No abstract

No abstract

This work deals with the design of a high sensitivity DNA sequence detector using a 50 MHz quartz crystal microbalance (QCM) electronic oscillator circuit. The oscillator circuitry is based on Miller topology, which is able to work in damping media. Calibration and experimental study of frequency noise are carried out, finding that the designed sensor has a resolution of 7.1 ng/cm2 in dynamic conditions (with circulation of liquid). Then the oscillator is proved as DNA biosensor. Results show that the system is able to detect the presence of complementary target DNAs in a solution with high selectivity and sensitivity. DNA target concentrations higher of 50 ng/mL can be detected.

The proliferation of new peptides and proteins requiring characterisation is a direct result of recent advances in genomics and proteomics, but protein aggregation is particular problem in the biotechnology industry, where aggregation is encountered throughout the lifetime of a therapeutic protein, including during refolding, purification, sterilization, shipping, and storage process. To ensure that it meets quality standards, the size, molecular weight and/or molecular weight distribution, and aggregate state must be accurately determined. Traditional analytical methods for determining molecular weight include size-exclusion chromatography (SEC), gel electrophoresis, analytical ultracentrifugation and time-of-flight mass spectrometry. These technologies are time-consuming (some take days), provide data based on relative standards, or cannot characterise very high molecular weight aggregates. Laser light-scattering (LS) detection coupled with SEC system have been used for over a decade to determine the size and molecular weight of bio-molecules such as proteins, peptides, polysaccharides, oligonucleotides, and antibodies, the method of choice being for molar mass determinations and the study of self-association and heterogeneous interaction under native, equilibrium conditions in solution. The purpose of the current review is to describe and discuss the capability of the SEC/LS system to determine absolute molecular weight of proteins and their complexes and the association state of the conjugate, either with itself or with protein receptor/ligands. For this, the "two or three detector" methods, each with its advantages and limitations, can be used to calculate the molecular weight of a simple protein or glycoprotein, and the stoichiometry of their complexes. Also, some alternative techniques for determining the molecular weight are discussed in this review. Applications of all these methodologies are described.

In battery applications, particularly in automobiles, submarines and remote communications, the state of charge (SoC) is needed in order to manage batteries efficiently. The most widely used physical parameter for this is electrolyte density. However, there is greater dependency between electrolyte viscosity and SoC than that seen for density and SoC. This paper presents a Quartz Crystal Microbalance (QCM) sensor for electrolyte density-viscosity product measurements in lead acid batteries. The sensor is calibrated in H2SO4 solutions in the battery electrolyte range to obtain sensitivity, noise and resolution. Also, real-time tests of charge and discharge are conducted placing the quartz crystal inside the battery. At the same time, the present theoretical “resolution limit” to measure the square root of the density-viscosity product false(ρηfalse) of a liquid medium or best resolution achievable with a QCM oscillator is determined. Findings show that the resolution limit only depends on the characteristics of the liquid to be studied and not on frequency. The QCM resolution limit for ρη measurements worsens when the density-viscosity product of the liquid is increased, but it cannot be improved by elevating the work frequency.