Radiographic enlargement of bone tunnels following anterior cruciate ligament (ACL) reconstruction has been recently introduced in the literature; however, the etiology and clinical relevance of this phenomenon remain unclear. While early reports suggested that bone tunnel enlargement is mainly the result of an immune response to allograft tissue, more recent studies imply that other biological as well as mechanical factors play a more important role. Biological factors associated with tunnel enlargement include foreign-body immune response (against allografts), non-specific inflammatory response (as in osteolysis around total joint implants), cell necrosis due to toxic products in the tunnel (ethylene oxide, metal), and heat necrosis as a response to drilling (natural course). Mechanical factors contributing to tunnel enlargement include stress deprivation of bone within the tunnel wall, graft-tunnel motion, improper tunnel placement, and aggressive rehabilitation. Graft-tunnel motion refers to longitudinal and transverse motion of the graft within the bone tunnel and can occur with various graft types and fixation techniques. Aggressive rehabilitation programmes may contribute to tunnel enlargement as the graft-bone interface is subjected to early stress before biological incorporation is complete. Further basic research is required to verify the effect of the various proposed factors on the etiology of bone tunnel enlargement. We recommend that routine follow-up examinations after ACL reconstruction should include the measurement of bone tunnel size in order to contribute to a better understanding of the incidence, time course, and clinical relevance of this phenomenon. Improved and more anatomical surgical fixation techniques may be useful for the prevention of bone tunnel enlargement.

The results highlight the important role of KS on the interaction between trunk angle, joint kinetics, and postural dynamic stability during landing and show that ACL-reconstructed patients use an analogous feedforward strategy (e.g., more flexed trunk) to that used in their ACL-deficient state, aiming to compensate for KS deficits and thereby sacrificing postural dynamic stability and increasing the risk of loss of balance during landing maneuvers.

The objective of this study was to determine the relative motion of a quadruple hamstring graft within the femoral bone tunnel (graft-tunnel motion) under tensile loading. Six graft constructs were prepared from the semitendinosus and gracilis tendons of human cadavers and were fixed with a titanium button and polyester tape within a bone tunnel in a cadaveric femur. Three different lengths of polyester tape (15, 25, and 35 mm loops) were evaluated. The femur was held stationary and uniaxial tensile loads were applied to the distal end of the graft using a materials testing machine. Each construct was subjected to loading for ten cycles with upper limits of 50 N, 100 N, 200 N and 300 N. Graft-tunnel motion was then determined using the distances between reflective tape markers placed on the hamstring graft and at the entrance to the femoral bone tunnel, which were tracked with a high-resolution video system. Graft-tunnel motion was found to range from 0.7 +/- 0.2 mm to 3.3 +/- 0.2 mm, and significant increases in graft-tunnel motion were observed with increasing tensile loads (P < 0.05). Shorter tape length (15 mm) resulted in significantly less motion when compared to longer tape length (35 mm) (P < 0.05). We conclude that graft-tunnel motion is significant and should be considered when using this fixation technique. Early stress on the graft, as seen in postoperative rehabilitation exercises and athletic activities, may cause large graft-tunnel motion before graft incorporation is complete. A shorter distance between the tendon tissue and the titanium button is recommended to minimize the amount of graft-tunnel motion. Alternative fixation materials to polyester tape, or different fixation techniques, need to be developed such that graft-tunnel motion can be reduced. Further studies are needed to evaluate the effect of graft-tunnel motion on graft incorporation in the bone tunnel.

Purpose To investigate whether pre-soaking the graft in vancomycin during anterior cruciate ligament reconstruction (ACLR) reduces the postoperative infection rate and if this technique is associated with an increased rate of complications, including graft failure or arthrofibrosis. Methods A retrospective review of a prospective database was performed in 1779 patients who underwent ACLR over a period of 5 years, analysing the rate of postoperative deep knee infection. Group 1 and 2 both received perioperative IV antibiotics, while only group 2 underwent ACLR with grafts pre-soaked in a 5 mg/ml vancomycin solution. To analyse possible side effects associated with vancomycin use, 500 patients out of the overall study population (100 patients per year) were randomly selected and retrospectively interviewed for further postoperative complications including graft failure and arthrofibrosis as well as subjective evaluation of their knee by completing the IKDC form with a minimum mean follow-up of 37 months. Results In group 1, 22 out of 926 (2%) patients suffered a postoperative deep knee infection. In contrast, there were no postoperative infections in the second group of 853 patients (0%). 16 of 22 infections (73%) were caused by coagulase-negative Staphylococcus. Statistical analysis revealed a significantly reduced postoperative infection rate when bathing the autograft in vancomycin (p < 0.01). Analysis of the random sample revealed a significant decrease of graft failure with 8 reruptures in 257 patients (3%) in the vancomycin group compared to 16 cases of graft failure in 167 patients (10%) in the control group (p < 0.05). No differences were found in the rate of postoperative arthrofibrosis, Tegner or subjective outcome scores. Conclusion Prophylactic vancomycin pre-soaking of autografts during ACLR appears to be a viable, cost-effective and safe option to reduce the rate of deep infection compared to systemic antibiotics alone. Level of evidence III.

