The production of biogas in landfills, its composition and the problems resulting from its generation are all reviewed. Biofiltration is a promising option for the control of emissions to atmosphere of the methane contained in biogas issued from the smaller and/or older landfills. A detailed review of the methane biofiltration literature is presented. The microorganisms, mainly the methanotrophs, involved in the methane biodegradation process, and their needs in terms of oxygen and carbon dioxide utilization, are described. Moreover, the influence of nutrients such as copper, nitrogen and phosphorus, and the process operating conditions such as temperature, pH and moisture content of the biofilter bed, are also presented. Finally, the performance of various filter beds, in terms of their elimination capacities, is presented for laboratory scale biofilters and landfill covers.

No abstract

Plastic usage increases year by year, and the growing trend is projected to continue. However as of 2017, only 9% of the 9 billion tons of plastic ever produced had been recycled leaving large amounts of plastics to contaminate the environment, resulting in important negative health and economic impacts. Curbing this trend is a major challenge that requires urgent and multifaceted action. Based on scientific and gray literature mainly published during the last 10 years, this review summarizes key solutions currently in use globally that have the potential to address at scale the plastic and microplastic contaminations from source to sea. They include technologies to control plastics in solid wastes (i.e. mechanical and chemical plastic recycling or incineration), in-stream (i.e. booms and clean-up boats, trash racks, and sea bins), and microplastics (i.e. stormwater, municipal wastewater and drinking water treatment), as well as general policy measures (i.e. measures to support the informal sector, bans, enforcement of levies, voluntary measures, extended producer responsibility, measures to enhance recycling and guidelines, standards and protocols to guide activities and interventions) to reduce use, reuse, and recycle plastics and microplastics in support of the technological options. The review discusses the effectiveness, capital expenditure, and operation and maintenance costs of the different technologies, the cost of implementation of policy measures, and the suitability of each solution under various conditions. This guidance is expected to help policymakers and practitioners address, in a sustainable and cost-efficient way, the plastic and microplastic management problem using technologies and policy instruments suitable in their local context. Supplementary Information The online version contains supplementary material available at 10.1007/s11356-021-18038-5.

Externally Peer Reviewe

This paper describes a study that was aimed at optimizing the pelletization of fecal sludge-based fertilizers for agricultural use. The process developed is easy to implement and increases the marketability of the products while also addressing a serious health and environmental challenge. The study took place during the period 2011-2012 in Ghana. The fecal sludge, rich in nutrients and organic matter, was dried and used to produce five different fertilizers (i.e., four formulations of compost and one with gamma irradiated material). Each material was then pelletized using locally constructed machinery. Key operating parameters, such as moisture content (10-55% in mass), binder type (clay or starch) and concentration (0-10% in mass), were varied and their impacts on the characteristics of pellets (e.g., amount of fine materials generated, length distribution or stability of pellets, and pellet disintegration rate) were also followed. Given the low analyzing capabilities of developing countries, some simple analytical methods were developed and used to compare pellets produced under different conditions. The results confirmed that the addition of 3% of pregelatinized starch is recommended during pelletization of fecal sludge-based fertilizers. Applicable moisture contents were also identified per fertilizer type, and were found to comprise between 21 and 43%.