The purpose of this study was to test the hypothesis that patella alta leads to a less favourable situation in terms of patellofemoral contact force, contact area and contact pressure than the normal patellar position, and thereby gives rise to anterior knee pain.A dynamic knee simulator system based on the Oxford rig and allowing six degrees of freedom was adapted in order to simulate and record the dynamic loads during a knee squat from 30° to 120° flexion under physiological conditions. Five different configurations were studied, with variable predetermined patellar heights.The patellofemoral contact force increased with increasing knee flexion until contact occurred between the quadriceps tendon and the femoral trochlea, inducing load sharing. Patella alta caused a delay of this contact until deeper flexion. As a consequence, the maximal patellofemoral contact force and contact pressure increased significantly with increasing patellar height (p < 0.01). Patella alta was associated with the highest maximal patellofemoral contact force and contact pressure. When averaged across all flexion angles, a normal patellar position was associated with the lowest contact pressures.Our results indicate that there is a biomechanical reason for anterior knee pain in patients with patella alta.Anterior knee pain may be present in as many as 30% of physically active individuals.

Several surgical techniques to treat thumb basal joint arthritis have been described. In this study we compared the results of a cemented thumb basal joint with trapeziectomy with a ligament reconstruction and tendon interposition. A questionnaire was sent to all 519 patients, 322 (with 382 procedures) responded. No significant differences were found when comparing impairment, pain, patient satisfaction and disability. Given the fact that the superiority of a prosthesis cannot be proven and the cost of the implant is greater, we recommend the trapeziectomy with ligament reconstruction and tendon interposition as opposed to arthroplasty as the first choice in the treatment of basal joint osteoarthritis of the thumb.

The biomechanics of the patellofemoral joint can become disturbed during total knee replacement by alterations induced by the position and shape of the different prosthetic components. The role of the patella and femoral trochlea has been well studied. We have examined the effect of anterior or posterior positioning of the tibial component on the mechanisms of patellofemoral contact in total knee replacement. The hypothesis was that placing the tibial component more posteriorly would reduce patellofemoral contact stress while providing a more efficient lever arm during extension of the knee. We studied five different positions of the tibial component using a six degrees of freedom dynamic knee simulator system based on the Oxford rig, while simulating an active knee squat under physiological loading conditions. The patellofemoral contact force decreased at a mean of 2.2% for every millimetre of posterior translation of the tibial component. Anterior positions of the tibial component were associated with elevation of the patellofemoral joint pressure, which was particularly marked in flexion > 90°. From our results we believe that more posterior positioning of the tibial component in total knee replacement would be beneficial to the patellofemoral joint.

No abstract

No abstract

Gastrointestinal tract duplications are uncommon congenital abnormalities, that may occur anywhere along the alimentary tract. Most frequently they occur at the level of the small bowel tract and are symptomatic before the age of two. In our case we report the history of a 68-years old women with a colon duplication, especially a rectal duplication. This is very exceptional.

No abstract