No abstract

The performance of a traffic system tends to improve as the percentage of connected vehicles (CV) in total flow increases. However, due to low CV penetration in the current vehicle market, improving the traffic signal operation remains a challenging task. In an effort to improve the performance of CV applications at low penetration rates, the authors develop a new method to estimate the speeds and positions of non-connected vehicles (NCV) along a signalized intersection. The algorithm uses CV information and initial speeds and positions of the NCVs from loop detectors and estimates the forward movements of the NCVs using the Gipps’ car-following model. Calibration parameters of the Gipps’ model were determined using a solver optimization tool. The estimation algorithm was applied to a previously developed connected vehicle signal control (CVSC) strategy on two different isolated intersections. Simulations in VISSIM showed the estimation accuracy higher for the intersection with less lanes. Estimation error increased with the decrease in CV penetration and decreased with the decrease in traffic demand. The CVSC strategy with 40% and higher CV penetration (for Intersection 1) and with 20% and higher CV penetration (for Intersection 2) showed better performance in reducing travel time delay and number of stops than the EPICS adaptive control.

The performance of the traffic system can drastically drop when nonrecurrent congestion caused by incidents occurs. Early detection and clearing of traffic incidents will enable the mitigation of the congestion and early restoration of normal traffic conditions. The research in this paper utilized the vehicle information from the recent technological advancement in transportation systems, connected vehicles (CV), and loop-detector information for nonconnected vehicles (NCVs) and developed a novel algorithm to (1) control traffic signals for normal traffic conditions in the absence of incidents, (2) detect traffic incidents using CV/NCV information, and (3) control traffic signals during the occurrence and dissipation of incidents. All the 3 strategies were integrated into one algorithm, which runs as per the real-time traffic conditions, in the presence or absence of incidents. Space-mean speeds of the vehicles on nonincident lanes and throughput maximization criteria were taken as the indicators for the activation of specific signal timings directed at the incident-affected approach. Diverse incident scenarios were tested on a four-legged isolated intersection using the VISSIM simulation tool. Incident detection results showed a higher detection rate and lower mean detection time at higher CV penetration and higher traffic volumes, and at the incident locations nearer to the stop-line. The proposed incident-responsive signal control strategy at 40% and higher CV penetration showed better performance over EPICS adaptive signal control solution, in reducing average travel time delay and the average number of stops per vehicle.