This paper introduces an assessment of the representation of shape parameter measurements on theoretical particles. The aim of the study was to establish a numerical method for estimating sphericity, roundness, and roughness on artificially designed particles and to evaluate their interdependence. The parameters studied included a fractal dimension (FD), solidity (So), Wadell's roundness (Rw), a perimeter-area normalized ratio (¥), and sphericity (S). The methods of the work included: (a) the design of theoretical particles with different shapes, (b) the definition of optimal analysis conditions for automated measurements, (c) the quantification of particle parameters by computer vision-based image processing, and (d) the evaluation of interdependence between the parameters. The study established the minimum sizes required for analysis of the particle shape. These varied depending on the method used (150 pixels or 50 pixels). Evaluating the relationships between the parameters showed that FD and So are independent of S. Nevertheless, Rw and ¥ are clearly dependent on S and, thus, must be numerically corrected to Rwc and ¥c. FD, So, Rwc, and ¥c were used to establish, mathematically, a new regularity parameter (RBC) that reflects the degree of roundness of a particle. The process was applied to a case study and the evaluation of all parameters corroborated previous petrographic characterizations. Minerals 2019, 9, 768 2 of 21 corners of the particle. Six categories of roundness for sediment grains have been established and, for each category, one grain of low and one of high sphericity was introduced [3,6-9]. The six categories are: Very angular, angular, subangular, sub-rounded, rounded, and well-rounded. Two-dimensional particle shape measurements are particularly applicable when individual particles cannot be extracted from the rock matrix (e.g., thin sections under an optical microscope). Microscopic images are two-dimensional. Therefore, they only show part of the shape of the three-dimensional particle. The assessed image is usually of particles lying on their most stable plane on a flat support, i.e., showing the largest projection area.Traditionally, roundness indices compare the outline of a 2D projection of the particle to a circle. The first comparison defines the roundness as the ratio ri/R, which was shown in [10] (where ri is the radius of the sharpest corner, and R is the radius of the smallest circumscribing sphere). On the other hand, [11] defined the roundness parameter based on the radius of the curvature of particle corners and the radius of the largest inscribed sphere.[6] and [7] used comparison charts with a class limit table for roundness. Some authors considered angularity to be the opposite of roundness, while others considered the degree of angularity [12] to be a combination of the angular relationship between the planes bounding a corner and the distance of the corner from the center of the particle. The overall particle form heavily influences the method. In addition, [12] presente...
The Lisbon metropolitan area (LMA, central-west of Portugal) has been severely affected by different geohazards (flooding episodes, landslides, subsidence, and earthquakes) that have generated considerable damage to properties and infrastructures, in the order of millions of euros per year. This study is focused on the analysis of subsidence, as related to urban and industrial activity. Utilizing the A-DInSAR dataset and applying active deformation areas (ADA) processing at the regional scale has allowed us to perform a detailed analysis of subsidence phenomena in the LMA. The dataset consisted of 48 ascending and 61 descending SAR IW-SLC images acquired by the Sentinel-1 A satellite between January 2018 and April 2020. The line-of-sight (LOS), mean deformation velocity (VLOS) maps (mm year−1), and deformation time series (mm) were obtained via the Geohazard Exploitation Platform service of the European Space Agency. The maximum VLOS detected, with ascending and descending datasets, were −38.0 and −32.2 mm year−1, respectively. ADA processing over the LMA allowed for 592 ascending and 560 descending ADAs to be extracted and delimited. From the VLOS measured in both trajectories, a vertical velocity with a maximum value of −32.4 mm year−1 was estimated. The analyzed subsidence was associated to four ascending and three descending ADAs and characterized by maximum VLOS of −25.5 and −25.2 mm year−1. The maximum vertical velocity associated with urban subsidence was −32.4 mm year−1. This subsidence is mainly linked to the compaction of the alluvial and anthropic deposits in the areas where urban and industrial sectors are located. The results of this work have allowed to: (1) detect and assess, from a quantitative point of view, the subsidence phenomena in populated and industrial areas of LMA; (2) establish the relationships between the subsidence phenomena and geological and hydrological characteristics.
