The morphology of the aggregates formed between DNA and poly(amido amine) (PAMAM) dendrimers depends on the dendrimer generation as previously reported in separate studies at high dendrimer/DNA charge ratios (>1). This has lead to substantial work on dendrimers as possible transfection agents. Inspired by these studies, we here present novel results from a coherent and systematic study using cryo-TEM, dynamic light scattering (DLS) and fluorescence spectroscopy to reveal how the size, composition and morphology of aggregates formed between DNA (4331 base pairs) and PAMAM dendrimers, are affected by dendrimer size and charge at low charge ratios (<1) in dilute solutions. At such conditions the process is cooperative and kinetically controlled and welldefined structured aggregates are formed for lower dendrimer generations. The smaller sized dendrimers (generation 1 and 2), which have a lower total charge per molecule, allow the formation of well-structured rods and toroids. In contrast, globular and less defined aggregates, which are less stable against precipitation, are formed with higher generation dendrimers. We were also able to directly visualise the cooperative nature of the condensation process as cryo-TEM and DLS show that dendrimer/DNA aggregates, containing condensed DNA, coexist with free extended DNA chains. In fact, the apparent hydrodynamic radii of the dendrimer/DNA aggregates, obtained using DLS, are found to be almost constant for charge ratios #1. The fluorescence study shows that the number of dendrimers bound per DNA chain decreases with the dendrimer generation but is independent of the charge ratio.

The aim of this work was to study intermolecular interactions in systems containing charged polyion (polyacrylate, PA(-)), charged surfactant (C(16)TA(+)) and nonionic surfactant (C(12)E(5) or C(12)E(8)). To achieve this we have created four different phase diagrams using two different so-called complex salts, C(16)TAPA(25) and C(16)TAPA(6000), both consisting of positively charged surfactant (C(16)TA(+)) with polyacrylate (PA(-)) as counterions (no simple salt). The difference between the salts is the length of the polyion (25 or 6000 monomers). Both are insoluble in water. The results revealed that decreasing polyion length and increasing the PEO chain length of the nonionic surfactant were important factors for increasing the solubility of the complex salt. We also found that the curvature effects are quite small at low water content when gradually exchanging C(12)E(8) for either one of the complex salts while there is a gradual change in curvature for the systems containing C(12)E(5). Another interesting observation was the possibility for relatively large amounts of complex salt to be incorporated into a V(1) (Ia3d, bicontinuous) phase in the C(12)E(8)-containing systems. This gives rise to several questions regarding arrangements and dynamics of the polyion in this phase. In the dilute regime several different liquid crystalline phases can coexist with a dilute liquid phase containing the nonionic surfactant.

Nanoparticles with an internal structure have been prepared by dispersing under dilute conditions poly(acrylic acid) with a polymerization degree n = 6000 (PAA6000) together with a cationic surfactant hexadecyltrimethylammonium hydroxide (C16TAOH) and the non-ionic surfactant penta(ethylene glycol) monododecyl ether (C12E5) in water. The nanoparticles are formed at different mixing ratios in the corresponding two-phase regions (liquid crystalline phase/dilute isotropic phase) of the C16TAPA6000 complex salt/C12E5/water ternary phase diagram. The particles consist of polyacrylate PA6000– polyions, C16TA+ surfactant ions, and C12E5. Their internal ordering was identified by small-angle X-ray scattering (SAXS) to be either bicontinuous cubic with the Ia3d crystallographic space group or normal hexagonal depending upon the amount of C12E5. The bicontinuous cubic phase, to our knowledge never observed before in polyelectrolyte–surfactant particle systems, was inferred by SAXS experiments. The data also showed that this structure is thermoresponsive in a reversible manner. The bicontinuous cubic space group transforms from Ia3d to Im3m as the temperature decreases from 25 to 15 °C. According to dynamic light scattering and electrophoretic mobility measurements, the particles have a well-defined size (apparent hydrodynamic radii RH in the range of 88–140 nm) and carry a positive net charge. The size of the nanoparticles is stable up to 1 month. The faceted nanoparticles are visualized by cryogenic transmission electron microscopy that also reveals their coexistence with thread-like C12E5 micelles.

Water-soluble aggregates based on two polyion-surfactant ion "complex salts", consisting of hexadecyltrimethylammonium (C16TA(+)) and polyacrylate (PA(-)) with either 25 or 6000 repeating units, with added nonionic surfactant octaethylene glycol monododecyl ether (C12E8) have been investigated. A previous phase study has shown that added C12E5 or C12E8 can solubilize complex salts in aqueous systems, and that increasing the poly(ethylene oxide) chain length of the nonionic surfactant and/or decreasing the polyion length favors dissolution. In this work we report on dynamic light scattering, NMR diffusometry, small-angle X-ray scattering, and isothermal titration calorimetry measurements performed to characterize the solubilized composite aggregates in dilute aqueous solution in terms of size and stoichiometry. It was found that mixed aggregates of polyacrylate, C16TA(+) ions, and C12E8, with almost constant stoichiometry, coexist with free micelles of C12E8 at all investigated mixing ratios. The length of the polyion only weakly affects the stoichiometry of the mixed aggregates while strongly affecting their size and water solubility.

Assemblies formed by a well-defined quality of DNA (4331 bp T7 DNA) and the small net-cationic protein lysozyme in dilute aqueous solutions have been characterized using cryo-transmission electron microscopy (cryo-TEM) and dynamic light scattering (DLS) as the main techniques. In a wide range of different DNA to lysozyme ratios in solutions of low ionic strength, dispersions of aggregates with the same general morphology and a practically constant hydrodynamic size are formed. The basic structure formed in the dispersions is that of rather flexible worm-like assemblies with a diameter of 10-20 nm, which are suggested to be made up by bundles of on the order of 10 DNA chains with an intervening matrix of lysozyme. With increased ionic strength, the worm-like appearance of the assemblies is lost and they adopt a less well-defined shape. The results suggest that the formation of the DNA-lysozyme aggregates is strongly influenced by cooperative assembly of the components and that, in addition to the electrostatic attraction between DNA and lysozyme, attractive interactions between the protein units are important in governing the behavior of the system.