Several grafts and several fixation techniques have been introduced for PCL reconstruction over the past years. To date, autograft and allograft tissues are recommended for PCL reconstruction, whilst synthetic grafts should be avoided. Autograft tissues include the bone-patellar tendon-bone graft, the hamstrings and the quadriceps tendon. Allograft tissues are increasingly being used for primary PCL reconstruction. The use of allograft tissues requires a number of formal prerequisites to be fulfilled. Besides the previous mentioned graft types allograft tissues include Achilles and tibialis anterior/posterior tendons. To date no superior graft type has been identified. Several techniques and devices have been used for fixation of a PCL replacement graft. Most of these were originally developed for ACL reconstruction and then adapted to PCL reconstruction. However, biomechanical requirements of the PCL differ substantially from those of the ACL. To date, requirements for PCL graft fixations are not known. From a systematic approach femoral graft fixation can either be achieved within the bone tunnel (nearly anatomic) with an interference screw or outside the bone tunnel on the medial femoral condyle using a staple, an endobutton or a screw. Tibial graft fixation can be achieved either with an interference screw in the bone tunnel or with a staple, screw/washer or sutures tied over a bone bridge outside the bone tunnel (extra-anatomic). An alternative fixation on the tibial side is the inlay technique that reduces the acute angulation of the graft at the posterior aspect of the tibia. Further research is necessary to identify the differences between the various fixation techniques.

To investigate the effect of simulated contraction of the popliteus muscle on the in situ forces in the posterior cruciate ligament and on changes in knee kinematics, we studied 10 human cadaveric knees (donor age, 58 to 89 years) using a robotic manipulator/universal force moment sensor system. Under a 110-N posterior tibial load (simulated posterior drawer test), the kinematics of the intact knee and the in situ forces in the ligament were determined. The test was repeated with the addition of a 44-N load to the popliteus muscle. The posterior cruciate ligament was then sectioned and the knee was subjected to the same tests. The additional popliteus muscle load significantly reduced the in situ forces in the ligament by 9% to 36% at 90 degrees and 30 degrees of flexion, respectively. No significant effects on posterior tibial translation of the intact knee were found. However, in the ligament-deficient knee, posterior tibial translation was reduced by up to 36% of the translation caused by ligament transection. A coupled internal tibial rotation of 2 degrees to 4 degrees at 60 degrees to 90 degrees of knee flexion was observed in both the intact and ligament-deficient knees when the popliteus muscle load was added. Our results indicate that the popliteus muscle shares the function of the posterior cruciate ligament in resisting posterior tibial loads and can contribute to knee stability when the ligament is absent.

We compared the mechanical behavior of two common hamstring graft constructs that are frequently used for reconstruction of the anterior cruciate ligament-Graft A: quadrupled semitendinosus tendon fixed with titanium button/polyester tape and suture/screw post, and Graft B: a double semitendinosus and double gracilis tendon fixed with a cross pin and two screws over washers. The experimental protocol used to evaluate each graft construct included stress relaxation (with and without preconditioning), cyclic loading, and a tensile load-to-failure test. The amount of stress relaxation without preconditioning was 60.6% for Graft A and 53.8% for Graft B. With preconditioning, it significantly decreased (p < 0.05) to 48.7 and 42.3%, respectively. Elongation of the graft construct in response to 100 cycles of loading (20-150 N) was 1.8 and 0.6% of the original length for Grafts A and B, respectively. However, after a series of five cyclic loading tests, the residual permanent elongation for each construct was 3.8 +/- 1.2 and 0.3 +/- 0.2 mm, a significant difference (p < 0.05) between the two graft constructs. Further analysis found more than 90% of the permanent elongation in the proximal and distal regions of Graft A, which consisted of polyester tape tied to a titanium button (proximal) and sutures tied around a screw post (distal). The tensile load-to-failure tests also revealed significant differences (p < 0.05) between the two graft constructs. Linear stiffness was 32 +/- 1 and 119 +/- 19 Nmm and ultimate load was 415 +/- 36 and 658 +/- 128 N for Grafts A and B, respectively. For Graft A, the polyester tape consistently failed; for Graft B, slippage or tearing from the washers was the mode of failure. We conclude that a quadruple-hamstring graft fixed over a cross pin proximally and with metal washers distally (Graft B) has less permanent elongation in response to cyclic loading and has structural properties superior to those of a graft construct that includes suture and tape material (Graft A). The large permanent elongation following repetitive loading of a graft construct with tape and suture material during the early postoperative period is of concern.

We hypothesized that posterior cruciate ligament reconstructions are often compromised by associated injuries to the posterolateral structures. Therefore, we evaluated a posterior cruciate ligament reconstruction in isolated and combined injury models using a robotic/universal force-moment sensor testing system. The resulting knee kinematics and the in situ forces in the native and reconstructed posterior cruciate ligament were determined under four external loading conditions. In the isolated injury model, reconstruction reduced posterior tibial translation to within 1.5+/-1.3 to 2.4+/-1.4 mm of the intact knee at 30 degrees and 90 degrees under a 134-N posterior tibial load. In the combined injury model, deficiency of the posterolateral structures increased posterior tibial translation of the reconstructed knee by 6.0+/-2.7 mm at 30 degrees and 4.6+/-1.5 mm at 90 degrees of flexion. External rotation increased up to 14 degrees while varus rotation increased up to 7 degrees. In situ forces in the posterior cruciate ligament graft also increased significantly (by 22% to 150%) for all loading conditions. Our results demonstrate that a graft that restores knee kinematics for an isolated posterior cruciate ligament deficiency is rendered ineffective and may be overloaded if the posterolateral structures are deficient. Therefore, surgical reconstruction of both structures is recommended in the setting of a combined injury.