No abstract

Graphene has demonstrated great promise for technological use, yet control over material growth and understanding of how material imperfections affect the performance of devices are challenges that hamper the development of applications. In this work, we reveal new insight into the connections between the performance of the graphene devices as environmental sensors and the microscopic details of the interactions at the sensing surface. We monitor changes in the resistance of the chemical-vapor deposition grown graphene devices as exposed to different concentrations of ethanol. We perform thermal surface treatments after the devices are fabricated, use scanning probe microscopy to visualize their effects down to nanometer scale and correlate them with the measured performance of the device as an ethanol sensor. Our observations are compared to theoretical calculations of charge transfers between molecules and the graphene surface. We find that, although often overlooked, the surface cleanliness after device fabrication is responsible for the device performance and reliability. These results further our understanding of the mechanisms of sensing in graphene-based environmental sensors and pave the way to optimizing such devices, especially for their miniaturization, as with decreasing size of the active zone the potential role of contaminants will rise.

Fabrication of custom-built heterostructures based on stacked 2D materials provides an effective method to controllably tune electronic and optical properties. To that end, optimizing fabrication techniques for building these heterostructures is imperative. A common challenge in layer-by-layer assembly of 2D materials is the formation of bubbles at atomically thin interfaces. We propose a technique for addressing this issue by removing the bubbles formed at the heterostructure interface in a custom-defined area using the heat generated by a laser equipped with raster scanning capabilities. We demonstrate that the density of bubbles formed at graphene-ReS2 interfaces can be controllably reduced using this method. We discuss an understanding of the flattening mechanism by considering the interplay of interface thermal conductivities and adhesion energies between two atomically thin 2D materials.

Quantum confinement and manipulation of charge carriers are critical for achieving devices practical for quantum technologies. The interplay between electron spin and valley, as well as the possibility to address their quantum states electrically and optically, makes two-dimensional (2D) transition metal dichalcogenides an emerging platform for the development of quantum devices. In this work, we fabricate devices based on heterostructures of layered 2D materials, in which we realize gate-controlled tungsten diselenide (WSe2) hole quantum dots. We discuss the observed mesoscopic transport features related to the emergence of quantum dots in the WSe2 device channel, and we compare them to a theoretical model.

Atomic scale defects in semiconductors enable their technological applications and realization of novel quantum states. Using scanning tunneling microscopy and spectroscopy complemented by ab-initio calculations we determine the nature of defects in the anisotropic van der Waals layered semiconductor ReS2.We demonstrate the in-plane anisotropy of the lattice by directly visualizing chains of rhenium atoms forming diamond-shaped clusters. Using scanning tunneling spectroscopy we measure the semiconducting gap in the density of states. We reveal the presence of lattice defects and by comparison of their topographic and spectroscopic signatures with ab initio calculations we determine their origin as oxygen atoms absorbed at lattice point defect sites.These results provide an atomic-scale view into the semiconducting transition metal dichalcogenides, paving the way toward understanding and engineering their properties.