No abstract

Most hydrogenase enzymes have organometallic active sites with CO and CN− as ligands and metal–metal bonds. Recent evidence points to a novel 2‐aza‐1,3‐propanedithiolate cofactor that directly participates in the heterolytic processing of dihydrogen. A close analogue of this cofactor and its organometallic subunit has been synthesized (see picture); spectroscopic, structural, and theoretical analysis of this model provides detailed insights into the properties of the proposed enzyme active site.

A series of models for the active site (H-cluster) of the iron-only hydrogenase enzymes (Fe-only H2-ases) were prepared. Treatment of MeCN solutions of Fe2(SR)2(CO)6 with 2 equiv of Et4NCN gave [Fe2(SR)2(CN)2(CO)4](2-) compounds. IR spectra of the dicyanides feature four nu(CO) bands between 1965 and 1870 cm(-1) and two nu(CN) bands at 2077 and 2033 cm(-1). For alkyl derivatives, both diequatorial and axial-equatorial isomers were observed by NMR analysis. Also prepared were a series of dithiolate derivatives (Et4N)2[Fe2(SR)2(CN)2(CO)4], where (SR)2 = S(CH2)2S, S(CH2)3S. Reaction of Et4NCN with Fe2(S-t-Bu)2(CO)6 gave initially [Fe2(S-t-Bu)2(CN)2(CO)4](2-), which comproportionated to give [Fe2(S-t-Bu)2(CN)(CO)5](-). The mechanism of the CN(-)-for-CO substitution was probed as follows: (i) excess CN(-) with a 1:1 mixture of Fe2(SMe)2(CO)6 and Fe2(SC6H4Me)2(CO)6 gave no mixed thiolates, (ii) treatment of Fe2(S2C3H6)(CO)6 with Me3NO followed by Et4NCN gave (Et4N)[Fe2(S2C3H6)(CN)(CO)5], which is a well-behaved salt, (iii) treatment of Fe2(S2C3H6)(CO)6 with Et4NCN in the presence of excess PMe3 gave (Et4N)[Fe2(S2C3H6)(CN)(CO)4(PMe3)] much more rapidly than the reaction of PMe3 with (Et4N)[Fe2(S2C3H6)(CN)(CO)5], and (iv) a competition experiment showed that Et4NCN reacts with Fe2(S2C3H6)(CO)6 more rapidly than with (Et4N)[Fe2(S2C3H6)(CN)(CO)5]. Salts of [Fe2(SR)2(CN)2(CO)4](2-) (for (SR)2 = (SMe)2 and S2C2H4) and the monocyanides [Fe2(S2C3H6)(CN)(CO)5](-) and [Fe2(S-t-Bu)2(CN)(CO)5](-) were characterized crystallographically; in each case, the Fe-CO distances were approximately 10% shorter than the Fe-CN distances. The oxidation potentials for Fe2(S2C3H6)(CO)4L2 become milder for L = CO, followed by MeNC, PMe3, and CN(-); the range is approximately 1.3 V. In water,oxidation of [Fe2(S2C3H6)(CN)2(CO)4](2-) occurs irreversibly at -0.12 V (Ag/AgCl) and is coupled to a second oxidation.

The anion [Fe(2)(S(2)C(3)H(6))(CN)(CO)(4)(PMe(3))](-) (2(-)) is protonated by sulfuric or toluenesulfonic acid to give HFe(2)(S(2)C(3)H(6))(CN)(CO)(4)(PMe(3)) (2H), the structure of which has the hydride bridging the Fe atoms with the PMe(3) and CN(-) trans to the same sulfur atom. (1)H, (13)C, and (31)P NMR spectroscopy revealed that HFe(2)(S(2)C(3)H(6))(CN)(CO)(4)(PMe(3)) is stereochemically rigid on the NMR time scale with four inequivalent carbonyl ligands. Treatment of 2(-) with (Me(3)O)BF(4) gave Fe(2)(S(2)C(3)H(6))(CNMe)(CO)(4)(PMe(3)) (2Me). The Et(4)NCN-induced reaction of Fe(2)(S(2)C(3)H(6))(CO)(6) with P(OMe)(3) gave [Fe(2)(S(2)C(3)H(6))(CN)(CO)(4)[P(OMe)(3)]](-) (4). Spectroscopic and electrochemical measurements indicate that 2H can be further protonated at nitrogen to give [HFe(2)(S(2)C(3)H(6))(CNH)(CO)(4)(PMe(3))](+) (2H(2)(+)). Electrochemical and analytical data show that reduction of 2H(2)(+) gives H(2) and 2(-). Parallel electrochemical studies on [HFe(2)(S(2)C(3)H(6))(CO)(4)(PMe(3))(2)](+) (3H(+)) in acidic solutions led also to catalytic proton reduction. The 3H(+)/3H couple is reversible, whereas the 2H(2)(+)/2H(2) couple is not, because of the efficiency of the latter as a proton reduction catalyst. Proton reduction is proposed to involve protonation of reduced diiron hydrides. DFT calculations establish that the regiochemistry of protonation is subtly dependent on the coligands but is more favorable to occur at the Fe-Fe bond for [Fe(2)(S(2)C(3)H(6))(CN)(CO)(4)(PMe(3))](-) than for [Fe(2)(S(2)C(3)H(6))(CN)(CO)(4)(PH(3))](-) or [Fe(2)(S(2)C(3)H(6))(CN)(CO)(4)[P(OMe)(3)]](-). The Fe(2)H unit stabilizes the conformer with eclipsed CN and PMe(3) because of an attractive electrostatic interaction between these ligands.