19

BackgroundAppropriate footwear for individuals with diabetes but no ulceration history could reduce the risk of first ulceration. However, individuals who deem themselves at low risk are unlikely to seek out bespoke footwear which is personalised. Therefore, our primary aim was to investigate whether group-optimised footwear designs, which could be prefabricated and delivered in a retail setting, could achieve appropriate pressure reduction, or whether footwear selection must be on a patient-by-patient basis. A second aim was to compare responses to footwear design between healthy participants and people with diabetes in order to understand the transferability of previous footwear research, performed in healthy populations.MethodsPlantar pressures were recorded from 102 individuals with diabetes, considered at low risk of ulceration. This cohort included 17 individuals with peripheral neuropathy. We also collected data from 66 healthy controls. Each participant walked in 8 rocker shoe designs (4 apex positions × 2 rocker angles). ANOVA analysis was then used to understand the effect of two design features and descriptive statistics used to identify the group-optimised design. Using 200 kPa as a target, this group-optimised design was then compared to the design identified as the best for each participant (using plantar pressure data).ResultsPeak plantar pressure increased significantly as apex position was moved distally and rocker angle reduced (p < 0.001). The group-optimised design incorporated an apex at 52% of shoe length, a 20° rocker angle and an apex angle of 95°. With this design 71–81% of peak pressures were below the 200 kPa threshold, both in the full cohort of individuals with diabetes and also in the neuropathic subgroup. Importantly, only small increases (<5%) in this proportion were observed when participants wore footwear which was individually selected. In terms of optimised footwear designs, healthy participants demonstrated the same response as participants with diabetes, despite having lower plantar pressures.ConclusionsThis is the first study demonstrating that a group-optimised, generic rocker shoe might perform almost as well as footwear selected on a patient by patient basis in a low risk patient group. This work provides a starting point for clinical evaluation of generic versus personalised pressure reducing footwear.

BackgroundCurved rocker shoes are designed with a contoured outsole which can be characteristics by three principle design features: rocker angle, apex angle and apex position. Although these shoes are routinely prescribed to reduce in-shoe pressure in patients with diabetes, there is only minimal scientific evidence to inform the choice of value for each of the three design features. Results from a previous study [1], suggested that a 95°apex angle may be the best compromise for offloading the different regions of the forefoot. The results of this study also suggested that higher rocker angle may lead to decrease pressure, however, this study did not quantify the precise effect of rocker angle and apex position in shoes with a 95°apex angle.

No abstract

No abstract