often driven by a voltage waveform that includes a low-frequency component in the range of hundreds of kHz with a voltage amplitude of 10 kV and more to generate highly energetic vertical ion bombardment at the wafer. In such discharges, the energetic positive ions can overcome the repelling potential created by positive wall charges inside the etch features, which allows high aspect ratios to be reached. In order to increase the plasma density a high-frequency driving component at several 10 MHz is typically applied simultaneously. Under such discharge conditions, the boundary surfaces are bombarded by extremely energetic particles, of which the consequences are poorly understood. We investigate the charged particle dynamics and distribution functions in this strongly non-local regime in argon discharges by particle-in-cell simulations. By including a complex implementation of plasma-surface interactions, electron induced secondary electron emission (δ-electrons) is found to have a strong effect on the ionization dynamics and the plasma density. Due to the high ion energies at the electrodes, very high yields of the ion induced secondary electron emission (γ-electrons) are found. However, unlike in classical capacitive plasmas, these γ-electrons do not cause significant ionization directly, since upon acceleration in the high voltage sheaths, these electrons are too energetic to ionize the neutral gas efficiently. These γand δ-electrons as well as electrons created in the plasma bulk and accelerated 8 Author to whom any correspondence should be addressed.
Low pressure single- or dual-frequency capacitively coupled radio frequency (RF) plasmas are frequently used for high-aspect ratio (HAR) dielectric etching due to their capability to generate vertical ion bombardment of the wafer at high energies. Electrons typically reach the wafer at low energies and with a wide angular distribution during the local sheath collapse. Thus, in contrast to positive ions, electrons cannot propagate deeply into HAR etch features and the bottom as well as the sidewalls of such trenches can charge up positively, while the mask charges negatively. This causes etch stops and distortion of profile shapes. Here, we investigate low pressure, high voltage capacitively coupled RF argon gas discharges by Particle-In-Cell/Monte Carlo collisions simulations and demonstrate that this problem can be solved by Voltage Waveform Tailoring, i.e. the velocity and angular distribution of electrons impacting on the electrodes can be tuned towards high velocities and small angles to the surface-normal, while keeping the energies of the impacting ions high. The applied voltage waveforms consist of a base frequency of 400 kHz with 10 kV amplitude and a series of higher harmonics. A high frequency component at 40 or 60 MHz is used additionally. Square voltage waveforms with different rise-times are examined as well. We show that high fluxes of electrons towards the wafer at normal velocities of up to 2.2 × 107 m s−1 (corresponding to 1.4 keV energy) can be realized.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.