No abstract

No abstract

No abstract

Bacterial cellulose (BC) synthesized by Gluconacetobacter sucrofermentans has a high degree of crystallinity, durability, great resistance, and biocompatibility. This study evaluates the effect that carbon and nitrogen sources, present in HS (Hestrin-Schramm) culture medium, have on BC from G. sucrofermentans CECT 7291 used to restore damaged documents. The initial pH of the medium and the temperature were set for all assays, which were conducted in static conditions. The cellulose layers were obtained at four time points. The growth media were characterized at each time point (pH and carbon source consumption). Cellulose layers were washed, pressed, dried, and characterized by determining their pH, dry weight, and optical and mechanical properties. The best combination of carbon and nitrogen sources proved to be fructose plus yeast extract-corn steep liquor, with or without ethanol, which provided a good balance between BC production and carbon source consumption, and generated a resistant and homogeneous cellulose layer.

The effect of the addition of two [4-butyltrimethylammonium]-xylan chloride polyelectrolytes (BTMAXs) on bacterial cellulose (BC) was evaluated. The first strategy was to add the polyelectrolytes to the culture medium together with a cell suspension of the bacterium. After one week of cultivation, the films were collected and purified. The second approach consisted of obtaining a purified and homogenized BC, to which the polyelectrolytes were added subsequently. The films were characterized in terms of tear and burst indexes, optical properties, surface free energy, static contact angle, Gurley porosity, SEM, X-ray diffraction and AFM. Although there are small differences in mechanical and optical properties between the nanocomposites and control films, the films obtained by BC synthesis in the presence of BTMAXs were remarkably less opaque, rougher, and had a much lower specular gloss. The surface free energy depends on the BTMAXs addition method. The crystallinity of the composites is lower than that of the control material, with a higher reduction of this parameter in the composites obtained by adding the BTMAXs to the culture medium. In view of these results, it can be concluded that BC–BTMAX composites are a promising new material, for example, for paper restoration.

A new method was developed to study how the oil and cyan pigments of cold-set ink are distributed in newspaper thickness. The methodology involved laboratory printing followed by delamination of the printed paper. The unprinted side, printed side, and resulting layers were analyzed using attenuated total reflection Fourier transform infrared spectroscopy (ATR FT-IR). Three commercial newspapers and black and cyan cold-set inks were chosen for the study. Attenuated total reflection Fourier transform infrared spectroscopy enabled the proportion of oil and cyan pigment on the printed surface and throughout the sheet thickness to be measured. Oil percentage was evaluated as the area increment of the region from 2800 cm(-1) to 3000 cm(-1) The relative amount of cyan pigment was determined as the area of the absorption band at 730 cm(-1) The ink oil was found mainly below half the paper thickness, whereas the pigment was detected at the layers closer to the printed surface, at a depth penetration of less than 15 µm (20% of thickness). Distribution of these two components in paper thickness depended on the type of cold-set ink, the amount of ink transferred, and the newspaper properties.

No abstract

No abstract