We report on the enhanced thermoelectric properties of selenium (Se) doped bismuth telluride (Bi(2)Te(3-x)Se(x)) nanoplatelet (NP) composites synthesized by the polyol method. Variation of the Se composition within NPs is demonstrated by X-ray diffraction and Raman spectroscopy. While the calculated lattice parameters closely follow the Vegard's law, a discontinuity in the shifting of the high frequency (E(g)(2) and A(1g)(2)) phonon modes illustrates a two mode behavior for Bi(2)Te(3-x)Se(x) NPs. The electrical resistivity (ρ) of spark plasma sintered pellet composites shows metallic conduction for pure Bi(2)Te(3) NP composites and semiconducting behavior for intermediate Se compositions. The thermal conductivity (κ) for all NP composites is much smaller than the bulk values and is dominated by microstructural grain boundary scattering. With temperature dependent electrical and thermal transport measurements, we show that both the thermoelectric power S (-259 μV/K) and the figure of merit ZT (0.54) are enhanced by nearly a factor of 4 for SPS pellets of Bi(2)Te(2.7)Se(0.3) in comparison to Bi(2)Te(3) NP composites. Tentatively, such an enhancement of the thermoelectric performance in nanoplatelet composites is attributed to the energy filtering of low energy electrons by abundant grain boundaries in aligned nanocomposites.
Hydroxyapatite (HA) is synthesized by a wet chemical route using calcium hydroxide and ortho-phosphoric acid at various temperatures (40, 80, and 100 degrees C). X-ray diffraction of the precipitate particles revealed HA as the predominant phase (>99%) with a small amount of beta-tricalcium phosphate. Fourier transform infrared spectroscopy indicated the presence of carbonate substitution, which decreased with increasing temperature. Transmission electron microscopy observations revealed needle-shaped particles with a high aspect ratio at 40 degrees C, which changed to spheroidal when the precipitation temperature was increased to 100 degrees C. The changes in the morphology with temperature were analyzed taking into account the driving force for the HA precipitation and the supersaturation level of Ca2+ and PO4(3-) ions with respect to HA. The analysis indicated that the supersaturation level of the reactants, especially the concentration of Ca2+ ions, played a predominant role on the precipitate morphology for this classical acid-base reaction.
Control of competing parameters such as thermoelectric (TE) power and electrical and thermal conductivities is essential for the high performance of thermoelectric materials. Bulk-nanocomposite materials have shown a promising improvement in the TE performance due to poor thermal conductivity and charge carrier filtering by interfaces and grain boundaries. Consequently, it has become pressingly important to understand the formation mechanisms, stability of interfaces and grain boundaries along with subsequent effects on the physical properties. We report here the effects of the thermodynamic environment during spark plasma sintering (SPS) on the TE performance of bulk-nanocomposites of chemically synthesized Bi(2)Te(2.7)Se(0.3) nanoplatelets. Four pellets of nanoplatelets powder synthesized in the same batch have been made by SPS at different temperatures of 230, 250, 280, and 350 °C. The X-ray diffraction, transmission electron microscopy, thermoelectric, and thermal transport measurements illustrate that the pellet sintered at 250 °C shows a minimum grain growth and an optimal number of interfaces for efficient TE figure of merit, ZT∼0.55. For the high temperature (350 °C) pelletized nanoplatelet composites, the concurrent rise in electrical and thermal conductivities with a deleterious decrease in thermoelectric power have been observed, which results because of the grain growth and rearrangements of the interfaces and grain boundaries. Cross section electron microscopy investigations indeed show significant grain growth. Our study highlights an optimized temperature range for the pelletization of the nanoplatelet composites for TE applications. The results provide a subtle understanding of the grain growth mechanism and the filtering of low energy electrons and phonons with thermoelectric interfaces.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.