Lower Hybrid Current Drive (LHCD) experiments performed at density close to that required for the steady state scenario are reported. On C-Mod, FTU and Tore Supra, a strong decay of the brehmsstrahlung emission is observed when the density is increased, much faster that the prediction of LHCD modelling. On JET, LH power deposition is also found to be sensitive to the plasma density: LH power modulation indicates that the power deposition moves to the very edge of the plasma (r/a ~ 0.9) when the density approaches the requirement of the JET SS scenario. From this experiment but also from the reconstruction of the electron cyclotron emission spectrum, the decrease of the LHCD efficiency with density is also found. From LHCD modelling of different JET pulses performed at different densities and wave parallel refraction indexes, it is concluded that the wave accessibility condition is not the key parameter for explaining the decrease of the efficiency. C-Mod, FTU and Tore Supra experiments indicate that the plasma edge parameters, namely density and temperature but also fluctuations, are affecting the efficiency via loss mechanisms which are likely to be collisional damping (C-Mod), parametric decay instabilities or wave scattering (FTU/ Tore Supra).

Changes of the toroidal plasma rotation induced by directed waves in the ion-cyclotron range of frequencies (ICRF) have been identified experimentally for the first time on the JET tokamak. The momentum carried by the waves is initially absorbed by fast resonating ions, which subsequently transfer it to the bulk plasma. Thus, the results provide evidence for the influence of ICRF heated fast ions on plasma rotation.

The ASDEX Upgrade (AUG) programme is directed towards physics input to critical elements of the ITER design and the preparation of ITER operation, as well as addressing physics issues for a future DEMO design. Since 2015, AUG is equipped with a new pair of 3-strap ICRF antennas, which were designed for a reduction of tungsten release during ICRF operation. As predicted, a factor two reduction on the ICRF-induced W plasma content could be achieved by the reduction of the sheath voltage at the antenna limiters via the compensation of the image currents of the central and side straps in the antenna frame. There are two main operational scenario lines in AUG. Experiments with low collisionality, which comprise current drive, ELM mitigation/suppression and fast ion physics, are mainly done with freshly boronized walls to reduce the tungsten influx at these high edge temperature conditions. Full ELM suppression and non-inductive operation up to a plasma current of I p = 0.8 MA could be obtained at low plasma density. Plasma exhaust is studied under conditions of high neutral divertor pressure and separatrix electron density, where a fresh boronization is not required. Substantial progress could be achieved for the understanding of the confinement degradation by strong D puffing and the improvement with nitrogen or carbon seeding. Inward/outward shifts of the electron density profile relative to the temperature profile effect the edge stability via the pressure profile changes and lead to improved/decreased pedestal performance. Seeding and D gas puffing are found to effect the core fueling via changes in a region of high density on the high field side (HFSHD). The integration of all above mentioned operational scenarios will be feasible and naturally obtained in a large device where the edge is more opaque for neutrals and higher plasma temperatures provide a lower collisionality. The combination of exhaust control with pellet fueling has been successfully demonstrated. High divertor enrichment values of nitrogen E N ⩾ 10 have been obtained during pellet injection, which is a prerequisite for the simultaneous achievement of good core plasma purity and high divertor radiation levels. Impurity accumulation observed in the all-metal AUG device caused by the strong neoclassical inward transport of tungsten in the pedestal is expected to be relieved by the higher neoclassical temperature screening in larger devices.

Experiments showing the dynamics in the self-organization of surface wave sustained discharges are presented. Microwave ͑2.4 GHz͒ discharges maintained in an argon gas in a continuous wave regime at a constant applied power and varying gas pressure are studied. The evolution of the discharge from a stationary plasma column at comparatively low pressure (pр10 Torr) to a plasma torch at atmospheric pressure passes through different stages of self-organization of the wave-field↔plasma nonlinear structure showing evidence of the general trends of behavior of nonequilibrium dissipative systems. The measurements are carried out at the stage of the discharge self-organization into a filamentary structure with an azimuthal rotation. Macroscopic characteristics ͑number, size, velocity of rotation͒ of the filaments and their dependence on the gas pressure and its time variation are given. The total light emission of the plasma considered as giving information about the plasma density is measured and different methods of signal processing ͑including correlation-spectrum analysis͒ are applied. Oscillations of the filament ends are also observed. The different types of interrelation between plasma density and field intensity, registrated in the different pressure ranges, call for variety in the instability mechanisms. Although the scenario of the discharge self-organization is stressed in the discussions, the observations are important with their relation to the discharge applications, which require avoiding conditions of development of instabilities.