No abstract

In spite of several published studies we have an incomplete understanding of the ion-release mechanisms and characteristics of polymer-coated fertilizers (PCF). Here we extend current conceptual models describing release mechanisms and describe the critical effects of substrate moisture and temperature on macro-and micronutrient release of three PCF types: Polyon ® , Nutricote ® , and Osmocote ® . Nutrient release was quantified at weekly intervals for up to 300 d from 5°C to 40°C in water and chemically inert sand, substrates that allowed release quantification without confounding effects of ion sorption/desorption. At least two release-timeframe formulations of each PCF type were studied and all products had similar nutrient concentrations to allow isolation of the effect of coating technology. Contrary to several studies, our data and model indicate that there is no significant difference in nutrient-release rates in water and a moist, solid substrate. This means that release rates determined in water can be used to model bio-available nutrient concentrations in moist soil or soilless media where sorption/desorption properties alter concentrations after release. Across all PCF, the nutrients most affected by temperature were typically N, K, B, Cu, and Zn, while the least affected were P, Mg, and Fe. We also found consistent differences among the coating technologies. Osmocote fertilizers released faster than specified at both high and low temperatures. Nutricote had relatively steady release rates over time and a nonlinear response to temperature. Polyon released more slowly than specified but replicate samples were highly uniform.

These findings indicate that whole-plant respiration of rapidly growing plants has a small sensitivity to temperature, and that the sensitivity does not change among the species tested, even after 20 d of treatment. Finally, the results support respiration models that separate respiration into growth and maintenance components.

The productivity of lettuce in a combination of high light, high temperature, and elevated CO2 has not been commonly studied because rapid growth usually causes a calcium deficiency in meristems called tipburn, which greatly reduces quality and marketability. We eliminated tipburn by blowing air directly onto the meristem, which allowed us to increase the photosynthetic photon flux (PPF) to 1000 μmol·m-2·s-1 (57.6 mol·m-2·d-1); two to three times higher than normally used for lettuce. Eliminating tipburn doubled edible yield at the highest PPF level. In addition to high PPF, CO2 was elevated to 1200 μmol·m-2·mol-1, which increased the temperature optimum from 25 to 30 °C. The higher temperature increased leaf expansion rate, which improved radiation capture and more than doubled yield. Photosynthetic efficiency, measured as canopy quantum yield in a whole-plant gas exchange system, steadily increased up to the highest temperature of 32 °C in high CO2. The highest productivity was 19 g·m-2·d-1 of dry biomass (380 g·d-1 fresh mass) averaged over the 23 days the plants received light. Without the limitation of tipburn, the combination of high PPF, high temperature, and elevated CO2 resulted in a 4-fold increase in growth rate over productivity in conventional environments.

Copper (Cu) is an essential micronutrient for plants and is the a.i. in pesticides for some pathogens and algae. Elevated doses of Cu can cause toxicity in plants. While silicon (Si) is reported to alleviate the toxicity of some heavy metals, its role in reducing the symptoms induced by excess Cu is unclear. Therefore, the role of Si in plant response to Cu stress was investigated in arabidopsis [Arabidopsis thaliana (L.) Heyn.]. Based on plant symptoms (a reduction of leaf chlorosis as well as increased shoot and root biomass) and a reduction of phenylalanine ammonia lyase [PAL (EC 4.3.1.5), a stress-induced enzyme] activity in the shoot, Si was found to alleviate copper stress. Real-time reverse transcriptase-polymerase chain reaction analyses indicated that the RNA levels of two arabidopsis copper transporter genes, copper transporter 1 (COPT1) and heavy metal ATPase subunit 5 (HMA5) were induced by high levels of Cu, but were significantly decreased when Si levels were also elevated. Taken together, our findings indicate that Si addition can improve the resistance of arabidopsis to Cu stress, and this improvement operates on multiple levels, ranging from physiological changes to alterations of gene expression.

The widely used exponential distribution of nitrogen or protein through the canopy is generally inappropriate. The model derives the optimum distribution with characteristics that are consistent with observation, so overcoming limitations of using the exponential distribution. Although canopies may not always operate at an optimum, optimization analysis provides valuable insight into plant acclimation to environmental conditions. Protein distribution has implications for the prediction of carbon assimilation, plant quality and nitrogen demand.

No abstract

No abstract