Lipases are the most widely used enzymes in biocatalysis, and the most utilized method for enzyme immobilization is using hydrophobic supports at low ionic strength. This method allows the one step immobilization, purification, stabilization, and hyperactivation of lipases, and that is the main cause of their popularity. This review focuses on these lipase immobilization supports. First, the advantages of these supports for lipase immobilization will be presented and the likeliest immobilization mechanism (interfacial activation on the support surface) will be revised. Then, its main shortcoming will be discussed: enzyme desorption under certain conditions (such as high temperature, presence of cosolvents or detergent molecules). Methods to overcome this problem include physical or chemical crosslinking of the immobilized enzyme molecules or using heterofunctional supports. Thus, supports containing hydrophobic acyl chain plus epoxy, glutaraldehyde, ionic, vinylsulfone or glyoxyl groups have been designed. This prevents enzyme desorption and improved enzyme stability, but it may have some limitations, that will be discussed and some additional solutions will be proposed (e.g., chemical amination of the enzyme to have a full covalent enzyme-support reaction). These immobilized lipases may be subject to unfolding and refolding strategies to reactivate inactivated enzymes. Finally, these biocatalysts have been used in new strategies for enzyme coimmobilization, where the most stable enzyme could be reutilized after desorption of the least stable one after its inactivation.

This review discusses the possible roles of polyethylenimine (PEI) in the design of improved immobilized biocatalysts from diverse perspectives.

No abstract

This paper shows the coimmobilization of β-galactosidase from Aspergillus oryzae (β-gal) and lipase B from Candida antarctica (CALB). The combi-biocatalyst was designed in a way that permits an optimal immobilization of CALB on octyl-agarose (OC) and the reuse of this enzyme after β-gal (an enzyme with lower stability and altogether not very stabilized by multipoint covalent attachment) inactivation, both of them serious problems in enzyme co-immobilization. With this aim, OC-CALB was coated with polyethylenimine (PEI) (this treatment did not affect the enzyme activity and even improved enzyme stability, mainly in organic medium). Then, β-gal was immobilized by ion exchange on the PEI coated support. We found that PEI can become weakly adsorbed on an OC support, but the adsorption of PEI to CALB was quite strong. The immobilized β-gal can be desorbed by incubation in 300 mM NaCl. Fresh β-gal could be adsorbed afterwards, and this could be repeated for several cycles, but the amount of PEI showed a small decrease that made reincubation of the OC-CALB-PEI composite in PEI preferable in order to retain the amount of polymer. CALB activity remained unaltered under all these treatments. The combi-catalyst was submitted to inactivation at 60 °C and pH 7, conditions where β-gal was rapidly inactivated while CALB maintained its activity unaltered. All β-gal activity could be removed by incubation in 300 mM NaCl, however, SDS analysis showed that part of the enzyme β-gal molecules remained immobilized on the OC-CALC-PEI composite, as the inactivated enzyme may become more strongly adsorbed on the ion exchanger. Full release of the β-gal after inactivation was achieved using 1 M NaCl and 40 °C, conditions where CALB remained fully stable. This way, the proposed protocol permitted the reuse of the most stable enzyme after inactivation of the least stable one. It is compatible with any immobilization protocol of the first enzyme that does not involve ion exchange as only reason for enzyme immobilization. © 2016 The Royal Society of Chemistry

No abstract

No abstract

No abstract

No abstract