No abstract

The adverse effects of stress shielding from the use of high-modulus metallic alloy bio-implant materials has led to increased research into developing polymer-ceramic composite materials that match the elastic modulus of human bone. Of particular interest are poly-l-lactic acid- hydroxyapatite (PLA/HA)-based composites which are fully resorbable in vivo. However, their bioresorbability has a deleterious effect on the mechanical properties of the implant. The purpose of this study is to investigate, from a micromechanistic perspective, the in vitro degradation behavior of such composites manufactured using a simple hot-pressing route for two different hydroxyapatite particles: a fine-grained (average particle size ∼5 μm) commercial powder or coarser whiskers (∼25-30 μm long, ∼5 μm in diameter). We observed that composites with ceramic contents ranging between 70 and 85 wt.% have mechanical properties that match reasonably those of human cortical bone. However, the properties deteriorate with immersion in Hanks' Balanced Salt Solution due to the degradation of the polymer phase. The degradation is more pronounced in samples with larger ceramic content due to the dissolution of the smaller amount of polymer between the ceramic particles.

A key issue for the fabrication of scaffolds for tissue engineering is the development of processing techniques flexible enough to produce materials with a wide spectrum of solubility (bioresorption rates) and mechanical properties matching those of calcified tissues. These techniques must also have the capability of generating adequate porosity to further serve as a framework for cell penetration, new bone formation, and subsequent remodeling. In this study we show how hybrid organic/inorganic scaffolds with controlled microstructures can be built using robotic assisted deposition at room temperature. Polylactide or polycaprolactone scaffolds with pore sizes ranging between 200-500 microm and hydroxyapatite contents up to 70 wt % were fabricated. Compressive tests revealed an anisotropic behavior of the scaffolds, strongly dependant on their chemical composition. The inclusion of an inorganic component increased their stiffness but they were not brittle and could be easily machined even for ceramic contents up to 70 wt %. The mechanical properties of hybrid scaffolds did not degrade significantly after 20 days in simulated body fluid. However, the stiffness of pure polylactide scaffolds increased drastically due to polymer densification. Scaffolds containing bioactive glasses were also printed. After 20 days in simulated body fluid they developed an apatite layer on their surface.