The use of cell-rich hydrogels for three-dimensional (3D) cell culture has shown great potential for a variety of biomedical applications. However, the fabrication of appropriate constructs has been challenging. In this study, we describe a 3D printing process for the preparation of a multilayered 3D construct containing human mesenchymal stromal cells with a hydrogel comprised of atelocollagen and supramolecular hyaluronic acid (HA). This construct showed outstanding regenerative ability for the reconstruction of an osteochondral tissue in the knee joints of rabbits. We found that the use of a mechanically stable, host-guest chemistry-based hydrogel was essential and allowed two different types of extracellular matrix (ECM) hydrogels to be easily printed and stacked into one multilayered construct without requiring the use of potentially harmful chemical reagents or physical stimuli for post-crosslinking. To the best of our knowledge, this is the first study to validate the potential of a 3D printed multilayered construct consisting of two different ECM materials (atelocollagen and HA) for heterogeneous tissue regeneration using an in vivo animal model. We believe that this 3D printing-based platform technology can be effectively exploited for regeneration of various heterogeneous tissues as well as osteochondral tissue.

PurposeRecent reports have highlighted the importance of an anatomic tunnel placement for anterior cruciate ligament (ACL) reconstruction. The purpose of this study was to compare the effect of different tunnel positions for single-bundle ACL reconstruction on knee biomechanics.MethodsSixteen fresh-frozen cadaver knees were used. In one group (n = 8), the following techniques were used for knee surgery: (1) anteromedial (AM) bundle reconstruction (AM–AM), (2) posterolateral (PL) bundle reconstruction (PL–PL) and (3) conventional vertical single-bundle reconstruction (PL-high AM). In the other group (n = 8), anatomic mid-position single-bundle reconstruction (MID–MID) was performed. A robotic/universal force-moment sensor system was used to test the knees. An anterior load of 89 N was applied for anterior tibial translation (ATT) at 0°, 15°, 30° and 60° of knee flexion. Subsequently, a combined rotatory load (5 Nm internal rotation and 7 Nm valgus moment) was applied at 0°, 15°, 30° and 45° of knee flexion. The ATT and in situ forces during the application of the external loads were measured.ResultsCompared with the intact ACL, all reconstructed knees had a higher ATT under anterior load at all flexion angles and a lower in situ force during the anterior load at 60° of knee flexion. In the case of combined rotatory loading, the highest ATT was achieved with PL-high AM; the in situ force was most closely restored with MIDMID, and the in situ force was the highest AM–AM at each knee flexion angle.ConclusionAmong the techniques, AM–AM afforded the highest in situ force and the least ATT.

No abstract

No abstract

A transection (root tear or complete radial tear) injury of the medial meniscus posterior horn is not rare in the oriental area and needs to be repaired to restore the hoop tension and to reduce the extruded meniscus, which leads to osteoarthritis of the knee. In cases with transection of the medial meniscus posterior horn, the meniscus can be repaired by a pull out suture technique. However, it is difficult to manipulate a suture hook and drill a tibial tunnel in the narrow medial joint space using the traditional anterior arthroscopic technique. This article describes a new pull out suture technique for transection of the medial meniscus posterior horn using a posterior trans-septal portal that provides a safe and wide field of vision. The handling of the suture hook and a guide may reduce the possibility of a chondral or meniscal injury.

No abstract

No abstract

No abstract