Abstract. This paper describes the pre-operational analysis and forecasting system developed during MACC (Monitoring Atmospheric Composition and Climate) and continued in the MACC-II (Monitoring Atmospheric Composition and Climate: Interim Implementation) European projects to provide air quality services for the European continent. This system is based on seven state-of-the art models developed and run in Europe (CHIMERE, EMEP, EURAD-IM, LOTOS-EUROS, MATCH, MOCAGE and SILAM). These models are used to calculate multi-model ensemble products. The paper gives an overall picture of its status at the end of MACC-II (summer 2014) and analyses the performance of the multimodel ensemble. The MACC-II system provides daily 96 h forecasts with hourly outputs of 10 chemical species/aerosols (O 3 , NO 2 , SO 2 , CO, PM 10 , PM 2.5 , NO, NH 3 , total NMVOCs (non-methane volatile organic compounds) and PAN+PAN Published by Copernicus Publications on behalf of the European Geosciences Union. V. Marécal et al.:A regional air quality forecasting system over Europe precursors) over eight vertical levels from the surface to 5 km height. The hourly analysis at the surface is done a posteriori for the past day using a selection of representative air quality data from European monitoring stations.The performance of the system is assessed daily, weekly and every 3 months (seasonally) through statistical indicators calculated using the available representative air quality data from European monitoring stations. Results for a case study show the ability of the ensemble median to forecast regional ozone pollution events. The seasonal performances of the individual models and of the multi-model ensemble have been monitored since September 2009 for ozone, NO 2 and PM 10 . The statistical indicators for ozone in summer 2014 show that the ensemble median gives on average the best performances compared to the seven models. There is very little degradation of the scores with the forecast day but there is a marked diurnal cycle, similarly to the individual models, that can be related partly to the prescribed diurnal variations of anthropogenic emissions in the models. During summer 2014, the diurnal ozone maximum is underestimated by the ensemble median by about 4 µg m −3 on average. Locally, during the studied ozone episodes, the maxima from the ensemble median are often lower than observations by 30-50 µg m −3 . Overall, ozone scores are generally good with average values for the normalised indicators of 0.14 for the modified normalised mean bias and of 0.30 for the fractional gross error. Tests have also shown that the ensemble median is robust to reduction of ensemble size by one, that is, if predictions are unavailable from one model. Scores are also discussed for PM 10 for winter 2013-1014. There is an underestimation of most models leading the ensemble median to a mean bias of −4.5 µg m −3 . The ensemble median fractional gross error is larger for PM 10 (∼ 0.52) than for ozone and the correlation is lower (∼ 0.35 for PM 10 and ∼ 0.54 for ...

Abstract. This paper deals with recent improvements to the global chemical transport model of Météo-France MOCAGE (Modèle de Chimie Atmosphérique à Grande Echelle) that consists of updates to different aerosol parameterizations. MOCAGE only contains primary aerosol species: desert dust, sea salt, black carbon, organic carbon, and also volcanic ash in the case of large volcanic eruptions. We introduced important changes to the aerosol parameterization concerning emissions, wet deposition and sedimentation. For the emissions, size distribution and wind calculations are modified for desert dust aerosols, and a surface sea temperature dependant source function is introduced for sea salt aerosols. Wet deposition is modified toward a more physically realistic representation by introducing re-evaporation of falling rain and snowfall scavenging and by changing the in-cloud scavenging scheme along with calculations of precipitation cloud cover and rain properties. The sedimentation scheme update includes changes regarding the stability and viscosity calculations. Independent data from satellites (MODIS, SEVIRI), the ground (AERONET, EMEP), and a model inter-comparison project (AeroCom) are compared with MOCAGE simulations and show that the introduced changes brought a significant improvement on aerosol representation, properties and global distribution. Emitted quantities of desert dust and sea salt, as well their lifetimes, moved closer towards values of AeroCom estimates and the multimodel average. When comparing the model simulations with MODIS aerosol optical depth (AOD) observations over the oceans, the updated model configuration shows a decrease in the modified normalized mean bias (MNMB; from 0.42 to 0.10) and a better correlation (from 0.06 to 0.32) in terms of the geographical distribution and the temporal variability. The updates corrected a strong positive MNMB in the sea salt representation at high latitudes (from 0.65 to 0.16), and a negative MNMB in the desert dust representation in the African dust outflow region (from − 1.01 to −0.22). The updates in sedimentation produced a modest difference; the MNMB with MODIS data from 0.10 in the updated configuration went to 0.11 in the updated configuration only without the sedimentation updates. Yet, the updates in the emissions and the wet deposition made a stronger impact on the results; the MNMB was 0.27 and 0.21 in updated configurations only without emission, and only without wet deposition updates, respectively. Also, the lifetime, the extent, and the strength of the episodic aerosol events are better reproduced in the updated configuration. The wet deposition processes and the differences between the various configurations that were tested greatly influence the representation of the episodic events. However, wet deposition is not a continuous process; it has a local and episodic signature and its representation depends strongly on the precipitation regime in the model.

Abstract. In this study we develop a secondary inorganic aerosol (SIA) module for the MOCAGE chemistry transport model developed at CNRM. The aim is to have a module suitable for running at different model resolutions and for operational applications with reasonable computing times. Based on the ISORROPIA II thermodynamic equilibrium module, the new version of the model is presented and evaluated at both the global and regional scales.The results show high concentrations of secondary inorganic aerosols in the most polluted regions: Europe, Asia and the eastern part of North America. Asia shows higher sulfate concentrations than other regions thanks to emission reductions in Europe and North America.Using two simulations, one with and the other without secondary inorganic aerosol formation, the global model outputs are compared to previous studies, to MODIS AOD retrievals, and also to in situ measurements from the HTAP database. The model shows a better agreement with MODIS AOD retrievals in all geographical regions after introducing the new SIA scheme. It also provides a good statistical agreement with in situ measurements of secondary inorganic aerosol composition: sulfate, nitrate and ammonium. In addition, the simulation with SIA generally gives a better agreement with observations for secondary inorganic aerosol precursors (nitric acid, sulfur dioxide, ammonia), in particular with a reduction of the modified normalized mean bias (MNMB).At the regional scale, over Europe, the model simulation with SIA is compared to the in situ measurements from the EMEP database and shows a good agreement with secondary inorganic aerosol composition. The results at the regional scale are consistent with those obtained from the global simulations. The AIRBASE database was used to compare the model to regulated air quality pollutants: particulate matter, ozone and nitrogen dioxide concentrations. Introduction of the SIA in MOCAGE provides a reduction in the PM 2.5 MNMB of 0.44 on a yearly basis and up to 0.52 for the 3 spring months (March, April, May) when SIAs are at their maximum.