Mesenchymal stem cells (MSCs) and osteoblasts respond to the surface electrical charge and topography of biomaterials. This work focuses on the connection between the roughness of calcium phosphate (CP) surfaces and their electrical potential (EP) at the micro- and nanoscales and the possible role of these parameters in jointly affecting human MSC osteogenic differentiation and maturation in vitro. A microarc CP coating was deposited on titanium substrates and characterized at the micro- and nanoscale. Human adult adipose-derived MSCs (hAMSCs) or prenatal stromal cells from the human lung (HLPSCs) were cultured on the CP surface to estimate MSC behavior. The roughness, nonuniform charge polarity, and EP of CP microarc coatings on a titanium substrate were shown to affect the osteogenic differentiation and maturation of hAMSCs and HLPSCs in vitro. The surface EP induced by the negative charge increased with increasing surface roughness at the microscale. The surface relief at the nanoscale had an impact on the sign of the EP. Negative electrical charges were mainly located within the micro- and nanosockets of the coating surface, whereas positive charges were detected predominantly at the nanorelief peaks. HLPSCs located in the sockets of the CP surface expressed the osteoblastic markers osteocalcin and alkaline phosphatase. The CP multilevel topography induced charge polarity and an EP and overall promoted the osteoblast phenotype of HLPSCs. The negative sign of the EP and its magnitude at the micro- and nanosockets might be sensitive factors that can trigger osteoblastic differentiation and maturation of human stromal cells.

No abstract

Investigation results of micro-arc wollastonite–calcium phosphate (W–CaP) biocoatings on the pure titanium (Ti) and Zr–1wt.%Nb (Zr–1Nb) alloy were presented. The voltages of 150–300 V generate the micro-arc oxidation (MAO) process with the initial amplitude current of 150–550 A and 100–350 A for Ti and Zr–1Nb substrates, respectively. The identical dependencies of changes of the coating thickness, surface roughness and adhesion strength on the process voltage were revealed for the both substrates. The W–CaP coatings with the thickness of 10–11 μm were formed on Ti and Zr–1Nb under the low process voltage of 130–150 V. Elongated wollastonite particles with the size in the range of 40–100 μm were observed in such coatings. The structure of the coatings on Ti was presented by the X–ray amorphous and crystalline phases. The X–ray reflexes relating to the crystalline phases of Ti and wollastonite were observed only in XRD patterns of the coatings deposited under 130–200 V on Ti. While, the crystalline structure with phases of CaZr4(PO4)6, β–ZrP2O7, ZrO2, and Zr was detected in the coatings on Zr–1Nb. FT–IRS, XRD, SEM, and TEM data confirmed that the increase of the process voltage to 300 V leads to the dissociation of the wollastonite. No toxic effect of specimens on a viability, morphology and motility of human adipose–derived multipotent mesenchymal stem cells was revealed in vitro.

The Cell-IQ continuous surveillance system allowed us to establish the following changes in a 14- day culture in vitro: a twofold suppression of the directional migration of multipotent mesenchymal stromal cells of human adipose tissue (MMSC-AT) towards the samples with a microarc calcium phosphate (CP) coating from synthetic hydroxyapatite; a tenfold decrease in the cell mass on the interphase with the samples, which was accompanied by a slight reduction in the expression of membrane determinants of stromal stem cells; and an enhancement of their osteogenic differentiation (osteocalcin secretion and mineralized matrix formation) on the 21st day of the study. Calcium phosphate particles, but not the calcium and phosphorus ions, may trigger the phenotypic transformation of the MMSC-AT behavior in vitro.

No abstract

This work describes the wettability and biological performance of Zn- and Cu-containing CaP-based coatings prepared by micro-arc oxidation on pure titanium (Ti) and novel Ti-40Nb alloy. Good hydrophilic properties of all the coatings were demonstrated by the low contact angles with liquids, not exceeding 45°. An increase in the applied voltage led to an increase of the coating roughness and porosity, thereby reducing the contact angles to 6° with water and to 17° with glycerol. The free surface energy of 75 ± 3 mJ/m2 for all the coatings were determined. Polar component was calculated as the main component of surface energy, caused by the presence of strong polar PO43− and OH− bonds. In vitro studies showed that low Cu and Zn amounts (~0.4 at.%) in the coatings promoted high motility of human adipose-derived multipotent mesenchymal stromal cells (hAMMSC) on the implant/cell interface and subsequent cell ability to differentiate into osteoblasts. In vivo study demonstrated 100% ectopic bone formation only on the surface of the CaP coating on Ti. The Zn- and Cu-containing CaP coatings on both substrates and the CaP coating on the Ti-40Nb alloy slightly decreased the incidence of ectopic osteogenesis down to 67%. The MAO coatings showed antibacterial efficacy against Staphylococcus aureus and can be arranged as follows: Zn-CaP/Ti > Cu-CaP/TiNb, Zn-CaP/TiNb > Cu-CaP/Ti.

Introduction. The adult neural crest-derived stem cells (NCSCs) have significant perspectives for use in regenerative medicine. The most attractive sources for adult NCSC isolation are the hair follicles (HF) and skin dermis (SD) because of easy access and minimally invasive biopsy. The aim of this study was to compare the biological properties of HF- and SD-derived NCSCs after their large-scale expansion. Methods. The conventional explant method was used to obtain HF NCSCs. For the isolation of SD NCSCs, a new combined technique consisting of preplating and subsequent culturing in 3D blood plasma-derived fibrin hydrogel was applied. The studied cells were characterized by flow cytometry, ICC, qPCR, Bio-Plex multiplex assay, and directed multilineage differentiation assays. Results. We have obtained both adult SD and HF NCSCs from each skin sample (n=5). Adult SD and HF NCSCs were positive for key neural crest markers: SOX10, P75 (CD271), NESTIN, SOX2, and CD349. SD NCSCs showed a higher growth rate during the large-scale expansion compared to HF NCSCs (p<0.01). Final population of SD NCSCs also contained more clonogenic cells (p<0.01) and SOX10+, CD271+, CD105+, CD140a+, CD146+, CD349+ cells (p<0.01). Both HF and SD NCSCs had similar gene expression profiling and produced growth factors, but some quantitative differences were detected. Adult HF and SD NCSCs were able to undergo directed differentiation into neurons, Schwann cells, adipocytes, and osteoblasts. Conclusion. The HF and SD are suitable sources for large-scale manufacturing of adult NCSCs with similar biological properties. We demonstrated that the NCSC population from SD was homogenous and displayed significantly higher growth rate than HF NCSCs. Moreover, SD NCSC isolation is cheaper, easier, and minimally time-consuming method.

We speculated our definition of the stem cell niche, proposed and described certain stages (postulation; morphofunctional; topographical; quantitative; bioengineering) of the niche theory development. Prospective directions of the niche designing for cell-based diagnostics and regenerative medicine were noted.