No abstract

Capacitive deionization (CDI) has recently gained some degree of popularity as a water treatment technology. This paper demonstrates the benefits of coating low surface area carbon electrodes with a sub-micron nanoporous layer of either γ-Al2O3 or SiO2. As shown by cyclic voltammetry, the oxide layer, having pores sizes ranging from larger micro to meso, substantially increased capacitance for ion removal while still maintaining reasonably high ohmic conductivity. The amount of Ca2+ removed in a CDI cell comprised of a SiO2 coated carbon as the negative and γ-Al2O3 carbon as the positive electrode was nearly five times higher than a cell with uncoated electrodes. Removal of Ca2+ followed pseudo first order kinetics, while Cl- removal was better described by a first order kinetic equation. The highest value for Ca2+ adsorption measured was 0.17 mEq/g of electrode material. This compares favorably with previously reported literature values obtained with high surface area carbons. The removal of Ca2+ and Cl− proved to be asymmetric (mEq Ca2+ > mEq Cl− removed). Consequently, to maintain electroneutrality, pH decreased during the removal process. Furthermore, some of the asymmetry was found to be due to a parasitic reaction, that of Cl− ions being oxidized to ClO3−.

Capacitive deionization (CDI) is a rapidly emerging desalination technology that promises to deliver clean water while storing energy in the electrical double layer (EDL) near a charged surface in a capacitive format. Whereas most research in this subject area has been devoted to using CDI for removing salts, little attention has been paid to the energy storage aspect of the technology. However, it is energy storage that would allow this technology to compete with other desalination processes if this energy could be stored and reused efficiently. This requires that the operational aspects of CDI be optimized with respect to energy used both during the removal of ions as well as during the regeneration cycle. This translates into the fact that currents applied during deionization (charging the EDL) will be different from those used in regeneration (discharge). This paper provides a mechanistic analysis of CDI in terms of energy consumption and energy efficiencies during the charging and discharging of the system under several scenarios. In a previous study, we proposed an operational buffer mode in which an effective separation of deionization and regeneration steps would allow one to better define the energy balance of this CDI process. This paper reports on using this concept, for optimizing energy efficiency, as well as to improve upon the electro-adsorption of ions and system lifetime. Results obtained indicate that real-world operational modes of running CDI systems promote the development of new and unexpected behavior not previously found, mainly associated with the inhomogeneous distribution of ions across the structure of the electrodes.

Activated carbons prepared using polyaniline (PAni), a N-containing precursor, doped with different anions were successfully employed in this work as electrode materials for capacitive deionization. The aim of this research was to investigate the effect of chloride (Cl À ), p-toluenesulfonate (PTS À ), dodecylbenze-sulfonate (DBS À ) and polystirenesulfonate (PSS À ) as PAni dopants on the textural and electrochemical properties of PAni activate carbon (PAC) and evaluate their performance for desalination. It was demonstrated that textural PAC properties such as microporosity could be properly tuned, resulting in a suitable proportion of micro-and mesoporosity by using different doping anions. Furthermore, it was observed that the higher the oxygen content the higher the electrode hidrophilicity due to introduction of surface polar groups, as identified by XPS. These groups were found to be the most important variable influencing on the PAC electrosorption capacity and energy efficiency. The highest specific adsorption capacity (14.9 mg g À1 ), along with the lowest specific energy consumption, was obtained using the PTS-doped PAC electrode. Considering its high capacity, low-cost and ease of synthesis, PAC/PTS seems to be a promising electrode for CDI.