Using “3D-spacer” technology, we have knitted 80% β-phase PVDF with Ag/PA66 fibres to demonstrate all fibre piezoelectric power generators. The 3D structure provides a power density of 1.10–5.10 μW cm−2 at applied impacts of 0.02–0.10 MPa.

Exceptionally long C60 nanowires, with a length to width aspect ratio as large as 3000, are grown from a 1,2,4-trimethylbenzene solution of C60. They have been formed to possess a highly unusual morphology, with each nanowire being composed of two nanobelts joined along the growth direction to give a V-shaped cross section. The crystal structure of these nanowires is found to be orthorhombic, with the unit cell dimensions of a = 10.2 A, b = 20.5 A, and c = 25.6 A. Structural and compositional analyses enable us to explain the observed geometry with an anisotropic molecular packing mechanism that has not been observed previously in C60 crystal studies. The nanowires have been observed to be able to transform into carbon nanofibers following high-temperature treatment, but the original V-shaped morphology can be kept unchanged in the transition. A model for the nanowire morphology based upon the solvent-C60 interactions and preferential growth directions is proposed, and potentially it could be extended for use to grow different types of fullerene nanowires.

Silicon nanowires were selectively grown at temperatures below 400 °C by plasma enhanced chemical vapor deposition using silane as the Si source and gold as the catalyst. A detailed growth study is presented using electron microscopy, focused ion beam preparation, and Raman spectroscopy. A radio-frequency plasma significantly increased the growth rate. The Si nanowires show an uncontaminated, crystalline silicon core surrounded by a 2-nm-thick oxide sheath. The as-grown diameters are small enough for the observation of quantum confinement effects. Plasma activation could allow a further decrease in deposition temperature. A growth model for plasma enhanced nanowire growth is discussed.

Flexible electronics are a very promising technology for various applications. Several types of flexible devices have been developed, but there has been limited research on flexible electromechanical systems (MEMS). Surface acoustic wave (SAW) devices are not only an essential electronic device, but also are the building blocks for sensors and MEMS. Here we report a method of making flexible SAW devices using ZnO nanocrystals deposited on a cheap and bendable plastic film. The flexible SAW devices exhibit two wave modes - the Rayleigh and Lamb waves with resonant frequencies of 198.1 MHz and 447.0 MHz respectively, and signal amplitudes of 18 dB. The flexible devices have a high temperature coefficient of frequency, and are thus useful as sensitive temperature sensors. Moreover, strong acoustic streaming with a velocity of 3.4 cm/s and particle concentration using the SAW have been achieved, demonstrating the great potential for applications in electronics and MEMS.

The preparation of nitrogenated carbon nanotubes (N-CNT) using pyridine as a carbon precursor resulted in an eight-times increase in gravimetric capacitance.

A highly unusual nanostructure of the nickel-boron particulate material, initially synthesised in the 1950s and well known to be an exceedingly active hydrogenation catalyst, has been identified for the first time.

No abstract

We report a direct salt-conversion approach for large-scale synthesis of carbon-encapsulated magnetic Fe and Fe3C nanoparticles.