No abstract

A stripline gyromagnetic nonlinear transmission line (NLTL) was constructed out of yttrium iron garnet ferrite and tested at charge voltages of 35 kV-55 kV with bias fields ranging from 10 kA/m to 20 kA/m. Typically, high power gyromagnetic NLTLs are constructed in a coaxial geometry. While this approach has many advantages, including a uniform transverse electromagnetic (TEM) mode, simple interconnection between components, and the ability to use oil or pressurized gas as an insulator, the coaxial implementation suffers from complexity of construction, especially when using a solid insulator. By moving to a simpler transmission line geometry, NLTLs can be constructed more easily and arrayed on a single substrate. This work represents a first step in exploring the suitability of various transmission line structures, such as microstrips and coplanar waveguides. The resulting high power microwave (HPM) source operates in ultra high frequency (UHF) band with an average bandwidth of 40.1% and peak rf power from 2 MW to 12.7 MW.

Operation of repetitive high-power microwave (HPM) sources is predominantly limited by thermal properties of anode and cathode materials. This letter presents a reflex-triode virtual cathode oscillator (vircator) capable of operating at 500 Hz at current densities between 100-200 A/cm 2 for multiple burst durations of 1-2 s. Stable vircator operation under such a thermally punishing environment is facilitated by the use of a thin pyrolytic graphite anode. The results presented focus on two anode-cathode (A-K) gap spacings: 11 and 21 mm, which produce stable microwave radiation at 4.6 and 1.6 GHz, respectively. Characteristic voltage, current, and microwave waveforms in conjunction with short-time Fourier transforms, frequency spectrographs, and HPM power density data for 1000 and 500 pulses at 1.6 and 4.6 GHz, respectively, are presented.

The thermal behavior of several electrically conducting solids under high incident electron fluence in high vacuum was evaluated. At electron energies of up to ∼200 keV, the depth-dose relationship for electron penetration into the materials was considered, and the resulting energy deposition profile from the surface was revealed to extend to a maximum of ∼175 µm below the surface depending on the anode material. Black body radiation is considered as the major mechanism that balances the power deposited in the material on the timescales of interest. Comparing the radiated power density at the sublimation temperature for different materials, metallic/nonmetallic, revealed that pyrolytic graphite anodes may radiate over 20 times more power than metallic anodes before failure due to sublimation. In addition, transparent pyrolytic graphite anodes (with a thickness on the order of several tens of micrometer) potentially radiate up to 40 times that of metallic anodes, since heating by the electron beam is approximately uniform throughout the thickness of the material, thus radiation is emitted from both sides. Experimental results obtained from titanium and pyrolytic graphite anodes validate the thermal analysis.

No abstract