A novel method for detecting F(1)-ATPase rotation in a manner sufficiently sensitive to achieve acquisition rates with a time resolution of 2.5 micros (equivalent to 400,000 fps) is reported. This is sufficient for resolving the rate at which the gamma-subunit travels from one dwell state to another (transition time). Rotation is detected via a gold nanorod attached to the rotating gamma-subunit of an immobilized F(1)-ATPase. Variations in scattered light intensity allow precise measurement of changes in the angular position of the rod below the diffraction limit of light. Using this approach, the transition time of Escherichia coli F(1)-ATPase gamma-subunit rotation was determined to be 7.62 +/- 0.15 (standard deviation) rad/ms. The average rate-limiting dwell time between rotation events observed at the saturating substrate concentration was 8.03 ms, comparable to the observed Mg(2+)-ATPase k(cat) of 130 s(-)(1) (7.7 ms). Histograms of scattered light intensity from ATP-dependent nanorod rotation as a function of polarization angle allowed the determination of the nanorod orientation with respect to the axis of rotation and plane of polarization. This information allowed the drag coefficient to be determined, which implied that the instantaneous torque generated by F(1) was 63.3 +/- 2.9 pN nm. The high temporal resolution of rotation allowed the measurement of the instantaneous torque of F(1), resulting in direct implications for its rotational mechanism.

We report the construction of a novel biosensing nanodevice to detect single, sequence-specific target DNA molecules. Nanodevice assembly occurs through the association of an immobilized F1-ATPase molecular motor and a functionalized gold nanorod via a single 3 ,5 -dibiotinylated DNA molecule. Target-dependent 3 ,5 -dibiotinylated DNA bridges form by combining ligation and exonucleation reactions (LXR), with a specificity capable of selecting against a single nucleotide polymorphism (SNP). Using dark field microscopy to detect gold nanorods, quantitation of assembled nanodevices is sufficient to distinguish the presence of as few as 1800 DNA bridges from nonspecifically bound nanorods. The rotary mechanism of F1-ATPase can drive gold nanorod rotation when the nanorod is attached via the DNA bridge. Therefore, rotation discriminates fully assembled devices from nonspecifically bound nanorods, resulting in a sensitivity limit of one zeptomole (600 molecules).

The integration of microfluidic devices with single molecule motor detection techniques allows chip based devices to reach sensitivity levels previously unattainable.

The abundance of E. coli F1-ATPase molecules observed to rotate using gold nanorods attached to the gamma-subunit was quantitated. Individual F1 molecules were determined to be rotating based upon time dependent fluctuations of red and green light scattered from the nanorods when viewed through a polarizing filter. The average number of F1 molecules observed to rotate in the presence of GTP, ATP, and without nucleotide was approximately 50, approximately 25, and approximately 4% respectively. In some experiments, the fraction of molecules observed to rotate in the presence of GTP was as high as 65%. These data indicate that rotational measurements made using gold nanorods provide information of the F1-ATPase mechanism that is representative of the characteristics of the enzyme population as a whole.

No abstract