In this work a study on the feasibility of extracting cellulose from sisal fiber, by means of two different procedures was carried out. These processes included usual chemical procedures such as acid hydrolysis, chlorination, alkaline extraction, and bleaching. The final products were characterized by means of Thermogravimetric Analysis (TGA), Infrared Spectroscopy (FTIR), X-Ray Diffraction (XRD), Differential Scanning Calorimetry (DSC) and Scanning Electronic Microscopy (SEM). The extraction procedures that were used led to purified cellulose. Advantages and disadvantages of both procedures were also analyzed. Finally, nanocellulose was produced by the acid hydrolysis of obtained cellulose and characterized by Atomic Force Microscopy (AFM).

Although good progress was made by two international benchmark exercises on in-plane permeability, existing methods have not yet been standardized. This paper presents the results of a third benchmark exercise using in-plane permeability measurement, based on systems applying the radial unsaturated injection method. 19 participants using 20 systems characterized a non-crimp and a woven fabric at three different fiber volume contents, using a commercially available silicone oil as impregnating fluid. They followed a detailed characterization procedure and also completed a questionnaire on their setup and analysis methods. Excluding outliers (2 of 20), the average coefficient of variation (c v) between the participant's results was 32% and 44% (non-crimp and woven fabric), while the average c v for individual participants was 8% and 12%, respectively. This indicates statistically significant variations between the measurement systems. Cavity deformation was identified as a major influence, besides fluid pressure/viscosity measurement, textile variations, and data analysis.

The influence of multiple extrusion cycles on the behavior of natural fibers-reinforced polypropylene was studied. Composites were fabricated with 20 wt % of flax fibers. Final fibers dimensions (length and diameter) were measured by means of optical microscopy. Mechanical properties of matrix and composites were measured after each extrusion cycle. It was observed that the elastic modulus increased by fibers incorporation. The elastic modulus of the matrix was higher after the first process cycle than that of the virgin material, mainly because of chain scission. In the next cycles, the modulus kept constant. On the other hand the elastic modulus of the composite after a single extrusion step was lower than that predicted by the Halpin-Tsai model probably because of a poor mixing and to low adhesion at the fiber-matrix interface. In the following two steps, modulus increased because the better fiber dispersion was observed. For the final two extrusion cycles, the slow decrease in this property was correlated with the darkening and poor organoleptic properties observed as a result of thermal degradation.