Series connection of four quantum Hall effect (QHE) devices based on epitaxial graphene films was studied for realization of a quantum resistance standard with an up-scaled value. The tested devices showed quantum Hall plateaux R H,2 at filling factor ν = 2 starting from relatively low magnetic field (between 4 T and 5 T) when temperature was 1.5 K. Precision measurements of quantized Hall resistance of four QHE devices connected by triple series connections and external bonding wires were done at B = 7 T and T = 1.5 K using a commercial precision resistance bridge with 50 μA current through the QHE device.The results showed that the deviation of the quantized Hall resistance of the series connection of four graphene-based QHE devices from the expected value of 4×R H,2 = 2h/e 2 was smaller than the relative standard uncertainty of the measurement (< 1×10 -7 ) limited by the used resistance bridge.
Abstract. Graphene is the promising material for the gas sensing application. High sensitivity to the nitrogen dioxide and ozone allows application of the simple graphene based devices for the environmental monitoring. The aims of the work were the fabrication of reliable graphene devices and the comparison of epitaxial and CVD-based graphene sensors for their sensing abilities. In order to increase sensitivity and reliability of graphene sensors the optimization of fabrication technology as well as operation parameters was done. Results demonstrated ultra high sensitivity of the fabricated epitaxial sensors upon exposure to NO 2 and ozone gases.
Accurate and reliable dynamic pressure measurements are needed for optimizing performance in modern combustion engines, manufacturing processes and aerospace applications. Besides fast pressure transients, these applications subject dynamic pressure transducers to elevated temperatures. Both of these quantities effect the sensitivity of transducers. Therefore, transducers should be calibrated at conditions that corresponds to the operating environment. To answer these needs, the National Metrology Institute VTT MIKES has developed its drop weight dynamic pressure primary standard further. Developments include improved control and measurement of the falling weight, extension of the pressure range to combustion engine pressures down to 3 MPa and a heating option for dynamic pressure transducers under calibration. These advances enable traceable calibration of cylinder pressure transducers at conditions relevant to engine applications. The overall uncertainty (k = 2) of calibration is estimated to be around 1.7%. The performance was demonstrated by calibrating a piezoelectric pressure transducer in the pressure and temperature range from 7 MPa to 30 MPa in 20 °C, 120 °C and 180 °C, respectively. As a result, traceable calibrations of dynamic pressure transducers can be performed at conditions relevant for engine applications. This improves the reliability and accuracy of in-cylinder pressure measurements.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.