Movement of multiple segment limbs requires generation of appropriate joint torques which include terms arising from dynamic interactions among the moving segments as well as from such external forces as gravity. The interaction torques, arising from inertial, centripetal, and Coriolis forces, are not present for single joint movements. The significance of the individual interaction forces during reaching movements in a horizontal plane involving only the shoulder and elbow joints has been assessed for different movement paths and movement speeds. Trajectory formation strategies which simplify the dynamics computation are presented.

The inertial parameters of manipulator rigid-body loads and links have been automatically estimated as a result of gen eral movement. The Newton-Euler equations have been recast to relate linearly the measured joint forces or torques via acceleration-dependent coefficients to the inertial parame ters, which have then been estimated by least squares. Load estimation was implemented on a PUMA 600 robot equipped with an R TI FS-B wrist force-torque sensor and on the MIT Serial Link Direct Drive Arm equipped with a Barry Wright Company Astek wrist force-torque sensor. Good estimates were obtained for load mass and center of mass, and the forces and torques due to movement of the load could be pre dicted accurately. The load moments of inertia were more difficult to estimate. Link estimation was implemented on the MIT Serial Link Direct Drive Arm. A good match was ob tained between joint torques predicted from the estimated parameters and the joint torques estimated from motor cur rents. The match actually proved superior to predicted torques based on link inertial parameters derived by CAD modeling. Restrictions on the identifiability of link inertial parameters due to restricted sensing and movement near the base have been addressed. Implications of estimation accu racy for manipulator dynamics and control have been consid ered.

The objective of this study was to determine the extent to which subjects modulate their elbow joint mechanical properties during ongoing arm movement. Small pseudo-random force disturbances were applied to the wrist with an airjet actuator while subjects executed large (1 rad) elbow joint movements. Using a lumped parameter model of the muscle, tendon and proprioceptive feedback dynamics, a time-varying system identification technique was developed to analyze the phasic changes in the elbow joint's mechanical response. The mechanical properties were found to be time-varying, and well approximated by a quasi-linear second-order model. The stiffness of the arm was found to drop during movement. The arm was always underdamped, with the damping ratio changing during movement. Inertia estimates were constant and consistent with previous measurements. Overall, the moving arm was found to be very compliant, with a peak stiffness value less than the lowest value measured during posture, and a natural frequency of less than 3 Hz. Changing the speed of movement, or the load from gravity, changed the stiffness measured, but not in strict proportion to the change in net muscle torque.

No abstract

No abstract

No abstract

No abstract

No abstract