The aim of this paper is to report on the use of Microcontact Printing (μCP) for the manufacturing of 3D Molded Interconnects Devices. Two different approaches are reported. A first one is based on the total metallization of the polymer, μCP of the 3D pattern followed by the wet etching of the non-protected areas of the part (the so-called indirect process). A second approach is based on the combination of radio-frequency (RF) plasma treatment, μCP of a pattern of catalysts on the polymer and metallization by electroless deposition (the so-called direct process). This second process allows metallization of bare polymer parts (free of catalytic species in the bulk) with conductive 3D networks ready for the assembly of SMD devices. Examples of MID devices made with both approaches are reported. Key points like thickness (up to 12-15 μm), conductivity and adhesion of the metallic network are also reviewed. Printing on slope surfaces is demonstrated. Advantages and drawbacks of both processes are discussed.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.