Super-resolution imaging has been advantageous in studying biological and chemical systems, but the required equipment and platforms are expensive and unable to observe single-molecules at the high (μM) fluorophore concentrations required to study protein interaction and enzymatic activity. Here, a plasmonic platform was designed that utilized an inexpensively fabricated plasmonic grating in combination with a scalable glancing angle deposition (GLAD) technique using physical vapor deposition. The GLAD creates an abundance of plasmonic nano-protrusion probes that combine the surface plasmon resonance (SPR) from the periodic gratings with the localized SPR of these nano-protrusions. The resulting platform enables simultaneous imaging of a large area without point-by-point scanning or bulk averaging for the detection of single Cyanine-5 molecules in dye concentrations ranging from 50 pM to 10 μM using epifluorescence microscopy. Combining the near-field plasmonic nano-protrusion probes and super-resolution technique using localization microscopy, we demonstrate the ability to resolve grain sizes down to 65 nm. This plasmonic GLAD grating is a cost-effective super-resolution imaging substrate with potential applications in high-speed biomedical imaging over a wide range of fluorescent concentrations.

Here we describe a method to fabricate a multi-channel high-throughput microchip device for measurement of quantal transmitter release from individual cells. Instead of bringing carbon-fiber electrodes to cells, the device uses a surface chemistry approach to bring cells to an array of electrochemical microelectrodes. The microelectrodes are small and “cytophilic” in order to promote adhesion of a single cell whereas all other areas of the chip are covered with a thin “cytophobic” film to block cell attachement and facilitate movement of cells to electrodes. This cytophobic film also insulates unused areas of the conductive film, thus the alignment of cell docking sites to working electrodes is automatic. Amperometric spikes resulting from single-granule fusion events were recorded on the device and had amplitudes and kinetics similar to those measured using carbon-fiber microelectrodes. Use of this device will increase the pace of basic neuroscience research and may also find applications in drug discovery or validation.

Ionic liquids (ILs) are being widely investigated as advanced electrolytes within electric double-layer capacitors (EDLCs) due to their inherent ionic conductivity, wide electrochemical windows, essentially zero volatility, and high temperature stability. Despite being composed entirely of ions, the ionic conductivity of a typical IL is significantly hindered by its high viscosity, rendering it akin to normal electrolytes. In this light, in order to increase the applicability of IL electrolytes, it is of the utmost priority to discover approaches for improving the electrochemical properties of ILs without adversely affecting their other beneficial attributes. In this work, we make important strides toward this goal by employing low energy sputtering to generate novel electrolytes comprising gold nanoparticle dispersions within the prototypical IL 1-ethyl-3-methylimidazolium ethyl sulfate, [emim][EtSO 4 ]. This study also afforded the unique opportunity to investigate nanoscale growth mechanisms occurring within the IL. Cyclic voltammetry and electrochemical impedance spectroscopy analyses revealed that when the IL contained a substantial fraction of sub-nanometer-sized particles, the double-layer capacitance was increased by $190%, concomitant with a bulk electrolyte resistance decrease of $70% with respect to a gold-free control. An exponential rise in resistance accompanied by a proportional decrease in capacitance accompanies nanoparticle growth until a critical size is reached-typically within 10 h at room temperature-beyond which the final capacitance is typically $60% higher than the control with an electrolyte resistance similar to the control. Overall, our results reveal an anomalous capacitance increase and low internal resistance for nanoparticle-in-IL dispersions, suggesting intriguing potential as electrolytes for next-generation EDLCs, fuel cells, and sensors.

No abstract

A novel platform for super-resolution imaging has been devised that employs plasmonic gratings fabricated using glancing angle deposition (GLAD) of silver. GLAD was found to produce a large population of unique nanostructures over the entire plasmonic grating. These nanostructures excite nearby fluorescent molecules to improve spatial resolution to sub-diffraction limit distances while also increasing signal-to-noise ratio (SNR). For example, the improved localization precision produces 65 nm image resolution on a highly concentrated fluorescent sample. These inexpensive plasmonic GLAD gratings have potential to improve fluorescent intensity and resolution over a wide range of applications.

A template-free solvothermal method in mixed solvent system was employed to produce ZnO nanorods in powder and thin-film forms at temperatures as low as 90oC. A thin seed layer of...

Low hydrogen content silicon oxycarbonitride (SiOCN) thin films were grown by plasma-enhanced chemical vapor deposition exploiting hydrogen dilution with silane/methane/nitrous oxide or tetramethylsilane/nitrous oxide precursors. The effects of deposition temperature were compared by investigating the compositional, optical, mechanical, and electrical properties of films grown at 100 °C, 250 °C, and 400 °C at thicknesses ranging from 50 nm to 10 μm. The dielectric constant and high breakdown strength of the films remain relatively constant at between 4–5 and 6.8 ± 0.2 MV cm−1 to 9.1 ± 0.3 MV cm−1, respectively, despite the differences in deposition temperature. Other properties of the films include excellent transparency in the visible regime, high nanoindentation hardness (4 to 12 GPa), and relatively low measured stress on Si (−20 to −300 MPa). Overall, the results of this work show that these SiOCN films can be used in a wide variety of applications, including as a dielectric within high voltage capacitors, transparent abrasion-resistant coatings for plastic windows, coatings on flexible substrates, a metal diffusion barrier for low-k dielectrics and polymer films, or within various microelectronic fabrication steps or systems.

No abstract