Tailoring the characteristics of gating transitions in the porous network, Ni(ndc)dabco (ndc = 2,6-naphthalenedicarboxylate, dabco = 1,4-diazabicyclo[2.2.2]octane), also termed DUT-8(Ni) (DUT = Dresden University of Technology), was achieved by systematically adjusting the critical synthesis parameters. The impact of the starting composition and solvent mixtures in the synthesis was found to critically affect the guest-response properties of the obtained materials. A comprehensive set of physical characterization methods, namely thermal analysis, H NMR of digested crystals, solid stateC NMR, PXRD, SEM, IR and Raman spectroscopy shows that the crystallite size is a crucial factor, determining the differing characteristics such as "gate pressure" and adsorption capacity in the guest-responsive switching behaviour of DUT-8. Crystallites smaller than 500 nm in size retain the open form after removal of the guest molecules resulting in typical "Type Ia" isotherm, whereas crystallites larger than 1 μm transform into the "closed pore" form and therefore can show a characteristic "gate opening" behaviour during gas adsorption. The particle size distribution of DUT-8(Ni) can be tailored by changing the synthesis conditions and consequently the slope of the isotherm at the "gating step" is affected. The in depth analysis of synthesis conditions and switching behaviour is an important step towards a better understanding of the fundamental principles responsible for guest responsive porosity switching in the solid state.

A convenient approach for a controlled and high-yield synthesis of copper-deficient Cu 3−x P (0.1 < x < 0.7) is reported that makes use of ionic liquids with highly nucleophilic "naked" halide anions. Halide anions drastically enhance the reactivity of the white phosphorus precursor and kinetically disfavour the formation of phosphorus-rich side products. Cu 3−x P shows a high degree of tolerance for cation vacancies without mayor structural reorganisation, as evidenced by X-ray diffraction and solid-state nuclear magnetic resonance spectroscopy. Measurements of the electric properties reveal that Cu 3−x P is a bad metallic p-type conductor. The resistivity is composition-dependent and displays a distinct anomaly from a phase transition, leading to the discovery and structural characterisation of two hitherto unknown low temperature polymorphs. Electrochemical evaluation of copper-deficient Cu 3−x P as anode material for lithium ion batteries reveals a drastic change in the cycling mechanism leading to an increase of the initial capacities by about 70 %. This work gives a comprehensive insight into the chemical and structural features of copper-deficient Cu 3−x P and should lead to an improved understanding of its properties, not only for battery applications.

Metal–organic frameworks are promising candidates for selective separation processes such as CO2 removal from methane (natural gas sweetening). Framework flexibility, that is, the ability of a MOF lattice to change its structure as a function of parameters like pressure, temperature, and type of adsorbed molecules, is only observed for some special compounds. The main question of our present work is: does framework flexibility influence the adsorption selectivity? As a direct quantitative method to monitor the adsorption of both, carbon dioxide and methane, we make use of high-pressure in situ 13C NMR spectroscopy of 13CO2/13CH4 gas mixtures. This method allows to distinguish between the two gases as well as between adsorbed molecules and the interparticle gas phase. Gas mixture adsorption is studied under isothermal conditions. The selectivity factor for CO2 adsorption from CO2/CH4 mixtures is measured as a function of total gas pressure. The flexible material SNU-9 as well as the flexible and the nonflexible variant of DUT-8­(Ni) are compared. Maximum selectivity factors for CO2 are observed for the flexible variant of DUT-8­(Ni) in its open, large-pore state. In contrast, the rigid variant of DUT-8­(Ni) and SNU-9 especially in its intermediate state exhibits lower adsorption selectivity factors. This observation indicates significant influence of the framework elasticity on the adsorption selectivity.

No abstract

Polycrystalline Cu3-xP was successfully synthesized in different ionic liquids comprising imidazolium and phosphonium cations. The reaction of elemental copper and red phosphorus in trihexyltetradecylphosphonium chloride at 200 °C led to single-phase Cu3-xP (x = 0.05) within 24 h with a quantitative yield (99%). Liquid-state nuclear magnetic resonance spectroscopy of the ionic liquids revealed degeneration of the imidazolium cations under the synthesis conditions, while phosphonium cations remain stable. The solid products were characterized with X-ray powder diffraction, scanning electron microscopy, energy-dispersive X-ray spectroscopy, solid-state nuclear magnetic resonance spectroscopy, and elemental analysis. A reinvestigation of the electronic transport properties of Cu2.95(4)P showed metallic behavior for the bulk material. The formation of CuP2 during the synthesis of phosphorus-rich Cu3-xP (x ≥ 0.1) was observed.