<p>The Tazones Lighthouse landslide is an active mass movement affecting a stretch of the Cantabrian Coast (N Spain), characterized by the presence of almost vertical rocky cliffs developed on Jurassic rocks. The area is being monitored since 2018 when irreversible structural damages appeared in a building located in the surroundings of the lighthouse because of the fast evolution of the landslide.</p><p>&#160;</p><p>On June 2018, the first 24 topographic marks were installed by the COSINES Project researchers and 10 more were set up on December of that year, after the appearance of new cracks. Since then, monthly monitoring campaigns have been carried out by total station to gauge the displacement of the 34 mentioned marks and 4 additional control points. One of the control marks was lost, between January and February 2019, due to the fast evolution of the movement. Monitoring has been complemented by the elaboration of detailed digital terrain models through drone flights carried out in November 2018 and November 2019. In addition, precipitation data registered on the rainfall gauges of the surroundings have been collected.</p><p>&#160;</p><p>This contribution presents the recent fast evolution of the Tazones Lighthouse landslide, affecting an area about 70.000 m<sup>2</sup> and characterized by relevant horizontal and vertical displacements. Since the beginning of the 3D monitoring, the 50% of the marks have moved more than 1 meter and 34% of them have moved more than 2 meters, one of them exceeding 14 meters of displacement.</p><p>The detailed digital terrain models have allowed quantifying the volume of mobilized mass over a year from the main head of the movement, located 110 meters above sea level. Moreover, the comparison of these data with precipitation records has led to relate the evolution of the displacement with the rainfall, being able to establish a very good correlation between precipitation distribution and movement acceleration.</p>
<p>Ground displacements associated to landslides can be analysed by means of geological, geotechnical, topographic and remote sensing techniques. In this work different classical topographic techniques are combined with a satellite based remote sensing technique: Differential SAR Interferometry (DInSAR). The topographic techniques provide precise measurements on a set of points strategically located for each landslide. The DInSAR technique provides a more opportunistic set of points, usually denser than topographic techniques, providing key information on the area of influence of the movement and its potential impact on the surroundings. The combination of both approaches provides a complementary set of measurements useful to properly understand the landslide mechanics. The area of study is Tazones Lighthouse sector (43&#186; 32&#8217; 54&#8217;&#8217;N, 5&#186; 23&#8217; 57&#8217;&#8217;W), located on a coastal cliff in north Asturias (N Spain), where there is an important active mass movement.</p><p>The used procedure consisted in the following steps: a) Processing of Envisat ASAR satellite data from 2002 to 2012 to obtain the deformation velocity map of the zone of interest thorough the ESA G-POD service (European Space Agency Grid Processing On Demand); b) Processing of the period 2014-2019 with Sentinel-1 data to obtain the Deformation time series and the deformation velocity map with the PSIG software (developed by the Geomatics Division of the CTTC); c) Integration, combination and comparison by a Geographical Information System (GIS) of the satellite results with topographic data obtained from 2018 to 2019 by means of standard techniques (theodolite, feno survey markers and control points); d) Analysis and interpretation of the results taken into account geological-geomorphological data available.</p><p>The results of this study show different velocity ratios in the Area of Interest (AoI), from mm/year to m/year, which are consistent with the ground measurements. Therefore, the work demonstrated the potentials of combining different geodetic techniques to infer information about landslides processes and the usefulness of the DInSAR for the control of the mass movement, whose fast evolution makes it difficult the topographic work due to the changes in the relief and the loss of several feno survey markers.</p>
Abstract. The Tazones Lighthouse slope shows different active mass movements affecting an area of 70.000 m2 of the Cantabrian Coast (N Spain), characterized by almost vertical rocky cliffs developed on Jurassic rocks: alternating marl, sandstone and limestone with three main stratigraphic and structural discontinuity families. Between June 2018 and May 2020, 22 monthly monitoring campaigns have been carried out to measure the displacement of 38 control points, located between 95–110 masl. The total station monitoring has been complemented by ortophoto analysis and detailed digital terrain models (DTM) from two drone flights. Since the beginning of the 3D monitoring, about the 50 % of the markers moved more than 1 m, one of them exceeding 15 m. Detailed DTM has shown that the increased activity is controlled by the discontinuities. There is an extraordinary correlation between displacement acceleration and precipitation and soil moisture: the largest displacements have occurred after 2 periods of intense rain (January and October–November 2019, with a maximum 24-hour precipitation of 64.5 mm and 82.1 mm, respectively, and soil moisture values higher than 90 %). This represents an exceptional opportunity to analyse in real time the Jurassic cliffs retreat of the Cantabrian Coast, a question that remained not quantified.
Gravitational processes on inaccessible cliffs, especially in coastal areas, are difficult to study in detail with only in situ techniques. This difficulty can be overcome by the complementary application of remote sensing methods. This work focuses on an active complex landslide affecting the slope of the Tazones Lighthouse (Cantabrian coast, North Iberian Peninsula), which has been monitored since June 2018. The aim of this research is to establish a conceptual model of the internal structure of the slope. A remote multitechnique approach was applied, including landscape deformation analysis from photogrammetric surveys, ground motion detection applying A-DInSAR techniques and Sentinel-1 satellite data, and electrical resistivity tomography. The obtained results showed the great potential of some of the remote techniques, such as UAV photogrammetry and electrical tomography, and the ineffectiveness of others, such as A-DInSAR, which failed to provide adequate results due to the profuse vegetation. This work made it possible to establish a geological model of the functioning of the slope of the Tazones Lighthouse and to deduce the surface extent of the destabilized mass (70,750 m2), the rupture surface shape (stepped), its in-depth extent (10–50 m), the volume of materials involved (~3,550,000 m3) and the type of landslide (complex including a predominant translational slide). The combination of field and remote sensing data significantly increased the possibility of reaching a comprehensive geological interpretation of landslides on rocky coasts.
<p>Landslides are one of the most common and dangerous threats in the world that generate considerable damage and economic losses. The aim of this study is to analyse the suitability of using the ESA G-POD (European Space Agency Grid Processing On Demand) environment to detect landslide incidence.</p><p>This free service allows to gain Mean Deformation Maps (mm/year and cm/year) by means of P-SBAS (Parallel-Small Baseline Subset) method, which is a kind of A-DInSAR (Advanced-Differential SAR Interferometry) technique.</p><p>The study area is in the Northwest of Spain, where there are and have been some significant well-known active landslides. ENVISAT ASAR satellite data collected from 2003 to 2010, have been contrasted with the slope instabilities inventory of Asturias (BAPA: <em>Base de datos de Argayos del Principado de Asturias</em> - Principality of Asturias Landslide Database), from 2003 to 2010. Afterwards, a new check with instability data registered in BAPA dataset from 2010 to 2017 has been done.</p><p>A-DInSAR and BAPA data have been jointly integrated and examined in a GIS. The results obtained indicate that there is consistency between both types of data. In addition, this research has been useful to highlight the G-POD free service as a reliable, economic and adequate tool to analyse movements of terrain during time periods of several years in the North of Spain.</p>
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.